Engineering topics
Hu, Zhihan
Publications and source records attributed to Hu, Zhihan.
Irradiation-induced shift in the thermodynamic stability of phases and the self-healing effect in transformative high entropy alloys
Here, this work investigated Fe 40 Mn 20 Cr 15 Co 20 Si 5 high entropy alloy (CS-HEA), which exhibits transformation induced plasticity (TRIP) from γ-fcc → ε-hcp, as a probable candidate for nuclear applications. CS-HEA is an extensively-explored, low stacking fault energy alloy with superior strength, ductility, fatigue resistance, and corrosion resistance. This study delved into the effect of irradiation on the shift in thermodynamic stability of the phases and thus radiation tolerance. The evolution of phases, lattice parameters, and transformation volume, V γ→ε , were evaluated from X-ray diffraction experiments along with the mechanical response from nanoindentation. The alloy exhibited a recently-proposed novel self-healing mechanism possible due to the TRIP effect to minimize irradiation damage by restraining the γ-fcc → ε-hcp transformation via thermal aid; this self-healing mechanism was confirmed by transmission electron microscopy. The results were corroborated by a negative change in V γ→ε and a low |V γ→ε |, which is an important criterion for recovery of parent γ-fcc phase. Thus, this alloy was deemed a good radiation-tolerant candidate for nuclear application.
Microstructural and compositional evolutions in $γ$-LiAlO 2 pellets during ion irradiation at an elevated temperature
This study reports on the microstructural, phasic and compositional evolutions of γ-LiAlO 2 during ion irradiation. Polycrystalline γ-LiAlO 2 pellets were irradiated sequentially with He + and D 2 + ions to the same combined fluences of up to 3 × 10 17 (He + +D + )/cm 2 at 773 K. The irradiated pellets were characterized using scanning transmission electron microscopy and atom probe tomography. Surface amorphization likely due to radiolysis and planar defects as a possible precursor for formation of precipitates are created at 5 × 10 16 (He + +D + )/cm 2 , followed by the formation of nano-sized precipitates and fractures at higher doses. Spinel-like precipitates of non-stoichiometric LiAl 5 O 8 and gas-filled cavities are observed to grow with increasing dose. Faceted precipitates and rounded cavities appear at 2 × 10 17 (He + +D + )/cm 2 . With further increasing ion fluence to 3 × 10 17 (He + +D + )/cm 2 , amorphization of the precipitates takes place and micron-sized fractures appear. Surface exfoliation could occur at an extremely high ion fluence. There are compositional changes in the γ-LiAlO 2 pellets during the microstructural evolution. In the precipitate and amorphized regions, Li concentrations decrease to ~7 and 3.7 at.% from 25 at.% in γ-LiAlO 2 , respectively. This study reveals a full-cycle microstructural evolution with corresponding compositional changes in γ-LiAlO 2 pellets during ion irradiation at 773 K. In conclusion, the data could help model, assess, and predict the material performance during neutron irradiation in reactors.
Phase patterning of metallic glasses through superfast quenching of ion irradiation-induced thermal spikes
Amorphous metallic glasses (MGs) convert to crystalline solids upon annealing at a high temperature. Such a phase change, however, does not occur with the local melting caused by damage cascades introduced by ion irradiation, although the resulting thermal spikes can reach temperatures > 1000 K. This is because the quenching rate of the local melting zone is several orders of magnitude higher than the critical cooling rate for MG formation. Thus the amorphous structure is sustained. This mechanism increases the highest temperature at which irradiated MG sustains amorphous phase. More interestingly, if an irradiated MG is pre-annealed to form a polycrystalline structure, ion irradiation can locally convert this crystalline phase to an amorphous phase if the grains are nanometers in size and comparable to the damage cascade volume size. Combining pre-annealing and site selective ion irradiation, patterned crystalline-amorphous heterogeneous structures have been fabricated. This finding opens new doors for various applications.
