Engineering topics

Huston, Robert J.

Publications and source records attributed to Huston, Robert J..

3 records

NASA NTRS1996

History, a projection of the future: A rotary wing perspective

The success and failure of past vehicle concepts is reviewed in an attempt to highlight some of the advanced vehicle concepts attempted in the past failed because of a lack of appreciation, by both the sponsors and the developer, for the technical and societal requirements critical to their success. This paper will review the history of some attempts to provide both good hover and forward flight efficiency and will point out some of the technical and societal obstacles encountered. Two examples, that of the tiltrotor and tiltwing vehicles. will be highlighted show the different paths followed by a successful and an unsuccessful concept. The outlook for future VTOL/rotary wing concepts will be evaluated.

Huston, Robert J.↗

NASA NTRS1989

Noise considerations for tiltrotor

A projection is made of the technology-development requirements faced by aircraft designers contemplating the evolution of V-22-type tilt-rotor aircraft technology into a civilian tilt-rotor commuter aircraft of the requisite scale and payload. These research challenges are noted to often involve the reduction of noise level to values tolerated by passengers within the cabin and communities in the vicinity of airports, especially during hover and in the course of transition from vertical to horizontal flight (and vice-versa). Noise-generation and noise-radiation characteristics research has been undertaken using the XV-15 tilt-rotor proof-of-concept aircraft.

Huston, Robert J.↗

NASA NTRS1960

Data from a Static-Thrust Investigation of Large-Scale General Research VTOL-STOL Model in Ground Effect

The model was tested at two different elevations with the wing pivot at 1.008 and 2.425 propeller diameters above the ground. The slipstream of the propellers was deflected by tilting the wing and propellers, by deflections of large-chord trailing-edge flaps, and by combinations of flap deflection and wing tilt. Tests were conducted over a range of propeller disk loadings from 7.41 to 29.70 pounds per square foot. Force data for the complete model and pressure distributions for the wing and flaps behind one propeller were recorded and are presented in tabular form without analysis.

Huston, Robert J.↗