Engineering topics

Huber, R. C.

Publications and source records attributed to Huber, R. C..

4 records

DOE OSTI2025

Effect of Crystallinity on Polymer Chain Compression in Polyethylene Dynamically Loaded with In-Situ X-Ray Diffraction

Abstract Polyethylene (PE) is a polymer widely used in commercial applications, where the properties of PE can be altered based on the molecular conformation. In this study, shock compression experiments with in-situ x-ray diffraction were conducted on two conformations of PE– low density polyethylene (LDPE) and ultra-high molecular weight polyethylene (UHMWPE). Encouragingly, X-ray diffraction patterns were easily observed in LDPE, which is only 25% crystalline. In agreement with a previous study on HDPE, LDPE exhibited a phase transition at 7.7 GPa. Lower pressure experiments on UHMWPE and LDPE exhibited polymer chain compression, but no occurrence of a phase transition.

36 MATERIALS SCIENCE↗

DOE OSTI2024

Detonation Soot: A New Class of Ice Nucleating Particle

Abstract Temperatures and pressures from high explosive detonations far exceed atmospheric conditions in typical combustion reactions, and consequently, detonation soot forms with physiochemical properties distinct from soot formed by combustion. In this study, samples of detonation soot from two high explosives, PBX 9502 and Composition B‐3, were analyzed. Ice nucleation experiments on soot collected after controlled detonations were conducted in the laboratory to probe immersion and contact mode freezing. Samples nucleated ice at temperatures warmer than commercially available nanodiamonds, which has a mean nucleation temperature of −20.7°C. Ice nucleation rate coefficients increase rapidly by two to three orders of magnitude below −20°C for every sample. Size‐selected 137 μm diameter particles produced during detonation in an ambient air atmosphere yield bimodal distributions of freezing temperature with primary and secondary nucleation modes centered at −20°C and −13°C, respectively. The presence of a secondary mode allows for enhanced ice nucleation rate coefficients (one to two orders of magnitude greater than samples without a secondary mode) at temperatures outside the influence of the primary mode (>−17°C). Given the observed onset nucleation temperatures of −9.2°C, our results imply that detonation soot of the type studied here would only need to reach an altitude of approximately 4 km to facilitate ice formation.

54 ENVIRONMENTAL SCIENCES↗

DOE OSTI2022

Diamond and methane formation from the chemical decomposition of polyethylene at high pressures and temperatures

Abstract Polyethylene (C 2 H 4 ) n was compressed to pressures between 10 and 30 GPa in a diamond anvil cell (DAC) and laser heated above 2500 K for approximately one second. This resulted in the chemical decomposition of the polymer into carbon and hydrocarbon reaction products. After quenching to ambient temperature, the decomposition products were measured in the DAC at pressures ranging from ambient to 29 GPa using a combination of x-ray diffraction (XRD) and small angle x-ray scattering (SAXS). XRD identified cubic diamond and methane as the predominant product species with their pressure–volume relationships exhibiting strong correlations to the diamond and methane equations of state. Length scales associated with the diamond products, obtained from SAXS measurements, indicate the formation of nanodiamonds with a radius of gyration between 12 and 35 nm consistent with 32–90 nm diameter spherical particles. These results are in good agreement with the predicted product composition under thermodynamic and chemical equilibrium.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2021

Carbon clusters formed from shocked benzene

Abstract Benzene (C 6 H 6 ), while stable under ambient conditions, can become chemically reactive at high pressures and temperatures, such as under shock loading conditions. Here, we report in situ x-ray diffraction and small angle x-ray scattering measurements of liquid benzene shocked to 55 GPa, capturing the morphology and crystalline structure of the shock-driven reaction products at nanosecond timescales. The shock-driven chemical reactions in benzene observed using coherent XFEL x-rays were a complex mixture of products composed of carbon and hydrocarbon allotropes. In contrast to the conventional description of diamond, methane and hydrogen formation, our present results indicate that benzene’s shock-driven reaction products consist of layered sheet-like hydrocarbon structures and nanosized carbon clusters with mixed sp 2 - sp 3 hybridized bonding. Implications of these findings range from guiding shock synthesis of novel compounds to the fundamentals of carbon transport in planetary physics.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