A quantitative method to determine the region not influenced by injected interstitial and surface effects during void swelling in ion-irradiated metals
We propose and demonstrate a microstructurally-based experimental method to quantitively determine the depth regions in self-ion-irradiated metals that are affected by the injected interstitial effect and various surface effects, focusing on the choice of safe analysis zones to minimize the impact of these phenomena. The goal is to define the depth ranges where extracted data can be confidently applied to ion-neutron correlations for reactor application. Since ion energies in the range of 1–5 MeV are most frequently employed by the radiation effects community, irradiations were conducted at four energies in this range, all proceeding at 475 °C. The experiment was conducted on relatively pure single crystal iron to focus only on physical phenomena, avoiding the influence of possibly confounding chemical or segregation processes. Care was also taken to minimize the influence of other physical factors such as crystalline orientation. It was shown that, at 475 °C, ion energies of ≤1 MeV were too shallow in penetration and did not yield a safe depth range, but irradiations at 2.5 MeV and above yielded useful safe zones with predicted swelling behavior becoming independent of ion energy. The surface-affected zone width was found to be roughly twice that of the void-denuded zone width and to be independent of accumulated displacement dose. The largest injected-interstitial effect arises from the injected interstitial depression of void nucleation and growth. The interstitial-affected region starts at about one half of the projected range and does not show any “spreading” of its influence in depth as the peak damage level increases from 50 to 100 dpa. This study provides some confidence that enhances the credibility of ion simulation when applied to prediction of void swelling in neutron environments.
Behavior and properties of helium cavities in ductile-phase-toughened tungsten irradiated with He + ions at an elevated temperature
Ductile-phase toughened tungsten (DPT W) composites have demonstrated a great potential for plasma-facing components in fusion power systems. These materials can retain the outstanding thermomechanical properties of W while significantly enhancing the fracture toughness. The DPT W composite in this study consists of W particles (88 wt.%) embedded in a ductile NiFeW (12 wt.%) solution matrix. Irradiation of the composite was performed with 90 keV He + ions to 1.0 × 10 17 He + /cm 2 at 973 K. The He cavities formed in both W and NiFeW phases are examined using convergent-beam scanning transmission electron microscopy (CB-STEM) at an atomic-level resolution. Full-range depth profiles of the He cavity diameters and number densities are analyzed. The results show that the average cavity diameter in NiFeW is ~2.7 times that in W, while the number density is an order of magnitude lower. A quantitative analysis of the He density and pressure in the cavities is also achieved using STEM electron energy loss spectroscopy (STEM-EELS) mapping. The He atoms in the cavities in NiFeW are found to be under-pressurized, while those in similar-sized cavities in W are not detectable. Further, the He energy-loss shift exhibits a linear relationship with the He density in cavities in NiFeW, with the slope comparable to that for martensitic steel.
Ion irradiation study of lithium silicates for fusion blanket applications
Here, this study reports on the microstructural and compositional evolutions, deuterium release and lithium loss behavior in lithium silicates. Pellets of biphasic Li 4 SiO 4 and Li 2 SiO 3 were fabricated using hot pressing of powders. Sequential irradiation with Si + , He + and D + ions was performed up to 773 K to emulate one-year 6 Li burnup in 6 Li 4 SiO 4 inside the SlimCS DEMO. Crystalline Li 4 SiO 4 phase was not observed in the irradiated depth region of all the samples in this study. In spite of full amorphization in the near-surface region, Li 2 SiO 3 irradiated to a high dose at 773 K remained crystalline in the damage peak region, suggesting that Li 2 SiO 3 is more irradiation resistant to amorphization than Li 4 SiO 4 . Radiolysis may be primarily responsible for silicate decomposition and amorphization. Data from this study also show that D release from the pellet is very efficient during ion irradiation at 773 K, which is accompanied with a significant Li loss. Thermal annealing for 10 min at 773 K for the room-temperature irradiated pellet leads to a nearly complete D release without an observable Li loss. A concept of Ni coating on tritium breeder materials is discussed with supporting data to minimize Li loss without a significant impact on tritium diffusion and release.
A method to predict texture effect on ion beam channeling analysis of polycrystals and the application to study the mosaic spreading effect in highly oriented pyrolytic graphite
We propose a method to convert the channeling Rutherford backscattering spectrum yield map of a single crystal to a polycrystal through a matrix rotation technique. The rotation matrix is determined by the deviation of the crystal axial direction from the original z axis. The final yield map is created after averaging the rotated yields using the texture function as the weight factor. For highly oriented pyrolytic graphite (HOPG) exhibiting mosaic spread, the method leads to a Gaussian kernel averaging of the map obtained from a single crystal. The yield map of a single crystal is obtained by a simulation of ion trajectories in a potential field described by Moliere screened Coulomb potentials. Yield maps are calculated under various σ values (standard deviations of mosaic spread). The simulated results are compared with experimental results obtained using 1.2 MeV alpha particle. σ is extracted through the best fitting, demonstrating that the method can be used to obtain texture details. The effects of mosaic spread on minimum yield χ min and the half-width at half maximum of angular scans ψ ½ are systematically modeled and compared with previous theoretical equations. The study also shows that previous theoretical equations are valid only at small σ values. The proposed method can be applied to any type of polycrystal and is not limited to HOPG. It provides near-surface mosaic spread and crystallography information with a longitudinal depth resolution of tens of nanometers and is not influenced by grain shapes.
