J W Strapp | Search NASA

NASA NTRSDate not supplied

Summary of Additional In-situ Cloud Data in High Ice Water Content Conditions from Three Recent Flight Campaigns

In-situ measurements of cloud Total Water Content and ice particle Median Mass Diameter have been previously collected during the High Altitude Ice Crystal – High Ice Water Content (HAIC-HIWC) and HIWC RADAR I flight campaigns. These measurements have been provided to an Ice Crystal Icing Aviation Rulemaking Advisory Committee to assess Title 14 Code of Federal Regulations (14CFR) Part 33 Appendix D, and recommend possible changes to the envelopes contained therein. Since then, NASA and the FAA have completed three additional flight campaigns in similar clouds. This article examines these new measurements and any impact they might have on Appendix D assessment. The addition of the new flight campaign data had little effect on previous estimates of the properties of high total water content regions of clouds. Some new information on the occurrence of graupel particles may be important to some ice crystal icing applications.

Aircraft Icing, Aircraft Instrumentation, Airspeed↗

NASA NTRSDate not supplied

Wind Tunnel PSD and MVD Characterization Using New 1D2D Optical Array Probes

This work explores characterization of the liquid clouds using a combination of a forward scattering probe and two Optical Array Probes. Current OAP probes provide particle shape, size, and number concentration from two-dimensional shadow images. However, past studies have shown that such images are subject to distortion when outside of the focal plane. This affects the retrieval of particle size distributions, particularly in the Supercooled Large Droplet size range. In this article, the use of a Droplet Measurement Technologies Cloud Droplet Probe and two new OAPs produced by Science Engineering Associates, is examined using wind tunnel data, to assess suitability for use in a wind tunnel calibration in SLD conditions. The new OAP probes exploit a flexible and simple grey scale imaging method to eliminate some present shortcomings of commonly used OAPs, and to reduce correction factors. Spinning disk measurements were used to specify probe depth of field, and average size errors. Composite spectra covering the nominal 2-3200 µm size range were formed by crossing over from the CDP to 1D2D-X at 48 µm, and then to the 1D2D-Y at about 400 µm. A good overlap was found at the crossover points without any artificial scaling. Composite spectra adequately closed the liquid water content distribution, and provided integrated LWCs within about 35% of the hot-wire LWCs used for tunnel calibration. This discrepancy was at least partially attributed to LWC underestimation by the hot-wire at high MVD. A model of probe performance was used to show an example of expected accuracy of ideal probes subject to the same OAP distortions and using the same mitigating procedures and corrections, predicting PSD Median Volume Diameter and integrated LWC errors of less than 10%.

Aircraft Icing↗