Search NASA⌕ Search

Engineering topics

Jackson, T. J.

Publications and source records attributed to Jackson, T. J..

At least 55 records · Page 3

A model for microwave emission from vegetation-covered fields

The measured brightness temperatures over vegetation-covered fields are simulated by a radiative transfer model which treats the vegetation as a uniform canopy with a constant temperature, over a moist soil which emits polarized microwave radiation. The analytic formula for the microwave emission has four parameters: roughness height, polarization mixing factor, effective canopy optical thickness, and single scattering albedo. A good representation has been obtained with the model for both the horizontally and vertically polarized brightness temperatures at 1.4 and 5 GHz frequencies, over fields covered with grass, soybean and corn. A directly proportional relation is found between effective canopy optical thickness and the amount of water present in the vegetation canopy. The effective canopy single scattering albedo depends on vegetation type.

Mo, T.↗

USDA-ARS Hydrology Laboratory MISWG Hydrology Workshop

Current research being conducted in remote sensing techniques for measuring hydrologic parameters and variables deals with runoff curve numbers (CN), evapotranspiration (ET), and soil moisture. The CN and ET research utilizes visible and infrared measurements. Soil moisture investigations focus on the microwave region of the electromagnetic spectrum.

Jackson, T. J.↗

A multi-frequency measurement of thermal microwave emission from soils - The effect of soil texture and surface roughness

An experiment on remote sensing of soil moisture content was conducted over bare fields with microwave radiometers at the frequencies of 1.4 GHz, 5 GHz, and 10.7 GHz during July September of 1981. Three bare fields with different surface roughneses and soil textures were prepared for the experiment. Ground truth acquisition of soil temperatures and moisture contents for 5 layers down to the depth of 15 cm was made concurrently with radiometric measurements. The experimental results show that the effect of surface roughness is to increase the soils' brightness temperature and to reduce the slope of regression between brightness temperature and moisture content. The slopes of regression for soils with different textures are found to be comparable, and the effect of soil texture is reflected in the difference of regression line intercepts at brightness temperature axis. The result is consistent with laboratory measurement of soils' dielectric permittivity. Measurements on wet smooth bare fields give lower brightness temperatures at 5 GHz than at 1.4 GHz. Previously announced in STAR as N82-24550

Wang, J. R.↗

A multi-frequency measurement of thermal microwave emission from soils: The effects of soil texture and surface roughness

An experiment on remote sensing of soil moisture content was conducted over bare fields with microwave radiometers at the frequencies of 1.4 GHz, 5 GHz, and 10.7 GHz during July - September of 1981. Three bare fields with different surface roughnesses and soil textures were prepared for the experiment. Ground truth acquisition of soil temperatures and moisture contents for 5 layers down to the depths of 15 cm was made concurrently with radiometric measurements. The experimental results show that the effect of surface roughness is to increase the soils' brightness temperature and to reduce the slope of regression between brightness temperature and moisture content. The slopes of regression for soils with different textures are found to be comparable, and the effect of soil texture is reflected in the difference of regression line intercepts at brightness temperature axis. The result is consistent with laboratory measurement of soils' dielectric permittivity. Measurements on wet smooth bare fields give lower brightness temperatures at 5 GHz than at 1.4 GHz.

Wang, J. R.↗

Aircraft remote sensing of soil moisture and hydrologic parameters, Taylor Creek, Florida, and Little River, Georgia, 1979 data report

Experiments were conducted to evaluate aircraft remote sensing techniques for hydrology in a wide range of physiographic and climatic regions using several sensor platforms. The data were collected in late 1978 and during 1979 in two humid areas--Taylor Creek, Fla., and Little River, Ga. Soil moisture measurements and climatic observations are presented as well as the remote sensing data collected using thermal infrared, passive microwave, and active microwave systems.

Jackson, T. J.↗

Aircraft active microwave measurements for estimating soil moisture

Both active and passive microwave sensors are sensitive to variations in near-surface soil moisture. The principal advantage of active microwave systems for soil moisture applications is that high spatial resolution can be retained even at satellite attitudes. The considered investigation is concerned with the use of active microwave scatterometers for estimating near-surface soil moisture. Microwave scatterometer data were obtained during a series of three aircraft flights over a group of Oklahoma research watersheds during May 1978. Data were obtained for the C, L, and P bands at angles of incidence between 5 and 50 degrees. The best results were obtained using C band data at incidence angles of 10 and 15 degrees and soil moisture depth of 0 to 15 cm. These results were in excellent agreement with the conclusions of the truck-mounted scatterometer measurement program reported by Ulaby et al. (1978, 1979).

Jackson, T. J.↗

Radiometric measurements over bare and vegetated fields at 1.4 GHz and 5 GHz frequencies

Microwave emission from bare and vegetated fields was measured with dual polarized radiometers at 1.4 GHz and 5 GHz frequencies. The measured brightness temperatures over bare fields are shown to compare favorably with those calculated from radiative transfer theory with two constant parameters characterizing surface roughness effect. The presence of vegetation cover is found to reduce the sensitivity to soil moisture variation. This sensitivity reduction is generally pronounced the denser, the vegetation cover and the higher the frequency of observation. The effect of vegetation cover is also examined with respect to the measured polarization factor at both frequencies. With the exception of dry corn fields, the measured polarization factor over vegetated fields is found appreciably reduced compared to that over bare fields. A much larger reduction in this factor is found at 5GHz than at 1.4GHz frequency.

