Engineering topics

Iversen, J.

Publications and source records attributed to Iversen, J..

6 records

NASA NTRS1986

Design and calibration of the carousel wind tunnel

In the study of planetary aeolian processes the effect of gravity is not readily modeled. Gravity appears in the equations of particle motion along with interparticle forces but the two terms are not separable. A wind tunnel that would permit variable gravity would allow separation of the forces and aid greatly in understanding planetary aeolian processes. The design Carousel Wind Tunnel (CWT) allows for a long flow distance in a small sized tunnel since the test section is a continuo us circuit and allows for a variable pseudo gravity. A prototype design was built and calibrated to gain some understanding of the characteristics of the design and the results presented.

Leach, R. N.↗

NASA NTRS1984

Windblown sand on Venus - Preliminary results of laboratory simulations

Small particles and winds of sufficient strength to move them have been detected from Venera and Pioneer-Venus data and suggest the existence of aeolian processes on Venus. The Venus wind tunnel (VWT) was fabricated in order to investigate the behavior of windblown particles in a simulated Venusian environment. Preliminary results show that sand-size material is readily entrained at the wind speeds detected on Venus and that saltating grains achieve velocities closely matching those of the wind. Measurements of saltation threshold and particle flux for various particle sizes have been compared with theoretical models which were developed by extrapolation of findings from Martian and terrestrial simulations. Results are in general agreement with theory, although certain discrepancies are apparent which may be attributed to experimental and/or theoretical-modeling procedures. Present findings enable a better understanding of Venusian surface processes and suggest that aeolian processes are important in the geological evolution of Venus.

Greeley, R.↗

NASA NTRS1981

Experimental investigation of vortices shed by various wing fin configurations

Forty-six different fins, which were members of twelve plan-form families, were tested. A two dimensional Boeing single element airfoil at an angle of attack of eight degrees and a sweepback angle of thirty-two was used to simulate a portion of the wing of a generator aircraft. Various free stream velocities were used to test any individual fin at its particular angle of attack. While the fin itself was mounted on the upper surface of the generator model, the angle of attack of each fin was varied until stall was reached and/or passed. The relative fin vortex strengths were measured in two ways. First, the maximum angular velocity of a four blade rotor placed in the fin vortex center was measured with the use of a stroboscope. Second, the maximum rolling moment on a following wing model placed in the fin vortex center was measured by a force balance.

Iversen, J.↗

NASA NTRS1980

Threshold windspeeds for sand on Mars - Wind tunnel simulations

Wind friction threshold speeds for particle movement were determined in a wind tunnel operating at martian surface pressure with a 95 percent CO2 and 5 percent air atmosphere. The relationship between friction speed and free-stream velocity is extended to the critical case for Mars of momentum thickness Reynolds numbers between 425 and 2000. It is determined that the dynamic pressure required to initiate saltation is nearly constant for pressures between 1 bar and 4 mb for atmospheres of both air and CO2.

Greeley, R.↗

NASA NTRS1976

Estimates of the wind speeds required for particle motion on Mars

Threshold wind speeds for setting particles into motion on Mars are estimated by evaluating experimentally observed threshold friction velocities and determining the ratio of this velocity to the threshold wind speed at the top of earth's atmospheric boundary layer (ABL). Turning angles between the direction of the wind at the top of the ABL and the wind stress at the surface are also estimated. Detailed consideration is given to the dependence of the threshold wind speed at the top of the ABL on particle diameter, surface pressure, air temperature, atmospheric stability and composition, surface roughness, and interparticle cohesion. The results are applied to interpret a number of phenomena that have been observed on Mars and are attributable to aeolian processes. It is shown that: (1) minimum threshold wind speeds of about 50 to 100 m/sec are required to cause particle motion on Mars under 'favorable' conditions; (2) particle motion should be infrequent and strongly correlated with proximity to small topographical features; (3) in general, particle motion occurs more readily at night than during the day, in winter polar areas than equatorial areas around noon, and for H2O or CO2 ice particles than for silicate particles; and (4) the boundary between saltating and suspendible particles is located at a particle diameter of about 100 microns.

Pollack, J. B.↗

NASA NTRS1976

Mars - Wind friction speeds for particle movement

Wind friction threshold speeds for particle movement were determined in a low pressure boundary layer wind tunnel at an atmospheric pressure of 5.3 mb. The results imply that for comparable pressures on Mars, the minimum wind friction threshold speed is about 2.5 m/sec, which would require free-stream winds of 50 to 135 m/sec, depending on the character of the surface and the atmospheric conditions. The corresponding wind speeds at the height of the Viking lander meteorology instrument would be about a factor of two less than the free-stream wind speed. The particle size most easily moved by winds on Mars is about 160 microns; particles both larger and smaller than this (at least down to about 5 microns) require stronger winds to initiate movement.

Greeley, R.↗