Search NASA⌕ Search

Engineering topics

Hughes, Patrick

Publications and source records attributed to Hughes, Patrick.

11 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2019

GeoVision Analysis Supporting Task Force Report: Thermal Applications—Geothermal Heat Pumps

Geothermal heat pumps (GHPs), also referred to as ground-source heat pumps or Geo-exchange, have been proven capable of producing large reductions in energy use and associated carbon emissions for space conditioning and water heating in buildings. However, the current adoption rate of GHPs in the United States is still low, and GHPs receive little attention from either the public or policy makers. This report gives an overview of the status of GHP technology and its application in the United States, cost and performance of the state-of-the art GHP systems, barriers preventing wider adoption, and technologies under development that have potential to help overcome these barriers.

15 GEOTHERMAL ENERGY↗
DOE OSTI2017

Advanced control for ground source heat pump systems

Ground source heat pumps (GSHP), also known as geothermal heat pumps (GHP), are proven advanced HVAC systems that utilize clean and renewable geothermal energy, as well as the massive thermal storage capacity of the ground, to provide space conditioning and water heating for both residential and commercial buildings. GSHPs have higher energy efficiencies than conventional HVAC systems. It is estimated, if GSHPs achieve a 10% market share in the US, in each year, 0.6 Quad Btu primary energy consumption can be saved and 36 million tons carbon emissions can be avoided (Liu et al. 2017). However, the current market share of GSHPs is less than 1%. The foremost barrier preventing wider adoption of GSHPs is their high installation costs. To enable wider adoption of GSHPs, the costeffectiveness of GSHP applications must be improved.

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗
DOE OSTI2015

A comparative study of the status of GSHP applications in the United States and China

Ground source heat pump (GSHP) or geothermal heat pump technology was first developed and commercially introduced in the late 1970s, and GSHP units representing approximately 3.9 million tons of cooling had been installed in the United States by 2012. Applications of GSHP technology also have grown rapidly in China since it was introduced into China in the 1990s through collaboration between the Chinese and US governments. It is estimated that by 2013, about 400 million m2 (4.3 billion ft2) of building floor space in China was heated and/or cooled by GSHP systems. Moreover, governments in both China and the United States have programs that in some way support and/or promote the use of GSHP technology. After decades of practice, both countries have accumulated abundant experience in applying GSHP technology, but both also are confronted with various challenges to rapidly deploying this technology. Under the sponsorship of the US–China Clean Energy Research Center for Building Energy Efficiency, researchers reviewed and compared the current status of GSHP applications in the United States and China, including related policies, standards, technologies, equipment, costs, market development, and barriers. Finally, based on this comparative study, future collaborations between the two countries are recommended to improve the application of the GSHP technology and fully realize its energy saving potential.

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗
DOE OSTI2015

Condensing Furnace Venting Part 2: Evaluation of Same-Chimney Vent Systems for Condensing Furnaces and Natural Draft Water Heaters

In 1987, the National Appliance Energy Conservation Act prescribed the first federal minimum energy conservation standard for natural gas furnaces at an annual fuel utilization efficiency of 78%, effective January 1, 1992. One of the techno-economic issues that has prevented higher furnace efficiency standards since then is the lack of cost-effective, simple, and safe solutions that enable condensing furnaces and atmospheric combustion water heaters to vent through the same existing chimney. Part 1 of this two-part report series, published in October 2014, documents the issue, prospective solutions, and a test laboratory established to evaluate prospective venting solutions. This part 2 report documents the updated prospective solutions (because they have evolved since part 1 was written), the methodology for experimentally evaluating prospective solutions, and results of the evaluations.

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