Search NASA⌕ Search

Engineering topics

Jachimowski, C. J.

Publications and source records attributed to Jachimowski, C. J..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1987

Mach 2 combustion characteristics of hydrogen/hydrocarbon fuel mixtures

The combustion of H2/CH4 and H2/C2H4 mixtures containing 10 to 70 vol pct hydrocarbon at combustor inlet Mach number 2 and temperatures 2000 to 4000 R is investigated experimentally, applying direct-connect test hardware and techniques similar to those described by Diskin and Northam (1987) in the facilities of the NASA Langley Hypersonic Propulsion Branch. The experimental setup, procedures, and data-reduction methods are described; and the results are presented in extensive tables and graphs and characterized in detail. Fuel type and mixture are found to have little effect on the wall heating rate measured near the combustor exit, but H2/C2H4 is shown to burn much more efficiently than H2/CH4, with no pilot-off blowout equivalence ratios greater than 0.5. It is suggested that H2/hydrocarbon mixtures are feasible fuels (at least in terms of combustion efficiency) for scramjet SSTO vehicles operating at freestream Mach numbers above 4.

Diskin, Glenn S.↗
NASA NTRS1985

A simplified hydrocarbon reaction mechanism for combustion applications

A simplified chemical kinetic reaction mechanism for the combustion of a hydrocarbon fuel is presented and discussed. The observed kinetic behavior of propane combustion as determined in shock tube studies and the calculated kinetic behavior of propane/air mixtures as derived from a detailed propane combustion mechanism were used as a data base for constructing and refining the mechanism. The mechanism contains 13 chemical species and 26 chemical reactions. Numerical studies revealed that the simplified mechanism can reproduce the observed kinetic behavior of propane/air mixtures, including laminar flame speeds, over a wide range of temperatures and pressures. It is anticipated that the mechanism can be used in various combustion applications and provide a more realistic description of the combustion process than can be achieved using global reaction mechanisms.

Jachimowski, C. J.↗
NASA NTRS1985

Ignition of mixtures of SiH sub 4, CH sub 4, O sub 2, and Ar or N sub 2 behind reflected shock waves

Ignition delay times in mixtures of methane, silane, and oxygen diluted with argon and nitrogen were measured behind reflected shock waves generated in the chemical kinetic shock tube at Langley Research Center. The delay times were inferred from the rapid increase in pressure that occurs at ignition, and the ignition of methane was verified from the emission of infrared radiation from carbon dioxide. Pressures of 1.25 atm and temperatures from 1100 K to 1300 K were generated behind the reflected shocks; these levels are representative of those occurring within a supersonic Ramjet combustor. Expressions for the ignition delay time as a function of temperature were obtained from least squares curve fits to the data for overall equivalence ratios of 0.7 and 1.0. The ignition delay times with argon as the diluent were longer than those with nitrogen as the diluent. The infrared wavelength observations at 4.38 microns for carbon dioxide indicated that silane and methane ignited simultaneously (i.e., within the time resolution of the measurement). A combined chemical kinetic mechanism for mixtures of silane, methane, oxygen, and argon or nitrogen was assembled from one mechanism that accurately predicted the ignition of methane and a second mechanism that accurately predicted silane hydrogen ignition. Comparisons between this combined mechanism and experiment indicated that additional reactions, possibly between silyl and methyl fragments, are needed to develop a good silane methane mechanism.

Mclain, A. G.↗
NASA NTRS1984

Chemical kinetic reaction mechanism for the combustion of propane

A detailed chemical kinetic reaction mechanism for the combustion of propane is presented and discussed. The mechanism consists of 27 chemical species and 83 elementary chemical reactions. Ignition and combustion data as determined in shock tube studies were used to evaluate the mechanism. Numerical simulation of the shock tube experiments showed that the kinetic behavior predicted by the mechanism for stoichiometric mixtures is in good agrement with the experimental results over the entire temperature range examined (1150-2600K). Sensitivity and theoretical studies carried out using the mechanism revealed that hydrocarbon reactions which are involved in the formation of the HO2 radical and the H2O2 molecule are very important in the mechanism and that the observed nonlinear behavior of ignition delay time with decreasing temperature can be interpreted in terms of the increased importance of the HO2 and H2O2 reactions at the lower temperatures.

