Search NASA⌕ Search

Engineering topics

Hu, S

Publications and source records attributed to Hu, S.

Preparation, characterization, and application of modified chitosan sorbents for elemental mercury removal

A series of raw, iodine (bromide) or/and sulfuric acid-modified chitosan sorbents were synthesized and comprehensively characterized by N{sub 2} isotherm adsorption/desorption method, TGA, FTIR, XRD, and XPS et al. Adsorption experiments of vapor-phase elemental mercury (Hg{sup 0}) were studied using the sorbents in a laboratory-scale fixed-bed reactor. The results revealed that porosities and specific surface areas of the sorbents decreased after modification. The sorbents operated stably at flue-gas temperature below 140{sup o}C. The chemical reactions of iodine and sulfate ion with the amide of chitosan occurred, and the I{sub 2} was found in the sorbents due to the presence of H{sub 2}SO{sub 4}. Fixed-bed adsorber tests showed that compared to raw chitosan, the bromide or iodine-modified chitosan could promote the efficiency of Hg{sub 0} capture more or less. Mercury removal efficiency could be significantly promoted when an appropriate content of H{sub 2}SO{sub 4} was added, and the iodine and H{sub 2}SO{sub 4} modified sorbents almost had a mercury removal efficiency of 100% for 3 h. The presence of moisture can increase the sorbent's capacity for mercury uptake due to the existence of active sites, such as sulfonate and amino group. The mercury breakthrough of modified chitosan sorbents decreased with increasing temperature. A reaction scheme that could explain the experimental results was presumed based on the characterizations and adsorption study.

01 COAL, LIGNITE, AND PEAT↗

Self-assembly of orthogonal three-axis sensors

Conventional planar microfabrication is widely utilized to construct sensors for the measurement of physical or chemical properties. However, in these devices, the information component measured is typically restricted to only one vectorial axis. Here, we describe a self-assembling strategy that can be utilized to construct three dimensional (3D) cubic devices that facilitate measurement along three axes. This 3D measurement is achieved by arranging sensing elements orthogonally; any sensing element that can be lithographically patterned can be utilized. The 3D arrangement of sensors allows for the measurement of angular and orientation parameters. As an example, we describe a three-axis cantilever based sensor and demonstrate measurement of an evaporated analyte using resonant frequency shifts of cantilevers in each of the x, y, and z axes.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Hypernuclear spectroscopy program at JLab Hall C

DOI: http://dx.doi.org/10.1016/j.nuclphysa.2008.01.029 Hypernuclear production by the (e,e?K+) reaction has unique advantages in hypernuclear spectroscopy of the S=?1 regime. The second-generation spectroscopy experiment on 12C, 7Li and 28Si targets has been recently carried out at JLab Hall C with a new experimental configuration (Tilt method) and also using a new high-resolution kaon spectrometer (HKS). The experiment is described and preliminary results are presented together with the empasis of significance of the (e,e?K+) reaction for ? hypernuclear spectroscopy and its future prospects.

Hashimoto, Osamu↗