Engineering topics

Hong, Xia

Publications and source records attributed to Hong, Xia.

8 records

DOE OSTI2023

Nanoscale Ferroelectric Control of Novel Electronic States in Layered Two-Dimensional Materials (Final Report)

In this DOE Early Career project “Nanoscale Ferroelectric Control of Novel Electronic States in Layered Two-Dimensional Materials,” the PI’s group has combined ferroelectric field effect with nanoscale domain imaging and writing to design the electronic and optical properties of two-dimensional (2D) van der Waals materials, including graphene and transition metal dichalcogenides MoS2 and ReS2. The van der Waals materials have been prepared into field effect transistor (FET) devices with ferroelectric gates. Through domain patterning in a ferroelectric polymer PVDF-TrEF top-gate via conductive atomic force microscopy, the team has created programmable Schottky junctions in monolayer MoS 2 , where both barrier height and I-V rectifying polarity can be reconfigured. The transport anisotropy of monolayer to few-layer ReS 2 has been mapped out by defining the entire channel into an insulating state and creating nanoscale conducting paths along different directions through domain writing in the ferroelectric top-gate. The result shows that the conductivity along and perpendicular to the Re-chain can differ by >5.5x10 4 . Theoretical modeling points to the band origin of the transport anomaly and reveals the emergence of a flat band in few-layer ReS 2 . The interfacial epitaxial relation between ReS 2 and PVDF-TrFE further promotes the formation of close-packed, highly ordered PVDF-TrFE nanowires with width of 35 nm and 10 nm. Nonvolatile modulation of quantum Hall effect has been achieved in graphene FETs with a ferroelectric oxide Ba 0.4 Sr 0.6 TiO 3 back-gate. Scattering from the remote surface optical phonon in Ba 0.4 Sr 0.6 TiO 3 limits the room temperature mobility of graphene to be about 3x10 4 cm 2 /Vs. Steep-slope switching has been achieved in MoS 2 FETs back-gated by polycrystalline Pb(Zr,Ti)O 3 , which signals a static-state negative capacitance mode without involving an additional dielectric layer. Piezoresponse force microscopy studies show that the sub-threshold swing can be well correlated with the domain wall density in Pb(Zr,Ti)O 3 . The team also observes an unconventional filtering effect of the second harmonic generation response at the MoS 2 /Pb(Zr,Ti)O 3 heterointerface, which can be accounted for by the alignment between one of the polar axes of MoS 2 and the chiral dipole rotation at the surface of domain wall in Pb(Zr,Ti)O 3 . The research supported by this DOE grant has significantly advanced the fundamental understanding and functional design of ferroelectric/2D van der Waals heterostructures for their implementation towards energy applications.

36 MATERIALS SCIENCE↗

DOE OSTI2022

Remote surface optical phonon scattering in ferroelectric Ba 0.6 Sr 0.4 TiO 3 gated graphene

We report the effect of remote surface optical (RSO) phonon scattering on carrier mobility in monolayer graphene gated by ferroelectric oxide. We fabricate monolayer graphene transistors back-gated by epitaxial (001) Ba 0.6 Sr 0.4 TiO 3 films, with field effect mobility up to 23 000 cm 2 V –1 s –1 achieved. Switching ferroelectric polarization induces nonvolatile modulation of resistance and quantum Hall effect in graphene at low temperatures. Ellipsometry spectroscopy studies reveal four pairs of optical phonon modes in Ba 0.6 Sr 0.4 TiO 3 , from which we extract RSO phonon frequencies. The temperature dependence of resistivity in graphene can be well accounted for by considering the scattering from the intrinsic longitudinal acoustic phonon and the RSO phonon, with the latter dominated by the mode at 35.8 meV. Furthermore, our study reveals the room temperature mobility limit of ferroelectric-gated graphene transistors imposed by RSO phonon scattering.

36 MATERIALS SCIENCE↗

DOE OSTI2021

Giant Transport Anisotropy in ReS 2 Revealed via Nanoscale Conducting-Path Control

The low in-plane symmetry in layered 1T'-ReS 2 results in strong band anisotropy, while its manifestation in the electronic properties is challenging to resolve due to the lack of effective approaches for controlling the local current path. In this work, we reveal the giant transport anisotropy in monolayer to four-layer ReS 2 by creating directional conducting paths via nanoscale ferroelectric control. By reversing the polarization of a ferroelectric polymer top layer, we induce conductivity switching ratio of >1.5×10 8 in the ReS 2 channel at 300 K. Characterizing the domain-defined conducting nanowires in an insulating background shows that the conductivity ratio between the directions along and perpendicular to the Re-chain can exceed 5.5×10 4 in monolayer ReS 2 . Theoretical modeling points to the band origin of the transport anomaly, and further reveals the emergence of a flat band in few-layer ReS 2 . Our work paves the path for implementing the highly anisotropic 2D materials for designing novel collective phenomena and electron lensing applications.