Jachimowski, C. J.↗
NASA NTRS1983

Ignition of SiH4-H2-O2-N2 behind reflected shock waves

The ignition of mixtures of silane, hydrogen, and oxygen diluted with nitrogen was studied in a chemical kinetic shock tube. Ignition delay time measurements were made behind reflected shock waves at pressures of 1.25 atm and 1.35 atm and temperatures ranging from approximately 800 K to 1050 K for two mixtures with silane-oxygen equivalence ratios of 1.0 and 0.5, respectively. Enhancement of the ignition by use of silane was observed experimentally by the failure of a similar mixture containing only hydrogen, oxygen, and nitrogen to ignite during the maximum test time available for these test conditions.

Mclain, A. G.↗
NASA NTRS1983

A Chemical Kinetic Mechanism for the Ignition of Silane/Hydrogen Mixtures

A chemical kinetic reaction mechanism for the oxidation of silane/hydrogen mixtures is presented and discussed. Shock-tube ignition delay time data were used to evaluate and refine the mechanism. Good agreement between experimental results and the results predicted by the mechanism was obtained by adjusting the rate coefficient for the reaction SiH3 + O2 yields SiH2O + OH. The reaction mechanism was used to theoretically investigate the ignition characteristics of silane/hydrogen mixtures. The results revealed that over the entire range of temperature examined (800 K to 1200 K), substantial reduction in ignition delay times is obtained when silane is added to hydrogen.

Jachimowski, C. J.↗
NASA NTRS1980

Chemical kinetic models for combustion of hydrocarbons and formation of nitric oxide

The formation of nitrogen oxides NOx during combustion of methane, propane, and a jet fuel, JP-4, was investigated in a jet stirred combustor. The results of the experiments were interpreted using reaction models in which the nitric oxide (NO) forming reactions were coupled to the appropriate hydrocarbon combustion reaction mechanisms. Comparison between the experimental data and the model predictions reveals that the CH + N2 reaction process has a significant effect on NO formation especially in stoichiometric and fuel rich mixtures. Reaction models were assembled that predicted nitric oxide levels that were in reasonable agreement with the jet stirred combustor data and with data obtained from a high pressure (5.9 atm (0.6 MPa)), prevaporized, premixed, flame tube type combustor. The results also suggested that the behavior of hydrocarbon mixtures, like JP-4, may not be significantly different from that of pure hydrocarbons. Application of the propane combustion and nitric oxide formation model to the analysis of NOx emission data reported for various aircraft gas turbines showed the contribution of the various nitric oxide forming processes to the total NOx formed.

Jachimowski, C. J.↗
NASA NTRS1979

Chemical kinetic modeling of benzene and toluene oxidation behind shock waves

The oxidation of stoichiometric mixtures of benzene and toluene behind incident shock waves was studied for a temperature range from 1700 to 2800 K and a pressure range from 1.1 to 1.7 atm. The concentration of CO and CO2 produced were measured as well as the product of the oxygen atom and carbon monoxide concentrations. Comparisons between the benzene experimental data and results calculated by use of a reaction mechanism published in the open literature were carried out. With some additional reactions and changes in rate constants to reflect the pressure-temperature range of the experimental data, a good agreement was achieved between computed and experimental results. A reaction mechanism was developed for toluene oxidation based on analogous rate steps from the benzene mechanism. Measurements of NOx levels in an actual flame device, a jet-stirred combustor, were reproduced successfully by use of the reaction mechanism developed from the shock-tube experiments on toluene. These experimental measurements of NOx levels were reproduced from a computer simulation of a jet-stirred combustor.

Mclain, A. G.↗
NASA NTRS1978

Experimental and analytical study of nitric oxide formation during combustion of propane in a jet-stirred combustor

A jet-stirred combustor, constructed of castable zirconia and with an Inconel injector, was used to study nitric oxide formation in propane-air combustion with residence times in the range from 3.2 to 3.3 msec and equivalence ratios varying from 0.7 to 1.4. Measurements were made of combustor operating temperature and of nitric oxide concentration. Maximum nitric oxide concentrations of the order of 55 ppm were found in the range of equivalence ratio from 1.0 to 1.1. A finite-rate chemical kinetic mechanism for propane combustion and nitric oxide formation was assembled by coupling an existing propane oxidation mechanism with the Zeldovich reactions and reactions of molecular nitrogen with hydrocarbon fragments. Analytical studies using this mechanism in a computer simulation of the experimental conditions revealed that the hydrocarbon-fragment-nitrogen reactions play a significant role in nitric oxide formation during fuel-rich combustion.

