Engineering topics

Iavarone, Maria

Publications and source records attributed to Iavarone, Maria.

6 records

DOE OSTI2024

The nontrivial effects of annealing on superconducting properties of Nb single crystals

The effect of annealing on the superconducting properties of niobium single crystals was studied using optical, magnetic, and scanning tunneling microscopy (STM) methods. Pieces of the same crystal boule were studied before and after the annealing at 800 ${^\circ}\textrm{C}$, 1400 ${^\circ}\textrm{C}$, and near the melting point of niobium (2477 ${^\circ}\textrm{C}$). The initial samples had a high hydrogen content and low-temperature imaging revealed large hydrides (hundreds of micrometers) appearing below 190 K. The formation of these large precipitates is already completely suppressed by annealing at 800 ${^\circ}\textrm{C}$. However, the overall superconducting properties of the annealed samples did not improve and, in fact, worsened. In particular, the superconducting transition temperature decreased, the upper critical field increased, and the pinning strength increased. In the STM study, the sample was annealed initially at 400 ${^\circ}\textrm{C}$, measured, annealed at 1700 ${^\circ}\textrm{C}$, and measured again. The STM revealed a ‘dirty’ superconducting gap with a significant spatial variation in tunneling conductance after annealing at 400 ${^\circ}\textrm{C}$. The clean gap was recovered after annealing at 1700 ${^\circ}\textrm{C}$. This is likely due to oxygen redistribution near the surface, which is always covered by oxide layers in as-grown crystals. Our results indicate that vacuum annealing at least up to 1400 ${^\circ}\textrm{C}$, while removing a large percentage of hydrogen, introduces additional nanosized defects, likely hydride precipitates, that act as efficient pair-breaking and pinning centers. The dimensionless scattering rate is estimated to have increased from $\Gamma = 0.2$ to about $\Gamma = 0.4$ after annealing at 1400 ${^\circ}\textrm{C}$. These results on single crystals differ drastically from those obtained in polycrystalline bulk niobium (i.e. cut from superconducting radio-frequency cavities), where annealing is known to have a significant positive effect that is attributed to the improvement of the crystalline structure masking the more subtle influence of the hydrides.

43 PARTICLE ACCELERATORS↗

DOE OSTI2023

Characterization of dissipative regions of a N-doped superconducting radio-frequency cavity

We report radio-frequency measurements of quality factors and temperature mapping of a nitrogen doped Nb superconducting RF cavity. Cavity cutouts of hot and cold spots were studied with low temperature scanning tunneling microscopy and spectroscopy, X-ray photoelectron spectroscopy and secondary electron microscopy. Temperature mapping revealed a substantial reduction of the residual resistance upon cooling the cavity with a greater temperature gradient and hysteretic losses at the quench location, pointing to trapped vortices as the dominant source of residual surface resistance. Analysis of the tunneling spectra in the framework of a proximity effect theory shows that hot spots have a reduced pair potential and a wider distribution of the contact resistance between the Nb and the top Nb oxide. Alone, these degraded superconducting properties account for a much weaker excess dissipation as compared with the vortex contribution. Based on the correlation between the quasiparticle density of states and temperature mapping, we suggest that degraded superconducting properties may facilitate vortex nucleation or settling of trapped flux during cooling the cavity through the critical temperature.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

DOE OSTI2023

Energy Frontier Research Centers: Center for the Computational Design of Functional Layered Materials (CCDM) August 1, 2014 - July 31, 2018; Center for Complex Materials from First Principles (CCM) August 1, 2018 - July 31, 2021 (Final Report)

The mission of the DOE Energy Frontier Research Centers CCDM (2014-2018) and CCM (2018-2021) was to theoretically develop, computationally apply, and experimentally validate electronic structure methods for all materials, with a focus on the complex materials, especially layered and two-dimensional materials, strongly-correlated materials, and liquid water. This was achieved by over 200 published journal articles authored by about 17 senior investigators from physics and chemistry and from theory, computation, and experiment, plus their collaborators. In particular, the Centers confirmed the predictive power of the SCAN (strongly constrained and appropriately normed) density functional, which was constructed to satisfy 17 known exact constraints and several appropriate norms. Without being fitted to real bonded systems, and at a modest computational cost, SCAN correctly predicted covalent, ionic, metallic, hydrogen, and van der Waals bonds in many challenging materials. SCAN gave an improved description of defects in semiconductors, surface properties of metals, seven phases of ice, liquid water, liquid and supercooled silicon, subtle structural distortions in ferroelectrics, formation energies and structural predictions for solids, and critical pressures for structural phase transitions. Perhaps most remarkably, SCAN correctly described some strongly-correlated materials that were previously believed to be beyond the reach of density-functional approximations. SCAN is the only density functional that correctly predicts the band gap closing under chemical doping of the cuprate high-temperature superconducting materials. SCAN also predicts a landscape of competing stripe and magnetic phases in the cuprates. For some materials with some codes, SCAN has convergence problems that are greatly reduced by the CCM-developed r 2 SCAN, without loss of accuracy or rigor. SCAN and r 2 SCAN still make some self-interaction error, which is greatly reduced by the CCDM/ CCM-developed local orbital scaling correction (LOSC). These Centers further proved that the fundamental energy gaps of a solid from an orbital energy difference and from total energy differences are the same for a large class of generalized Kohn-Sham (GKS) functionals, including SCAN and standard hybrid functionals, and that symmetry breaking arises when a dynamic density fluctuation drops to zero frequency. The Centers identified new mechanisms for catalysis in layered materials with ions intercalated between the layers, investigated charge density waves both in model systems and in real layered materials, studied changes of band gap with the number of layers, and explored topological ultrathin films, bent nanoribbons, and defects.