Microstructural evolution and precipitation in γ-LiAlO 2 during ion irradiation
Polycrystalline γ-LiAlO 2 pellets were sequentially irradiated with 120 keV He + and 80 keV D 2 + ions to the fluences of 1 × 10 17 and 2 × 10 17 (He + + D + )/cm 2 at 573 K. Additional irradiation was performed to a fluence of 2 × 10 17 (He + + D + )/cm 2 at 773 K. The irradiated pellets were characterized using scanning transmission electron microscopy, time-of-flight secondary ion mass spectrometry, and grazing incidence x-ray diffraction. Lattice damage, amorphization, and fractures are observed with no evidence for the formation of secondary-phase precipitates in the pellets irradiated up to an ion fluence of 2 × 10 17 (He + + D + )/cm 2 at 573 K. In contrast, faceted precipitates with sizes larger than 100 nm formed in a pellet irradiated to 2 × 10 17 (He + + D + )/cm 2 at 773 K. Analyses of the diffraction and composition data suggest that the precipitates have a spinel-type structure, likely a non-stoichiometric LiAl 5 O 8 with Li depletion. This could be an intermediate phase with Li atoms at the octahedral and possibly tetrahedral sites as well. It is speculated that as the dose increases, Li loss will continue and the precipitates will approach a composition of alumina primarily in phases of α-Al 2 O 3 and amorphized Al 2 O 3 .
Effect of Stress on Irradiation Responses of Highly Oriented Pyrolytic Graphite
The effect of stress on irradiation responses of highly oriented pyrolytic graphite (HOPG) was studied by combing molecular dynamics (MD) simulation, proton irradiation, and Raman characterization. MD simulations of carbon knock-on at energies < 60 eV were used to obtain average threshold displacement energies (E¯d) as a function of strain ranging from 0 to 10%. Simulations at a higher irradiation energy of 2–5 keV were used to study the effect of strain on damage cascade evolution. With increasing tensile strain, E¯d was reduced from 35 eV at 0% strain to 31 eV at 10% strain. The strain-reduced E¯d led to a higher damage peak and more surviving defects (up to 1 ps). Furthermore, high strains induced local cleavage around the cavities, as one additional mechanism of damage enhancement. Experimentally, HOPG film was folded, and the folded region with the maximum tensile stress was irradiated by a 2 MeV proton beam. Raman characterization showed significantly enhanced D to G modes in comparison to the stress-free irradiation. Based on the strain dependence of E¯d and the Kinchin–Pease model, a formula for displacement estimation under different tensile strains is proposed. The stress effects need to be considered in graphite applications in a reactor’s harsh environment where both neutron damage and stress are present.
Behavior of helium cavities in ion-irradiated W-Ni-Fe ductile-phase toughened tungsten
This study reports on the distribution of helium (He) cavities in a hot-rolled W-Ni-Fe ductile-phase toughened tungsten (DPT W) composite irradiated to a dose and a helium concentration that are comparable to those in the material after 5-year irradiation in a conceptual fusion power plant. Here, the DPT W sample consists of W particles embedded in a ductile-phase NiFeW matrix with a nominal composition of 90W-7Ni-3Fe by weight. It was hot-rolled to a thickness reduction by 87% (87R DPT W). Sequential irradiation of the material with 1.2 MeV Ni + ions to a fluence of 2.15×10 16 Ni + /cm 2 and 90 keV He + ions to 6.5×10 15 He + /cm 2 was performed at 973 K. Larger He cavities with a lower number density are observed in NiFeW than W. Helium cavities are aggregated preferentially along the NiFeW/W interphase boundary. This behavior is not observed along the W/W grain boundary under the same irradiation conditions. A similar distribution of He cavities with comparable sizes is observed in 87R DPT W irradiated with He + ions only, suggesting that the He cavity distribution is not significantly affected by pre-irradiation of Ni + ions at 973 K. The data from this study does not provide any evidence for formation of visible voids or Ni precipitates in W phase irradiated with Ni + ions only. Diffusion and clustering of He atoms and mobile vacancies during ion irradiation at 973 K are responsible for the formation and growth of the He cavities.