Jackson, David R. | Search NASA

NASA NTRS2007

Solar Occultation Satellite Data and Derived Meteorological Products: Sampling Issues and Comparisons with Aura MLS

Derived Meteorological Products (DMPs, including potential temperature (theta), potential vorticity, equivalent latitude (EqL), horizontal winds and tropopause locations) have been produced for the locations and times of measurements by several solar occultation (SO) instruments and the Aura Microwave Limb Sounder (MLS). DMPs are calculated from several meteorological analyses for the Atmospheric Chemistry Experiment-Fourier Transform Spectrometer, Stratospheric Aerosol and Gas Experiment II and III, Halogen Occultation Experiment, and Polar Ozone and Aerosol Measurement II and III SO instruments and MLS. Time-series comparisons of MLS version 1.5 and SO data using DMPs show good qualitative agreement in time evolution of O3, N2O, H20, CO, HNO3, HCl and temperature; quantitative agreement is good in most cases. EqL-coordinate comparisons of MLS version 2.2 and SO data show good quantitative agreement throughout the stratosphere for most of these species, with significant biases for a few species in localized regions. Comparisons in EqL coordinates of MLS and SO data, and of SO data with geographically coincident MLS data provide insight into where and how sampling effects are important in interpretation of the sparse SO data, thus assisting in fully utilizing the SO data in scientific studies and comparisons with other sparse datasets. The DMPs are valuable for scientific studies and to facilitate validation of non-coincident measurements.

Manney, Gloria↗

NASA NTRS1991

A general analysis of propagation along multiple-layer superconducting stripline and microstrip transmission lines

A rigorous spectral-domain formulation for a superconducting stripline or microstrip transmission line with a multiple-layer dielectric substrate is presented. The formulation models the strip conductor as a surface current with an equivalent surface impedance, where the surface impedance is approximated in closed form when the strip is either much thinner or much thicker than a penetration depth. In either case the surface impedance is related to the complex conductivity of the material, which is calculated from a two-fluid model. Results are presented to show the slow-wave propagation and attenuation along both microstrip and stripline packages in a realistic multiple-layer configuration, which accounts for the field penetration into the superconducting ground planes.

Nghiem, David↗

NASA NTRS1990

Microwave characterization of high-temperature superconducting thin films using stripline resonators

A method was derived for the extraction of the surface resistivity (Rs) of high-Tc superconducting (HTS) thin films at microwave frequencies, using a stripline resonator circuit. Surface resistivity values were calculated by measuring the difference in Q-values of a stripline resonator configuration when an HTS thin film was substituted for one of the metallic ground planes. Cryogenic tests were completed for several stripline resonator structures, yielding accurate predictions of the HTS thin-film performance at frequencies between 3 and 26 GHz (in harmonics of approximately 3 GHz). These results were then used to illustrate the dependence of HTS surface resistivity on frequency and temperature in the microwave frequency band.

Macdonald, Alan D.↗

NASA NTRS1990

A general analysis of propagation along multiple-layer superconducting stripline and microstrip transmission lines

A rigorous spectral-domain formulation for a superconducting stripline or microstrip transmission line with a multiple-layer dielectric substrate is presented. The formulation models the strip conductor as a surface current with an equivalent surface impedance, where the surface impedance is approximated in closed form when the strip is either much thinner or much thicker than a penetration depth. In either case the surface impedance is related to the complex conductivity of the material, which is calculated from a two-fluid model. Results are presented to show the slow-wave propagation and attenuation along both microstrip and stripline packages in a realistic multiple-layer configuration, which accounts for the field penetration into the superconducting ground planes.

Nghiem, David↗

NASA NTRS1988

An investigation of conformable antennas for the astronaut backpack communication system

During periods of extravehicular activity it is obviously important that communication and telemetry systems continue to function independently of the astronaut. A system of antennas must therefore be designed that will provide the necessary isotropic coverage using circular polarization over both the transmit and receive frequency bands. To avoid the inherent physical limitations to motion that would be incurred with any sort of protruding antenna, it is necessary that the radiator be essentially flush-mounted or conformable to the structure on which it is attached. Several individual antenna elements are needed for the desired coverage. Both the particular elements chosen and their location determine the ultimate radiation pattern of the overall system. For these reasons a two-fold research plan was undertaken. First, individual elements were investigated and designed. Then various mounting locations were considered and the radiation patterns were predicted taking into account the effects of the astronaut's backpack.

Long, Stuart A.↗