Engineering topics

Housner, J. M.

Publications and source records attributed to Housner, J. M..

27 records · Page 2

NASA NTRS1982

Semi-implicit transient analysis procedures for structural dynamics analysis

A semi-implicit direct time integration procedure is presented which avoids factorization of the implicit difference solution matrix. The procedure, if properly implemented, requires only vectorial calculations and hence needs the same computer core space as explicit integration procedures. Guidelines for splitting the stiffness matrix into upper and lower matrices are established, which among other things are designed to satisfy a correct transmission of rigid-body motions from element (or grid) to its adjacent elements.

Park, K. C.↗

NASA NTRS1982

On the dynamic collapse of a column impacting a rigid surface

Results are presented of an analytical investigation on the dynamic collapse of an elastic periodically supported column. The column has an attached mass at one end and impacts a rigid surface with prescribed velocity and angle of incidence at the other end. A first-order approximate nonlinear analysis is developed in which it is assumed that only first-order nonlinear terms need be retained. Differential equations are derived and solved numerically by explicit time integration in order to determine specific ranges of the basic nondimensional parameters for which the response characteristics are markedly different. To assess modeling sophistication relative to prediction accuracy, a comparison is made of the results from this approximate analysis with those of a finite element computer code based on a convected coordinate formulation.

Housner, J. M.↗

NASA NTRS1981

Nonlinear dynamic phenomena in the space shuttle thermal protection system

The development of an analysis for examining the nonlinear dynamic phenomena arising in the space shuttle orbiter tile/pad thermal protection system is presented. The tile/pad system consists of ceramic tiles bonded to the aluminum skin of the orbiter through a thin nylon felt pad. The pads are a soft nonlinear material which permits large strains and displays both hysteretic and nonlinear viscous damping. Application of the analysis to a square tile subjected to transverse sinusoidal motion of the orbiter skin is presented and the following nonlinear dynamic phenomena are considered: highly distorted wave forms, amplitude-dependent resonant frequencies which initially decrease and then increase with increasing amplitude of motion, magnification of substrate motion which is higher than would be expected in a similarly highly damped linear system, and classical parametric resonance instability.

Housner, J. M.↗

NASA NTRS1980

Nonlinear dynamic response of a uni-directional model for the tile/pad space shuttle thermal protection system

A unidirectional analysis of the nonlinear dynamic behavior of the space shuttle tile/pad thermal protection system is developed and examined for imposed sinusoidal and random motions of the shuttle skin and/or applied tile pressure. The analysis accounts for the highly nonlinear stiffening hysteresis and viscous behavior of the pad which joins the tile to the shuttle skin. Where available, experimental data are used to confirm the validity of the analysis. Both analytical and experimental studies reveal that the system resonant frequency is very high for low amplitude oscillations but decreases rapidly to a minimum value with increasing amplitude. Analytical studies indicate that with still higher amplitude the resonant frequency increases slowly. The nonlinear pad is also responsible for the analytically and experimentally observed distorted response wave shapes having high sharp peaks when the system is subject to sinusoidal loads. Furthermore, energy dissipation in the pad is studied analytically and it is found that the energy dissipated is sufficiently high to cause rapid decay of dynamic transients. Nevertheless, the sharp peaked nonlinear responses of the system lead to higher magnification factors than would be expected in such a highly damped linear system.

Housner, J. M.↗

NASA NTRS1980

Hydroelastic vibration analysis of partially liquid-filled shells using a series representation of the liquid

A series representation of the oscillatory behavior of incompressible nonviscous liquids contained in partially filled elastic tanks is presented. Each term is selected on the basis of hydroelastic vibrations in circular cylindrical tanks. Using a complementary energy principle, the superposition of terms is made to approximately satisfy the liquid-tank interface compatibility. This analysis is applied to the gravity sloshing and hydroelastic vibrations of liquids in hemispherical tanks and in a typical elastic aerospace propellant tank. With only a few series terms retained, the results correlate very well with existing analytical results, NASTRAN-generated analytical results, and experimental test results. Hence, although each term is based on a cylindrical tank geometry, the superposition can be successfully applied to noncylindrical tanks.