Wang, J. R.↗

Survey of in-situ and remote sensing methods for soil moisture determination

General methods for determining the moisture content in the surface layers of the soil based on in situ or point measurements, soil water models and remote sensing observations are surveyed. In situ methods described include gravimetric techniques, nuclear techniques based on neutron scattering or gamma-ray attenuation, electromagnetic techniques, tensiometric techniques and hygrometric techniques. Soil water models based on column mass balance treat soil moisture contents as a result of meteorological inputs (precipitation, runoff, subsurface flow) and demands (evaporation, transpiration, percolation). The remote sensing approaches are based on measurements of the diurnal range of surface temperature and the crop canopy temperature in the thermal infrared, measurements of the radar backscattering coefficient in the microwave region, and measurements of microwave emission or brightness temperature. Advantages and disadvantages of the various methods are pointed out, and it is concluded that a successful monitoring system must incorporate all of the approaches considered.

Schmugge, T. J.↗

Active microwave measurements for estimating soil moisture in Oklahoma

Previous research has shown that active and passive microwave sensors can be used to estimate near surface soil moisture. An advantage of the active systems is that they have the capability of high spatial resolution from satellite platforms. Most of the previous research has been conducted on agricultural fields. This study examined the use of active microwave data for estimating the average surface soil moisture for several watersheds located near Chicasha, Oklahoma. Data were collected using P, L, and C band scatterometers, mounted on the National Aeronautics and Space Administration C130B aircraft flying at an altitude of 300 m. Soil moisture data were collected in conjunction with three flights during May 1978. Our results indicated that relationships between the scatterometer data and soil moisture do exist and agree with the results obtained at the University of Kansas.

Jackson, T. J.↗

Effects of vegetation on passive microwave estimates of soil moisture

Data collected over plots using a microwave radiometer with a wavelength of 21 cm were used to evaluate a theoretical model of the effect of vegetative cover on the emission of soils. The theoretical model was used as a basis of a simplified model which predicts the emissivity of a soil-vegetation complex with a full canopy cover. This model, when transformed to predict soil moisture, requires measurements of the microwave brightness temperature, surface temperature and vegetation biomass. Since surface temperature can be determined using thermal infrared measurements and vegetation biomass could be estimated with visible and near infrared measurements, the simplified model could be applied using only remotely sensed data.

Jackson, T. J.↗

Survey of methods for soil moisture determination

Existing and proposed methods for soil moisture determination are discussed. These include: (1) in situ investigations including gravimetric, nuclear, and electromagnetic techniques; (2) remote sensing approaches that use the reflected solar, thermal infrared, and microwave portions of the electromagnetic spectrum; and (3) soil physics models that track the behavior of water in the soil in response to meteorological inputs (precipitation) and demands (evapotranspiration). The capacities of these approaches to satisfy various user needs for soil moisture information vary from application to application, but a conceptual scheme for merging these approaches into integrated systems to provide soil moisture information is proposed that has the potential for meeting various application requirements.

Schmugge, T. J.↗

Value of Landsat in urban water resources planning

The reported investigation had the objective to evaluate the utility of satellite multispectral remote sensing in urban water resources planning. The results are presented of a study which was conducted to determine the economic impact of Landsat data. The use of Landsat data to estimate hydrologic model parameters employed in urban water resources planning is discussed. A decision regarding an employment of the Landsat data has to consider the tradeoff between data accuracy and cost. Bayesian decision theory is used in this connection. It is concluded that computer-aided interpretation of Landsat data is a highly cost-effective method of estimating the percentage of impervious area.

Jackson, T. J.↗

Test of Landsat-based urban hydrologic modeling

A description is presented of the Fourmile Run Study which has been conducted to evaluate Landsat remote sensing as a method of defining input parameters required by urban hydrologic planning models. The evaluation was a part of water resource planning investigations concerning the Fourmile Run Watershed. The investigations involved an examination of the relationship between urban development and flooding for the Fourmile Run Basin. The study indicates that Landsat data provide a suitable source of land cover data for investigations conducted at the planning level. An estimation of the percentage of impervious area on the basis of Landsat data is less expensive than a use of aerial photos in planning studies. Only limited success could be achieved when Landsat data were used for smaller areal units.

Jackson, T. J.↗

A comparison between conventional and LANDSAT based hydrologic modeling: The Four Mile Run case study

Models designed to support the hydrologic studies associated with urban water resources planning require input parameters that are defined in terms of land cover. Estimating the land cover is a difficult and expensive task when drainage areas larger than a few sq. km are involved. Conventional and LANDSAT based methods for estimating the land cover based input parameters required by hydrologic planning models were compared in a case study of the 50.5 sq. km (19.5 sq. mi) Four Mile Run Watershed in Virginia. Results of the study indicate that the LANDSAT based approach is highly cost effective for planning model studies. The conventional approach to define inputs was based on 1:3600 aerial photos, required 110 man-days and a total cost of $14,000. The LANDSAT based approach required 6.9 man-days and cost $2,350. The conventional and LANDSAT based models gave similar results relative to discharges and estimated annual damages expected from no flood control, channelization, and detention storage alternatives.

Ragan, R. M.↗

Hydrography synthesis using LANDSAT remote sensing and the SCS models

The land cover requirements of the Soil Conservation Service (SCS) Model used for hydrograph synthesis in urban areas were modified to be LANDSAT compatible. The Curve Numbers obtained with these alternate land cover categories compare well with those obtained in published example problems using the conventional categories. Emergency spillway hydrographs and synthetic flood frequency flows computed for a 21.1 sq. mi. test area showed excellent agreement between the conventional aerial photo-based and the Landsat-based SCS approaches.

Ragan, R. M.↗