Search NASA⌕ Search

Engineering topics

Isbill, Sara B.

Publications and source records attributed to Isbill, Sara B..

10 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Strain-Induced Shifts in Defective Graphite Phonon Modes Predicted by Density Functional Theory

Carbon fiber composites have gained attention as a structural material because of their high strength-to-weight ratio, and understanding the effect of defects on reactivity and mechanical properties is important for the longevity and safety of the composite. Although it is known that strain causes the underlying graphitic vibrational modes to redshift, it is not clear how strain may alter reactivity and defect-induced vibrational changes. To investigate the strain-induced phonon changes of defective carbon fiber composites, density functional theory calculations of graphite are used, including intercalated hydrogen and fluorine defects. By comparing changes in the bond lengths, formation energies, and phonon density of states for uniaxially and biaxially strained graphite, strain was found to generally make defect formation more favorable and the specific behavior changes are dependent on the strain direction and defect identity. Specifically, intercalated fluorine phonons are more sensitive to strain than hydrogen intercalation phonons, and strain applied along the zigzag direction alters the calculated properties more than strain along the armchair direction. Finally, these results highlight the importance of understanding the microstructural effect of deviations from the ideal material because small changes in strain or defect type can significantly alter the behavior of the carbon fiber composite core.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2023

Pressure-induced evolution of the lattice dynamics for selected UO 3 polymorphs

Uranium trioxide (UO 3 ) is a stable chemical form of uranium oxide with multiple polymorphs found throughout the nuclear fuel cycle. The pressure-induced changes in the structure and lattice dynamics of four of these polymorphs are simulated with density functional perturbation theory and analyzed. Two phases, α- and δ-UO 3 are found to exhibit an isotropic response to pressure and do not undergo any changes in coordination geometry up to ~40 GPa. In contrast, the other two phases investigated, β- and γ-UO 3 , exhibit an anisotropic response to pressure. Decomposition of the phonon eigenvectors allows us to assign specific pressure-induced structural changes to individual phonon modes. Here, this analysis has been performed on a per atom basis for the relatively simple α- and δ-UO 3 structures, which have one symmetrically unique uranium site, and on a per coordination environment basis for β- and γ-UO 3 , which have multiple U sites.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗
DOE OSTI2023

Insight into the structural ambiguity of actinide(IV) oxalate sheet structures: a case for alternate coordination geometries

Plutonium(IV) oxalate hexahydrate (Pu(C 2 O 4 ) 2 ∙ 6H 2 O; PuOx) is an important intermediate in the recovery of plutonium from used nuclear fuel. Its formation via precipitation is well studied, yet its crystal structure remains unknown. Instead, the crystal structure of PuOx is assumed to be isostructural with neptunium(IV) oxalate hexahydrate (Np(C 2 O 4 )­ 2 ∙ 6H 2 O; NpOx) and uranium(IV) oxalate hexahydrate (U(C 2 O 4 )­ 2 ∙ 6H 2 O; UOx) despite the high degree of unresolved disorder that exists when determining water positions in the crystal structures of the latter two compounds. Such assumptions regarding the isostructural behavior of the actinide elements have been used to predict the structure of PuOx for use in a wide range of studies. Herein, we report the first crystal structures for PuOx and Th(C 2 O 4 ) 2 · 6H 2 O (ThOx). This data, along with new characterization of UOx and NpOx, has resulted in the full determination of the structures and resolution of the disorder around the water molecules. Specifically, we identify the coordination of two water molecules with each metal center, which necessitates a change in oxalate coordination mode from axial to equatorial that has not been reported in the literature. Here this work exemplifies the need to revisit previous assumptions regarding fundamental actinide chemistry, which are heavily relied upon within the current nuclear field.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2022

