Jägle, Eric A. | Search NASA

DOE OSTI2022

Thermodynamics-guided alloy and process design for additive manufacturing

In conventional processing, metals go through multiple manufacturing steps including casting, plastic deformation, and heat treatment to achieve the desired property. In additive manufacturing (AM) the same target must be reached in one fabrication process, involving solidification and cyclic remelting. The thermodynamic and kinetic differences between the solid and liquid phases lead to constitutional undercooling, local variations in the solidification interval, and unexpected precipitation of secondary phases. These features may cause many undesired defects, one of which is the so-called hot cracking. The response of the thermodynamic and kinetic nature of these phenomena to high cooling rates provides access to the knowledge-based and tailored design of alloys for AM. Here, we illustrate such an approach by solving the hot cracking problem, using the commercially important IN738LC superalloy as a model material. The same approach could also be applied to adapt other hot-cracking susceptible alloy systems for AM.

36 MATERIALS SCIENCE↗

DOE OSTI2020

In-situ synthesis of oxides by reactive process atmospheres during L-PBF of stainless steel

Traditionally, reactive gases such as oxygen (O 2 ) and carbon dioxide (CO 2 ) have been avoided during laser powder bed fusion (L-PBF) of metals and alloys based on the notion that it may lead to defect formation and poor properties. Here, in this work, we show that instead, these gases can be used to form sub-μm-sized oxide particles in-situ during the L-PBF process in an Fe-Cr-Al-Ti stainless steel and lead to improved room temperature and high-temperature mechanical properties. We manufactured cube samples using pure Ar and various reactive gas atmospheres, namely an O 2 /Argon (Ar) mixture containing 0.2 % O 2 and CO 2 /Ar mixtures containing up to 100 % CO 2 . Co-axial measurements of infrared radiation emitted from the melt pool showed correlation to the presence of O 2 or CO 2 in the gas mixture. Builds produced under CO 2 -containing atmosphere contained complex oxides with an average diameter of ~40 nm, an Al-rich core and a Ti-rich shell. Due to the high cooling rates typical to L-PBF, agglomeration of oxides and slag formation on the surface of the samples could almost be entirely avoided. Compression tests at temperatures up to 800 °C showed that the samples produced in 100 % CO 2 have about 20 % higher yield stress compared to samples produced in Ar. The paper concludes with a discussion of the formation mechanism of the observed oxides. Our results show that in-situ reactions during additive manufacturing processes are a promising pathway to the synthesis of particle-reinforced alloys.

36 MATERIALS SCIENCE↗