08 HYDROGEN↗

DOE OSTI2022

Visualization of defect induced in-gap states in monolayer MoS 2

Atomic-scale intrinsic defects play a key role in controlling functional electronic properties of two-dimensional (2D) materials. Here, we present a low-temperature scanning–tunneling microscopy and spectroscopy investigation of a common point-defect in monolayer molybdenum disulfide (MoS 2 ). We employ a sample preparation method in which the film surface is never exposed to air so that the native dangling bonds surrounding the defects in the film are preserved. Molybdenum vacancies are identified by their three characteristic in-gap resonances by combining scanning–tunneling measurements with parallel Green’s function-based theoretical modeling. The relative energy shifts between the various in-gap states allow us to identify a relative charge difference between two of the observed vacancies. The role of the substrate on the band structure of the defective MoS 2 monolayer is unveiled. Our study highlights the effects of the substrate on the in-gap states of common defects found in MoS 2 providing a pathway in designing and optimizing 2D materials for electronic applications.

36 MATERIALS SCIENCE↗

DOE OSTI2021

Spectroscopic study of the coupling effect between the two gaps of magnesium diboride on its RF properties

This program studied the two-gap nature of magnesium diboride and its possible effects on the superconducting rf properties of this material. Magnesium diboride (MgB 2 ) is a BCS superconductor with a superconducting critical temperature of 39 K, high critical current density and no weak link behavior across the grain boundary. These properties make this material ideal for both power applications and electronic devices. In particular, the high superconducting critical temperature and high thermodynamic field suggests that MgB 2 could be an ideal material also for superconducting radio frequency (SRF) cavities operating at a much higher temperature than Nb cavities and, therefore, reducing noticeably the cryogenics costs. However, MgB 2 is a two gap superconductor and it has been suggested that the RF properties are dominated by the smaller gap, which would make this material not competitive with Nb and especially Nb 3 Sn. The main problem does not seem to be the double-gap nature of this material but rather the weak-coupling of the two gaps that in the presence of an RF field suppresses superconductivity all together at fields much lower than the thermodynamic field. The main goal of this proposal is to address the fundamental question of the coupling between the two gaps in MgB 2 and understand if it is possible to control it and ultimately improve the RF performance of MgB 2 . The project studied these questions by measuring the density of states in the presence of an in-plane current and focused on the effect of controlled disorder. Disorder, indeed, provides an important knob to tune the properties of MgB2 and provides the possibility of changing the coupling between the two bands, making this material a competitive material for SRF applications.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

DOE OSTI2020

Vortex Matter in Confined Superconductors and Mesoscopic Hybrid Heterostructures. Final report

This program studied the fundamental features that underlie the behavior of hybrid ferromagnet/superconductor heterostructures both in the regime of magnetic coupling and proximity effect. In ferromagnet/superconductor hybrid structures, the source of superconducting correlations and ferromagnetism are spatially separated. Therefore, the interplay between ferromagnetism and superconductivity results in physical effects that are not easily observed in bulk superconductors and allows to tune the local superconducting and vortex properties, realizing, thus, a new class of materials. In the case of proximity effect the ferromagnet and the superconductor are in contact and leakage of superconducting pairs is allowed into the ferromagnetic layer. Typically, the decay length for the superconducting pair correlations in the ferromagnet is of the order of one nanometer due to the typically large ferromagnetic exchange field. However, a suitable magnetic structure in the ferromagnetic material can be used to align the spins of the superconducting pairs allowing much longer penetration of superconductivity in the magnetic material. These superconducting pairs with aligned spins can carry spin and provide the basis for superconducting spintronics devices. In the case of magnetic coupling the effect of a spatial inhomogeneous stray field produced by the ferromagnet substantially modifies the nucleation of the order parameter in the superconducting layer and can lead to a significant change in the local superconducting properties. Therefore, magnetically coupled planar ferromagnet-superconductor hybrid structures offer new avenues for manipulation of the superconductivity at the nanoscale and convenient means to control vortex dynamics.

36 MATERIALS SCIENCE↗