Computational investigation of hydrogen-induced phonon changes in carbon fiber

Optical vibrational spectroscopy has shown promise as a noninvasive means of monitoring the mechanical properties of carbon fiber (CF), which is increasingly used for industrial and consumer purposes. However, interpretation of optical vibrational spectra for solid materials is inferential, particularly when defects are present. Because inelastic neutron scattering (INS) spectroscopy is not subject to selection rules, the full vibrational spectra can be measured. And, identifying correlations between INS features and tensile properties can assist in the interpretation of spectra from more commonly used optical vibrational spectroscopic techniques, such as Raman and infrared (IR) spectroscopy. Recent INS experiments on high-performance commercial carbon fibers showed features near 900 and 1100 cm –1 in addition to a broad feature near 3000 cm –1 that increased in intensity with decreasing tensile strength. These features were assigned to hydrogen defects. Here, we use density functional theory to simulate the INS spectra of several hydrogen defect geometries in graphite as a model for carbon fiber structure units, confirming the experimental assignment of these peaks to hydrogen modes and providing insights into the structure and lattice dynamics of the defects.

36 MATERIALS SCIENCE↗
DOE OSTI2022

Computational insights into the lattice dynamics of Pu(IV) oxalates

Despite its use in PuO 2 production, the structure of anhydrous Pu(C 2 O 4 ) 2 is still not completely understood. Recently, two candidate structures for Pu(C 2 O 4 ) 2 were proposed via density functional theory (DFT), after which the first experimental optical vibrational spectra were reported. Here, in this study, we calculated the lattice dynamics of the candidate structures using DFT and found that the primary difference between them is the presence of a vibrational mode near 1380 cm -1 in one structure. The frequency and optical activity of this mode agree well with the published experimental results, providing strong support for this calculated structure as that of anhydrous Pu(C 2 O 4 ) 2 .

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗
DOE OSTI2022

Density functional theory investigations into the magnetic ordering of U 3 O 8

Density functional theory (DFT) has been highly successful in supporting experimental materials science; however, a correct electronic ground state is required to realize the full theoretical capacity of DFT. The uranium oxides, α–U 3 O 8 in particular, are simultaneously technologically important materials and theoretically challenging for DFT because the uranium magnetic ground state is not obvious. This is true for both experiment and theory—magnetic susceptibility measurements indicate an antiferromagnetic (AFM) ground state with transitions near 4.2 and 8.0 K, but the ordering itself is not known. Theoretical literature reports are in contradiction, with independent studies finding paramagnetic, ferromagnetic (FM), and AFM states as the lowest energy configuration. However, recent inelastic neutron scattering experiments suggested an uninvestigated magnetic structure with ordering along the [0.5 1 1] plane, motivating a theoretical reinvestigation. Using this insight, we calculated the relative energy of FM and AFM orderings along [0.5 1 1], [0.5 0 0], [0 1 0], and [0 0 1] using noncollinear DFT calculations with spin-orbital coupling. In this work, we found that the [0.5 1 1] AFM structure is lower in energy than FM or AFM orderings along the low Miller index directions. We also investigated polarization of the magnetic moment along each lattice vector and found that polarization along the out-of-plane direction is the energetically preferred orientation for the AFM structures. Additionally, we found in all calculations that moments initially pointing along the in-plane lattice vectors significantly relax until they point along the coordinate between the two crystallographically distinct uranium sites with complex noncollinear magnetic configurations. The new [0.5 1 1] AFM magnetic structure provides an additional path forward toward understanding the electronic structure of α-U 3 O 8 and lends theoretical credibility to recent neutron scattering results.

36 MATERIALS SCIENCE↗
DOE OSTI2022

Structural Characterization of Uranium Tetrafluoride Hydrate (UF 4 ·2.5H 2 O)

