Engineering topics

Jacqmin, David A.

Publications and source records attributed to Jacqmin, David A..

4 records

NASA NTRS2005

A Study of Cavitation-Ignition Bubble Combustion

We present the results of an experimental and computational study of the physics and chemistry of cavitation-ignition bubble combustion (CIBC), a process that occurs when combustible gaseous mixtures are ignited by the high temperatures found inside a rapidly collapsing bubble. The CIBC process was modeled using a time-dependent compressible fluid-dynamics code that includes finite-rate chemistry. The model predicts that gas-phase reactions within the bubble produce CO and other gaseous by-products of combustion. In addition, heat and mechanical energy release through a bubble volume-expansion phase are also predicted by the model. We experimentally demonstrate the CIBC process using an ultrasonically excited cavitation flow reactor with various hydrocarbon-air mixtures in liquid water. Low concentrations (< 160 ppm) of carbon monoxide (CO) emissions from the ultrasonic reactor were measured, and found to be proportional to the acoustic excitation power. The results of the model were consistent with the measured experimental results. Based on the experimental findings, the computational model, and previous reports of the "micro-diesel effect" in industrial hydraulic systems, we conclude that CIBC is indeed possible and exists in ultrasonically- and hydrodynamically-induced cavitation. Finally, estimates of the utility of CIBC process as a means of powering an idealized heat engine are also presented.

Nguyen, Quang-Viet↗

NASA NTRS1998

Radiation Heat Transfer Modeling Improved for Phase-Change, Thermal Energy Storage Systems

Spacecraft solar dynamic power systems typically use high-temperature phase-change materials to efficiently store thermal energy for heat engine operation in orbital eclipse periods. Lithium fluoride salts are particularly well suited for this application because of their high heat of fusion, long-term stability, and appropriate melting point. Considerable attention has been focused on the development of thermal energy storage (TES) canisters that employ either pure lithium fluoride (LiF), with a melting point of 1121 K, or eutectic composition lithium-fluoride/calcium-difluoride (LiF-20CaF2), with a 1040 K melting point, as the phase-change material. Primary goals of TES canister development include maximizing the phase-change material melt fraction, minimizing the canister mass per unit of energy storage, and maximizing the phase-change material thermal charge/discharge rates within the limits posed by the container structure.

Kerslake, Thomas W.↗

NASA NTRS1990

Interfacial dynamics of two liquids under an oscillating gravitational field

The evolution of two miscible liquids meeting at an initially sharp interface inside a cavity under microgravity g-jitter conditions is studied numerically. The response of the interface and kinematics of the flowfield to various g-jitter accelerations and aspect ratio variations is shown. The interface region acts like a vortex source sheet, and it can be unstable to Kelvin-Helmholtz and Rayleigh-Taylor instabilities. The vortices produced along the interface can serve as a stirring mechanism to promote local mixing. Below the critical Stokes-Reynolds number, the destabilization of the interface results in deformation into wavy structures. In some parameter regions, these structures oscillate in time; in others, they are quasi-steady. Above the critical Stokes-Reynolds number, 'chaotic' instability results, and the interface breaks into concentration pockets. The morphology of the initial breakup is similar to observed Rayleigh-Taylor instability. Subsequent mixing of the two fluids after the breakup of the interface is then very rapid.

Duval, Walter M. B.↗

NASA NTRS1988

Dynamics of two fluids under periodic acceleration

The evolution of the interface between two fluids confined in a rectangular cavity is investigated numerically to predict its transient behavior. These computations address mixing characteristics of fluids under microgravity conditions, particularly g-jitter conditions resulting from aircraft vibration or crew motion, and have applications in solution crystal growth. The two-dimensional formulation employs the Boussinesq approximation and treats the mixing of two fluids as an initial value problem with a prescribed concentration field. For fluid mixing of practical applications inside a cavity, it is shown that nonlinear convective transport can dominate over both viscous and molecular diffusion. However, viscous diffusion can become important for low Reynolds number or certain cavity sizes. A stacking phenomenon is shown to occur for aspect ratios (Ar) approximately between 5 to 10. For aspect ratios in the neighborhood of 0.1 to 0.2, inner cells evolve at the interface with increasing time. For a square cavity of Ar = 1, chaotic mixing of the fluid appears to occur for a Stokes-Reynolds number greater than about 5.

Duval, Walter M. B.↗