Search NASA⌕ Search

Engineering topics

Jacobs, Eastman N

Publications and source records attributed to Jacobs, Eastman N.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1939

Airfoil section data obtained in the NACA variable-density tunnel as affected by support interference and other corrections

The results of an investigation of the effect of support interference on airfoil drag data obtained in the variable-density tunnel are presented. As a result of the support interference, previously published airfoil data from the variable-density tunnel have shown too large drag coefficients and too large a rate of increase of drag coefficients and too large a rate increase of drag coefficients with airfoil thickness. The practical effect of the corrections on the choice of the optimum section is briefly considered and corrected data for a selected list of airfoils are presented as a convenience to the designer. Methods of correcting published data for other airfoils are presented.

Jacobs, Eastman N↗
NASA NTRS1938

Airfoil section characteristics as applied to the prediction of air forces and their distribution on wings

The results of previous reports dealing with airfoil section characteristics and span load distribution data are coordinated into a method for determining the air forces and their distribution on airplane wings. Formulas are given from which the resultant force distribution may be combined to find the wing aerodynamic center and pitching moment. The force distribution may also be resolved to determine the distribution of chord and beam components. The forces are resolved in such a manner that it is unnecessary to take the induced drag into account. An illustration of the method is given for a monoplane and a biplane for the conditions of steady flight and a sharp-edge gust. The force determination is completed by outlining a procedure for finding the distribution of load along the chord of airfoil sections.

Jacobs, Eastman N↗
NASA NTRS1937

Airfoil Section Characteristics as Affected by Variations of the Reynolds Number

Report presents the results of an investigation of a systematically chosen representative group of related airfoils conducted in the NACA variable-density wind tunnel over a wide range of Reynolds number extending well into the flight range. The tests were made to provide information from which the variations of airfoil section characteristics with changes in the Reynolds number could be inferred and methods of allowing for these variations in practice could be determined. This work is one phase of an extensive and general airfoil investigation being conducted in the variable-density tunnel and extends the previously published researches concerning airfoil characteristics as affected by variations in airfoil profile determined at a single value of the Reynolds number.

Jacobs, Eastman N↗
NASA NTRS1937

Tests of related forward-camber airfoils in the variable-density wind tunnel

A recent investigation of numerous related airfoils indicated that positions of camber forward of the usual location resulted in an increase of the maximum lift. As an extension of this investigation, a series of forward-camber airfoils has been developed, the members of which show airfoil characteristics superior to those of the airfoils previously investigated. The primary object of this report is to present fully corrected results for airfoils in the useful range of shapes. With the data thus made available, an airplane designer may intelligently choose the best possible airfoil-section shape for a given application and may predict to a reasonable degree the aerodynamic characteristics to be expected in flight from the section shape chosen.

Jacobs, Eastman N↗
NASA NTRS1936

Tests of N.A.C.A. airfoils in the variable-density wind tunnel Series 230.

The results of tests of six airfoils having the N.A.C.A. 230 mean line and varying in thickness from 0.06c to 0.21c are presented. These results agree with previous findings in showing that aerodynamically the best section is one of moderate thickness. The data are of value mainly in connection with the design of tapered wings having sections based on the N.A.C.A. 230 mean line.

Jacobs, Eastman N↗
NASA NTRS1936

Characteristics of the NACA 23012 Airfoil from Tests in the Full-Scale and Variable-Density Tunnels

This report gives the results of tests in the NACA full-scale and variable-density tunnels of a new wing section, the NACA 23012, which is one of the more promising of an extended series of related airfoils recently developed. The tests were made at several values of the Reynolds number between 1,000,000 and 8,000,000. The new airfoil develops a reasonably high maximum lift and a low profile drag, which results in an unusually high value of the speed-range index. In addition, the pitching-moment coefficient is very small. The superiority of the new section over well-known and commonly used sections of small camber and moderate thickness is indicated by making a direct comparison with variable-density tests of the NACA 2212, the well-known NACA family airfoil that most nearly resembles it. The superiority is further indicated by comparing the characteristics with those obtained from full-scale-tunnel tests of the Clark y airfoil.

Jacobs, Eastman N↗
NASA NTRS1936

Tests in the variable-density wind tunnel of related airfoils having the maximum camber unusually far forward

A family of related airfoils having the position of maximum camber unusually far forward was investigated in the variable-density tunnel as an extension of the study recently completed of a large number of related airfoils. The new airfoils gave improved characteristics over those previously investigated, especially in regard to the pitching moment. Some of the new sections are markedly superior to well-known and commonly used sections and should replace them in applications requiring a slightly cambered section of moderate thickness having a small pitching-moment coefficient.