2D van der Waals materials↗

DOE OSTI2021

Effect of correlated oxide electrodes on disorder pinning and thermal roughening of ferroelectric domain walls in epitaxial PbZr 0.2 Ti 0.8 O 3 thin films

We report the competing effects of disorder pinning and thermal roughening on ferroelectric domain walls as a function of temperature in epitaxial PbZr 0.2 Ti 0.8 O 3 thin films deposited on (001) SrTiO 3 substrates buffered by three types of correlated oxide electrodes, La 0.67 Sr 0.33 MnO 3 , LaNiO 3 , and SrIrO 3 . Piezo-response force microscopy studies show that the 50 nm PbZr 0.2 Ti 0.8 O 3 films are uniformly polarized in the as-grown states, with the patterned domain structures persisting above 700 °C. For all three types of films, the domain wall roughness is dominated by 2D random bond disorder at room temperature, and transitions to 1D thermal roughening upon heating. The roughness exponent ζ increases progressively from 0.3 to 0.5 within a temperature window that depends on the bottom conducting oxide type, from which we extracted the distribution of disorder pinning energy. Lastly, we discuss the possible origins of the disorder pinning and the effect of the correlated oxide electrodes on the energy landscape of DW motion.

36 MATERIALS SCIENCE↗

DOE OSTI2021

Assembly of Close–Packed Ferroelectric Polymer Nanowires via Interface–Epitaxy with ReS 2

The flexible, transparent, and low-weight nature of ferroelectric polymers makes them promising for wearable electronic and optical applications. To reach the full potential of the polarization-enabled device functionalities, large-scale fabrication of polymer thin films with well-controlled polar directions is called for, which remains a central challenge. The widely exploited Langmuir–Blodgett, spin-coating, and electrospinning methods only yield polymorphous or polycrystalline films, where the net polarization is compromised. Here, an easily scalable approach is reported to achieve poly(vinylidene fluoride-trifluoroethylene) P(VDF-TrFE) thin films composed of close-packed crystalline nanowires via interface-epitaxy with 1T'-ReS 2 . Upon controlled thermal treatment, uniform P(VDF-TrFE) films restructure into about 10 and 35 nm-wide (010)-oriented nanowires that are crystallographically aligned with the underlying ReS 2 , as revealed by high-resolution transmission electron microscopy. Piezoresponse force microscopy studies confirm the out-of-plane polar axis of the nanowire films and reveal coercive voltages as low as 0.1 V. Reversing the polarization can induce a conductance switching ratio of >10 8 in bilayer ReS 2 , over six orders of magnitude higher than that achieved by an untreated polymer gate. Lastly, this study points to a cost-effective route to large-scale processing of high-performance ferroelectric polymer thin films for flexible energy-efficient nanoelectronics.

crystalline nanowires↗

DOE OSTI2020

Direct selective laser sintering of hexagonal barium titanate ceramics

Abstract A direct selective laser sintering (SLS) process was combined with a laser preheating procedure to decrease the temperature gradient and thermal stress, which was demonstrated as a promising approach for additive manufacturing of BaTiO 3 ceramics. The phase compositions in BaTiO 3 ceramics fabricated by SLS were investigated by X‐ray and neutron diffractions. The surface morphologies and cross‐section microstructures were characterized by scanning electron microscopy (SEM) and transmission electron microscopy (TEM). A dense hexagonal h‐BaTiO 3 layer was formed on the surface and extended to a depth of 500 μm, with a relative density higher than 97% and absence of pores or microcracks. SLS resulted in the formation of the high‐temperature phase, h‐BaTiO 3 , which was retained at room temperature possibly due to the high cooling rate. The grain boundaries of SLSed h‐BaTiO 3 ceramics consist of a Ti‐rich secondary phase. Compared with that of the pressureless sintered t‐BaTiO 3 ceramics, the Vickers hardness of SLSed h‐BaTiO 3 is 70% higher.

Zhang, Xiang↗

DOE OSTI2020

Empowering 2D nanoelectronics via ferroelectricity

Introducing ferroelectricity to two-dimensional (2D) van der Waals (vdW) materials such as graphene, transition metal dichalcogenides, and black phosphorous presents a promising route for developing high-speed and low-power nanoelectronics. This Perspective reviews two actively pursued materials strategies, ferroelectric/vdW heterostructures and vdW ferroelectric materials. Finally, the topics discussed include their application potential and performance limitations as memory, logic, sensing, and optical devices, as well as the challenges and outlook of the field.

2D materials↗

DOE OSTI2020

Spin Rectification and Electrically Controlled Spin Transport in Molecular-Ferroelectrics-Based Spin Valves

We report a spin-rectification effect in a spin-valve structure consisting of ferroelectric croconic acid (C 5 H 2 O 5 ) sandwiched between ferromagnetic electrodes La 0.7 Sr 0.3 MnO 3 and Co, which can be switched between a high-resistance (off ) and a low-resistance (on) state by a poling voltage. In the off state, the magnetoresistance (MR) sign reverses with the measurement voltage with a 0.1-V offset, suggesting a spin-rectification behavior, while in the on state the MR remains negative. These observations can be understood in terms of electrically controlled interfacial energy-band alignment either from the electrostatic effect or from the interfacial redox process. In conclusion, the observed spin-rectification effect suggests thepossibility of diodelike devices for spin-polarized current.

36 MATERIALS SCIENCE↗