Wakelyn, N. T.↗
NASA NTRS1977

Chemical kinetic modeling of propane oxidation behind shock waves

The stoichiometric combustion of propane behind incident shock waves was studied experimentally and analytically over a temperature range from 1700 K to 2600 K and a pressure range from 1.2 to 1.9 atm. Measurements of the concentrations of carbon monoxide (CO) and carbon dioxide (CO2) and the product of the oxygen atom and carbon dioxide concentrations (O)(CO) were made after passage of the incident shock wave. A kinetic mechanism was developed which, when used in a computer program for a flowing, reacting gas behind an incident shock wave predicted experimentally measured results quite well. Ignition delay times from the literature were also predicted quite well. The kinetic mechanism consisted of 59 individual kinetic steps.

Mclain, A. G.↗
NASA NTRS1977

An experimental and analytical study of acetylene and ethylene oxidation behind shock waves

An experimental and analytical study of the oxidation of acetylene and ethylene behind incident shock waves was carried out over the temperature range 1815-2365 K at reaction pressures between 1.1 and 1.7 atm. The oxidation process was monitored by measuring radiation from carbon dioxide, carbon monoxide, and the reaction O + CO yields CO2 + h nu. The recorded emission profiles were analyzed to obtain concentrations for carbon dioxide, carbon monoxide, and the product of oxygen atom and the carbon monoxide concentrations. On the basis of this data and induction time data reported in the literature, kinetic models for acetylene and ethylene oxidation were assembled.

Jachimowski, C. J.↗
NASA NTRS1975

Analytical study of mechanisms for nitric oxide formation during combustion of methane in a jet-stirred combustor

The role of chemical kinetics in the formation of nitric oxide during the combustion of methane was examined analytically by means of a detailed chemical mechanism for the oxidation of methane, for the reaction between hydrocarbon fragments, and for the formation of nitric oxide. By comparing predicted nitric oxide levels with values reported in the literature from jet-stirred combuster experiments, it was determined that the nitric oxide levels observed in fuel-rich flames cannot be described by a mechanism in which the rate of nitric oxide formation is controlled solely by the kinetics of oxygen atom formation. A proposed mechanism for the formation of nitric oxide in methane-rich flames reproduces the observed levels. The oxidation of hydrogen cyanide appears to be an important factor in nitric oxide formation.

Jachimowski, C. J.↗
NASA NTRS1975

High temperature chemical kinetic study of the H2-CO-CO2-NO reaction system

An experimental study of the kinetics of the H2-CO-CO2-NO reaction system was made behind incident shock waves at temperatures of 2460 and 2950 K. The overall rate of the reaction was measured by monitoring radiation from the CO + O yields CO2 + h upoilon reaction. Correlation of these data with a detailed reaction mechanism showed that the high-temperature rate of the reaction N + OH yields NO + H can be described by the low-temperature (320 K) rate coefficient. Catalytic dissociation of molecular hydrogen was an important reaction under the tests conditions.

Jachimowski, C. J.↗
NASA NTRS1974

Kinetics of oxygen atom formation during the oxidation of methane behind shock waves

An experimental and analytical study of the formation of oxygen atoms during the oxidation of methane and methane-hydrogen mixtures behind incident shock waves was carried out over the temperature range 1790-2584 K at reaction pressures between 1.2 and 1.7 atm. Oxygen atom levels were determined indirectly by measurement of emission from reaction of O with CO. On the basis of these data and ignition-delay data reported in the literature, a kinetic scheme for methane oxidation was assembled. The proposed kinetic mechanism, in general, predicts higher peak oxygen atom levels than the current oxidation mechanisms proposed by Bowman and Seery and by Skinner and his co-workers.

Jachimowski, C. J.↗
NASA NTRS1972

Shock tube study of the reaction H plus O2 plus Ar yields HO2 plus Ar

Rate coefficient data for the recombination reaction H + 02 + Ar yields H02 + Ar have been determined from studies of lean hydrogen-oxygen mixtures behind incident shock waves over the temperature range of 948 to 1125 K. Hydroxyl radical concentration profiles were measured by ultraviolet absorption spectroscopy, and rate data were obtained through analysis of induction time and exponential growth parameter data. Analysis of the data yielded a rate coefficient which was generally lower than most of the more recent values obtained from shock tube studies. The effect of boundary layer formation on the conditions behind the shock was also examined and found to be negligible.

Jachimowski, C. J.↗