Search NASA⌕ Search

Engineering topics

House, L.

Publications and source records attributed to House, L..

Coronal mass ejections observed during the solar maximum mission - Latitude distribution and rate of occurrence

Sixty-five coronal mass ejections have been identified in a systematic examination of white-light coronal images obtained between March and September 1980 by the coronagraph/polarimeter flown on the solar maximum mission spacecraft. These ejections were more uniformly distributed in position angle (or 'projected' solar latitude) than the similar events observed during the Skylab mission in 1973-1974; 27 percent of the solar maximum mission mass ejections were centered at positions more than 45 deg from the solar equator. The average rate of occurrence of the observed mass ejections for the entire solar maximum mission epoch, based on the assumption that one coronagraph image per spacecraft orbit is sufficient for detection, was 0.9 + or 0.15 per 24-hour day. Application of the same sampling assumption to the Skylab data set leads to a rate of 0.75 per 24-hour day and thus a change in this rate from the Skylab era (on the declining phase of sunspot cycle 20) to solar maximum mission (near the maximum of sunspot cycle 21) of only approximately 20 percent.

Hundhausen, A. J.↗

Type II bursts, shock waves, and coronal transients - The event of 1980 June 29, 0233 UT

The metric Type-II solar burst event of June 29, 1980, is characterized on the basis of spatially resolved radioheliograph observations obtained at Culgoora, Australia, and visible-light observations obtained with the coronograph/polarimeter of the SMM satellite. The data are presented in images, diagrams, and graphs and discussed in detail. The Type-II emission is found to arise in the dense moving material behind the transient loops, which have sky-plane width 0.5 solar radius and line-of-sight depth 0.1-0.4 solar radius. A faint arc observed moving ahead of the transient loops at about 900 km/sec and not associated with the Type-II burst is attributed to a shock front, and the compression ratio and Alfven Mach number of the enhanced-density region are estimated as n2/n1 = 1.3-3 and M(A) = 1.2-3. The ambient material at 3 solar radii is determined to have Alfven speed 250-625 km/sec and magnetic-field strength 50-120 mG. The total mass of the event is calculated as 700 Tg; the total magnetic energy of the loops is (1.5-15) x 10 to the 29th ergs.

Gary, D. E.↗

The association of radio noise storm enhancements with the appearance of additional material in the corona

Visible light observations of the corona have been combined with radioheliograph observations at metric wavelengths to examine the dynamic behavior of the corona during and after noise storm onsets and enhancements. For the period studied, the occurrence of such radio events is systematically associated with the addition of coronal material in the vicinity of the radio source. Some of the events correspond to mass ejection transients, but they more frequently represent merely a brightening, which grows in 1 hour or less with the coronal region and remains dense and stable for several hours.

Kerdraon, A.↗

An association between coronal structures and type III burst sources

Observations of the coronal structures overlying type III radio burst producing regions, obtained with the HAO Coronograph/Polarimeter on board the Solar Maximum Mission, have been combined with observations of the type III bursts from the Mark III Nancay Radioheliograph at 169 MHz. A first qualitative comparison of the data, performed for two periods, indicates that the corona overlying type III producing sites is composed of small, discrete, over-dense structures, which are sometimes diverging and short-lived. The type III burst sources are complex, exhibiting elementary components. It is suggested that the type III burst structure follows that of the corona and that discrete structures may play a fundamental role for type III production.

Trottet, G.↗

The High Altitude Observatory Coronagraph/Polarimeter on the Solar Maximum Mission

The paper examines the High Altitude Observatory Coronagraph/Polarimeter designed to produce images of the solar corona in 7 wavelength bands in the visible spectral range, and to be flown on the NASA Solar Maximum Mission satellite. The spectral bands were chosen to exclude or include 'chromospheric' spectral lines, so as to allow discrimination between ejecta at coronal and chromospheric temperatures. The major goals of the instrument include: (1) observation of the corona in the flare process and of the ejecta from the flare site and the overlying corona, and (2) examination of the evolution of the solar corona near the period of solar maximum activity.

Macqueen, R. M.↗