Housner, J. M.↗

NASA NTRS1980

Nonlinear static TPS analysis

A nonlinear analysis which includes the effect of mismatch and filler bar was developed to predict the strain isolator pad reuseable surface insulation through-the-thickness interface stresses. Parametric studies were conducted for simulated shock loading on square tiles. Expected loads on an actual tile were also studied. The results indicate that when no mismatch is present, linear solutions tend to give nonconservative maximum stresses relative to the nonlinear solutions. When mismatch is present, the linear maximum stresses are only conservative at low load levels and highly nonconservative at high load levels. Although the presence of filler bar reduces maximum tensile stresses in some cases, it does not appear that the nominal dimension filler bar can reduce the nonlinear stress to a level at which the linear solution becomes conservative relative to the nonlinear solution. Moreover, on an outboard trailing edge elevon tile at descent with +20 deg flap, the linear analysis is 49% nonconservative relative to the nonlinear analysis with filler bar.

Housner, J. M.↗

NASA NTRS1977

Vibrations of incompressible liquid-plastic tank combinations using a series representation of the liquid

A series representation is presented of the dynamic behavior of incompressible non-viscous liquids contained in partially filled elastic shells of revolution. Using a series in which each term satisfies exactly Laplace's equation, the liquid portion of the problem becomes an integral equation on the wetted wall of the shell. Physical insight required in selecting the terms of the series is such that selection may be readily programed on a computer. Liquid-shell vibration interaction is investigated by modifying an existing shell of revolution vibration program with the series expansion of the liquid pressure loading on the wetted shell wall. Application of the modified program is demonstrated on a hemispherical tank and a realistic scaled model of a launch vehicle tank having a more complex geometry. Comparison of the present analysis with a NASTRAN finite element analysis for a hemispherical tank, and comparison with test results for a launch vehicle tank shows excellent agreement and rapid convergence of the series representation of the liquid to the true solution.

Housner, J. M.↗

NASA NTRS1975

Numerical analysis and parametric studies of the buckling of composite orthotropic compression and shear panels

A computer program is presented which was developed for the combined compression and shear of stiffened variable thickness orthotropic composite panels on discrete springs: boundary conditions are general and include elastic boundary restraints. Buckling solutions are obtained by using a newly developed trigonometric finite difference procedure which improves the solution convergence rate over conventional finite difference methods. The classical general shear buckling results which exist only for simply supported panels over a limited range of orthotropic properties, were extended to the complete range of these properties for simply supported panels and, in addition, to the complete range of orthotropic properties for clamped panels. The program was also applied to parametric studies which examine the effect of filament orientation upon the buckling of graphite-epoxy panels. These studies included an examination of the filament orientations which yield maximum shear or compressive buckling strength for panels having all four edges simply supported or clamped over a wide range of aspect ratios. Panels with such orientations had higher buckling loads than comparable, equal weight, thin skinned aluminum panels. Also included among the parameter studies were examinations of combined axial compression and shear buckling and examinations of panels with rotational elastic edge restraints.

Housner, J. M.↗

NASA NTRS1974

Flutter analysis of swept-wing subsonic aircraft with parameter studies of composite wings

A computer program is presented for the flutter analysis, including the effects of rigid-body roll, pitch, and plunge of swept-wing subsonic aircraft with a flexible fuselage and engines mounted on flexible pylons. The program utilizes a direct flutter solution in which the flutter determinant is derived by using finite differences, and the root locus branches of the determinant are searched for the lowest flutter speed. In addition, a preprocessing subroutine is included which evaluates the variable bending and twisting stiffness properties of the wing by using a laminated, balanced ply, filamentary composite plate theory. The program has been substantiated by comparisons with existing flutter solutions. The program has been applied to parameter studies which examine the effect of filament orientation upon the flutter behavior of wings belonging to the following three classes: wings having different angles of sweep, wings having different mass ratios, and wings having variable skin thicknesses. These studies demonstrated that the program can perform a complete parameter study in one computer run. The program is designed to detect abrupt changes in the lowest flutter speed and mode shape as the parameters are varied.

Housner, J. M.↗