Engineering topics

Howard, R. M.

Publications and source records attributed to Howard, R. M..

4 records

NASA NTRS1986

Wing laminar boundary layer in the presence of a propeller slipstream

The effects of a propeller slipstream on the wing laminar boundary layer are being investigated. Hot-wire velocity sensor measurements have been performed in flight and in a wind tunnel. It is shown that the boundary layer cycles between a laminar state and a turbulent state at the propeller blade passage rate. The cyclic length of the turbulent state increases with decreasing laminar stability. Analyses of the time varying velocity profiles show the turbulent state to lie in a transition region between fully laminar and fully turbulent. The observed cyclic boundary layer has characteristics similar to relaminarizing flow and laminar flow with external turbulence.

Miley, S. J.↗

NASA NTRS1985

Propeller slipstream/wing boundary layer effects at low Reynolds numbers

The effects of propeller slipstream on the wing laminar boundary are being investigated. Hot-wire velocity sensor measurements have been performed in flight and in a wind tunnel. It is shown that the boundary layer cycles between a laminar state and a turbulent state at the propeller blade passage rate. The cyclic length of the turbulent state increases with decreasing laminar stability. Analyses of the time varying velocity profiles show the turbulent state to lie in a transition region between fully laminar and fully turbulent. The observed cyclic boundary layer has characteristics similar to relaminarizing flow and laminar flow with external turbulence.

Miley, S. J.↗

NASA NTRS1985

An investigation of the effects of the propeller slipstream of a laminar wing boundary layer

A research program is in progress to study the effects of the propeller slipstream on natural laminar flow. Flight and wind tunnel measurements of the wing boundary layer have been made using hot-film velocity sensor probes. The results show the boundary layer, at any given point, to alternate between laminar and turbulent states. This cyclic behavior is due to periodic external flow turbulence originating from the viscous wake of the propeller blades. Analytic studies show the cyclic laminar/turbulent boundary layer to result in a significantly lower wing section drag than a fully turbulent boundary layer. The application of natural laminar flow design philosophy yields drag reduction benefits in the slipstream affected regions of the airframe, as well as the unaffected regions.

Howard, R. M.↗

NASA NTRS1981

Simulated spaceflight effects on mating and pregnancy of rats

The mating of rats was studied to determine the effects of: simulated reentry stresses at known stages of pregnancy, and full flight simulation, consisting of sequential launch stresses, group housing, mating opportunity, diet, simulated reentry, and postreentry isolation of male and female rats. Uterine contents, adrenal mass and abdominal fat as a proportion of body mass, duration of pregnancy, and number and sex of offspring were studied. It is found that: (1) parturition following full flight simulation was delayed relative to that of controls; (2) litter size was reduced and resorptions increased compared with previous matings in the same group of animals; and (3) abdominal fat was highly elevated in animals that were fed the Soviet paste diet. It is suggested that the combined effects of diet, stress, spacecraft environment, and weightlessness decreased the probability of mating or of viable pregnancies in the Cosmos 1129 flight and control animals.

Sabelman, E. E.↗