Jacobs, Eastman N↗
NASA NTRS1934

Airfoil section characteristics as affected by protuberances

The drag and interference caused by protuberance from the surface of an airfoil have been determined in the NACA variable-density wind tunnel at a Reynolds number approximately 3,100,000. The effects of variations of the fore-and-aft position, height, and shape of the protuberance were measured by determining how the airfoil section characteristics were affected by the addition of the various protuberances extending along the entire span of the airfoil. The results provide fundamental data on which to base the prediction of the effects of actual short-span protuberances. The data may also be applied to the design of air brakes and spoilers.

Jacobs, Eastman N↗
NASA NTRS1934

Wing characteristics as affected by protuberances of short span

The drag and interference caused by short-span protuberances from the surface of an airfoil have been investigated in the NACA variable-density wind tunnel at a Reynolds number of approximately 3,100,000, based on the chord length of the airfoil. The effects of variations of protuberance span length, span position, and shape were measured by determining how the wing characteristics were affected by the addition of the various protuberances.

Jacobs, Eastman N↗
NASA NTRS1933

The Drag of Streamline Wires

Preliminary results are given of drag tests of streamline wires. Full-size wires were tested over a wide range of speeds in the N.A.C.A. high speed tunnel. The results are thus directly applicable to full-scale problems and include any compressibility effects encountered at the higher speeds. The results show how protuberances may be employed on conventional streamline wires to reduce the drag, and also show how the conventional wires compare with others having sections more like strut or symmetrical airfoil sections. Because the new wire sections developed are markedly superior aerodynamically to conventional wires, it is recommended that some of them be tested in service in order to investigate their relative susceptibility to vibration and to fatigue failure.

Jacobs, Eastman N↗
NASA NTRS1933

The Reduction in Drag of a Forward-sloping Windshield

This paper gives results of a short investigation of the drag of a forward-sloping closed-cabin windshield. The drag of the windshield in both the original and a final modified form was determined from tests in the variable-density wind tunnel. The final form of the windshield was arrived at by modifying the original as the result of flow observations in the N.A.C.A. smoke tunnel. The investigation studied the utility of the N.A.C.A. smoke tunnel as applied to reducing the drag of objects for which the full dynamic scale could not be approached in the smoke tunnel, but designers should find the results of the flow observations and drag measurements of value. They show that most of the large drag added by the original windshield is eliminated by the modification of the windshield to the final form.

Jacobs, Eastman N↗
NASA NTRS1933

The characteristics of 78 related airfoil sections from tests in the variable-density wind tunnel

An investigation of a large group of related airfoils was made in the NACA variable-density wind tunnel at a large value of the Reynolds number. The tests were made to provide data that may be directly employed for a rational choice of the most suitable airfoil section for a given application. The variation of the aerodynamic characteristics with variations in thickness and mean-line form were systematically studied. (author)

Jacobs, Eastman N↗
NASA NTRS1933

The NACA variable-density wind tunnel

This report describes the redesigned variable-density wind tunnel of the National Advisory Committee for Aeronautics; it supersedes a previous report that described the original tunnel. The operation of the balance and the method of testing are explained and the method of correcting and presenting airfoil data is described. A summary of the formulas for predicting the characteristics of finite wings from the airfoil section data as they are usually presented is also given.

Jacobs, Eastman N↗
NASA NTRS1932

Tests on Thrust Augmenters for Jet Propulsion

This series of tests was undertaken to determine how much the reaction thrust of a jet could be increased by the use of thrust augmenters and thus to give some indication as to the feasibility of jet propulsion for airplanes. The tests were made during the first part of 1927 at the Langley Memorial Aeronautical Laboratory. A compressed air jet was used in connection with a series of annular guides surrounding the jet to act as thrust augmenters. The results show that, although it is possible to increase the thrust of a jet, the increase is not large enough to affect greatly the status of the problem of the application of jet propulsion to airplanes.

Jacobs, Eastman N↗
NASA NTRS1932

Characteristics of two sharp-nosed airfoils having reduced spinning tendencies

According to Mr. L.D. Bell, of the Consolidated Aircraft Corporation, certain undesirable spinning characteristics of a commercial airplane were eliminated by the addition of a filler to the forward part of the wing to give it a sharp leading edge. To ascertain what aerodynamic effects result from such a change of section, two airfoils having sharp leading edges were tested in the variable-density wind tunnel. Both sections were derived by modifying the Gott. 398. The tests, which were made at a large value of the Reynolds Number, were carried to very large angles of attack to provide data for application to flight at angles of attack well beyond the stall. The characteristics of the sharp-nosed airfoils are compared with those of the normal Gott. 398 airfoil. Both of the sharp-nosed airfoils, which differ in the angle between the upper and lower surfaces at the leading edge, have about the same characteristics. As compared with the normal airfoil, the maximum lift is reduced by approximately 26 per cent, but the objectionable rapidly decreasing lift with angle of attack beyond the stall is eliminated; the profile drag of the section is slightly reduced in the range of the lift coefficient between 0.2 and 0.85, but at higher and lower lift coefficients the drag is increased.

Jacobs, Eastman N↗