Uranium tetrafluoride is an important intermediate in the nuclear fuel cycle. Facile synthesis of its hydrate, uranium tetrafluoride hydrate (UF 4 ·2.5H 2 O), has recently been reported. The hydrate forms by contacting anhydrous UF 4 with neat H 2 O at room temperature for 24 h or by exposing anhydrous UF 4 to high relative humidity (>90%) conditions for several weeks. These pathways are of clear environmental relevance. Further understanding of the structure and optical spectra of UF 4 ·2.5H 2 O, especially of the water molecules, is therefore necessary. Herein, the structure of UF 4 ·2.5H 2 O was probed using time-of-flight neutron powder diffraction to improve understanding of the crystalline water environments in the structure. The complete structure was elucidated and compared to a previously reported partial structure for UF 4 ·2.5H 2 O and a predicted complete structure from density functional theory. The crystalline structure exhibits three distinct water environments: two of the three water sites are bound to uranium, and the third water is unbound or “free”. Furthermore, the completed structure reveals an extensive hydrogen bonding network involving water–fluorine and water–water interactions. One bound water site participates in hydrogen bonding with nearby fluoride ligands (O–H···F–U), and the second bound water site participates in hydrogen bonding with the unbound water (O–H···O) and a nearby fluoride ligand (O–H···F–U); the unbound water participates in hydrogen bonding with bound water (O–H···O–U). Low-temperature experiments and thermal analysis indicate UF 4 ·2.5H 2 O is thermally stable from 10 to 358 K, undergoes dehydration at higher temperatures, and is nearly dehydrated at 473 K. Structural measurements provide foundational understanding and will inform future investigations of the thermal and environmental stability of UF 4 ·2.5H 2 O.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2021

Reviewing computational studies of defect formation and behaviors in carbon fiber structural units

Solid-state carbon materials, such as graphite and graphene, are at the forefront of materials research because of their unique electronic, vibrational, and mechanical properties, leading to a broad range of potential and realized applications. One key application is their role as basic structural units of carbon fiber (CF), a lightweight alternative to steel. In CF, a delicate relationship exists between ultimate material strength and the atomic-scale density of defects contained at the inter- and intra-subunit levels. Computational studies provide insight into the stability of various types of defects that can form in these systems and connect with experimental observables such as bandgap and spectroscopic measurements. Therefore, the literature contains many computational studies that focus on changes induced by defects, including vacancies and Dienes transformations (Stone-Wales and Thrower defects). However, wide-ranging methods and cell sizes have been used, and property-specific information is often lacking. Furthermore, this review summarizes key literature findings, paying particular attention to changes in the electronic, vibrational, and mechanical properties induced by defects in graphitic materials relevant to CF.

36 MATERIALS SCIENCE↗
DOE OSTI2020

Influence of temperature on accessible pyrolysis pathways of homopolymerized bisphenol A/F epoxies and copolymers

Understanding the thermal pyrolysis of epoxies and their copolymers is important for identifying structural changes resultant from thermal transients, enabling identification of failure modes of high-performance composite materials. This work expands our understanding of the thermal pyrolysis of cured epoxies and the role of temperature and composition on products, pathways, and relative rates. Numerous researchers have explored the pyrolysis of bisphenol A (BPA) epoxy. Significantly fewer have studied bisphenol F (BPF), and copolymers of BPA and BPF have been neglected. In this work, a pyrolysis gas chromatography mass spectrometer (PY-GC-MS) was used to investigate the degradation mechanism of homopolymerized BPA, BPF epoxies and their copolymers. Additionally, for polymer identification, pyrolysis >450 °C resulted in the most extensive fragmentation and is useful for material identification, though lower temperatures show different degradation product profiles that provide mechanistic insight into thermal degradation pathways. Temperature greatly influences the accessible pyrolysis pathways of BPA, revealing dual mechanisms of formation for products p-isopropylphenol and p-isopropenylphenol. For BPF at low pyrolysis temperature the p,p-bisphenol F isomer is produced at significantly lower relative abundance compared to the abundance at higher temperatures tested, but production of the other two isomers changes little with respect to temperature. This suggests the epoxy components consisting of the p,p-bisphenol F isomer have higher thermal stability. Overall, the copolymer epoxies were found to have similar degradation products in stoichiometric distributions. The major exception was the formation of the p,p-bisphenol F isomer, which shows evidence of thermal stabilizing effects from addition of BPA epoxy.

36 MATERIALS SCIENCE↗