Search NASA⌕ Search

Engineering topics

Hu, Leiming

Publications and source records attributed to Hu, Leiming.

6 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2026

Enabling Stable and Salt-Free Formic Acid Production via Reactive Interface Optimization in Forward-Bias Bipolar-Membrane CO2 Electrolyzers

Electrochemical conversion of CO2 to liquid products is limited by parasitic reactions that consume products and destabilize operation. Here, we show that salt-free formic acid synthesis in a forward-bias bipolar-membrane CO2 electrolyzer is governed by a coupled reaction-transport instability driven by parasitic anode formic acid oxidation. Operando mass spectrometry reveals that this process proceeds through CO-mediated poisoning, identifying catalyst tolerance to CO as a key descriptor of anode selectivity. Among the catalysts examined, PtRu/C preferentially promotes hydrogen oxidation over formic acid oxidation. Coupling this catalyst with transport-interface engineering improves product removal, enhances Faradaic and energy efficiency, and enables stable operation at 200 mA/cm2 for 190 h with a voltage decay of 0.64 mV/h. Techno-economic analysis indicates an 18% reduction in minimum selling price and highlights product concentration as the dominant cost lever. These results establish a general framework for suppressing product oxidation in liquid-product electrolyzers.

Hu, Leiming↗
DOE OSTI2024

The influence of electrode crack dimensions on the durability of polymer electrolyte membrane fuel cells

Electrode cracks in polymer electrolyte membrane fuel cells (PEMFCs) are correlated with early onset failures. Here, in this work we investigate the influence of cracked gas diffusion electrodes (GDEs) on the durability of the membrane electrode assembly (MEA) using a combined chemical-mechanical accelerated stress test (AST). Electrode crack dimensions were systematically tuned using ink formulations and material selection strategies. A parameter to describe the crack width areal density (Φ CW ) was used to quantify the degree of discontinuity in the electrode surfaces. Open circuit voltage (OCV) transient analyses were used to benchmark and characterize the failure mechanisms in the MEAs as a function of the Φ CW . While smaller electrode-level cracks, on the order of microns, yielded a 28 % decrease in operating lifetime, larger cracks that propagated from a discontinuous, microporous layer (MPL) coating, decreased the operating lifetime by 56 %. This work emphasizes the need for material processing strategies that consider defect tolerances to limit membrane failures in PEMFCs.

08 HYDROGEN↗
DOE OSTI2024

A Three–Dimensional Nanoscale View of Electrocatalyst Degradation in Hydrogen Fuel Cells

The loss of platinum (Pt) electrochemically active surface area (ECSA) is a critical degradation mode that often becomes a limiting factor for heavy-duty proton exchange membrane fuel cell vehicles. High surface area carbon supports have been shown to improve Pt dispersion and limit detrimental ionomer-electrocatalyst interactions due to their large interior pore volume. Here, in this work, using automated scanning transmission electron tomography, the degradation of nanoparticles located on the interior versus exterior surfaces of the carbon support is compared following a catalyst-specific accelerated stress test (AST) of 90,000 voltage cycles between 0.6 V to 0.95 V. The results reveal a notable increase in median particle size for both interior and exterior Pt catalyst particles, with a slightly higher increase in particle size distribution and loss of specific surface area for the particles located on the exterior carbon surface. The fraction of Pt nanoparticles that reside within the interior of the carbon support also increased following the AST test, accompanied by evidence of an increase in average carbon mesopore size. Here, the results shed light on the degradation mechanisms affecting electrochemical properties and the enhanced particle accessibility at lower relative humidity.

08 HYDROGEN↗