Engineering topics

Jacqueline Boutin

Publications and source records attributed to Jacqueline Boutin.

5 records

NASA NTRS2024

The Dielectric Constant at P-Band for Salinity from 0 to 150 pss

Measurements have been made at P-band (0.707 GHz) to construct a model for the dielectric constant of sea water and extend the model for the dielectric constant to high salinity (50-150 pss). The measurements are part of research to develop a model for the dielectric constant suitable for future wide-bandwidth remote sensing of salinity and for application to water bodies such as the Great Salt Lake with salinity significantly above that found in the open ocean. Measurements have been made at temperatures from 2 to 30 °C and salinity from 0 to 138 pss. The data have been fit to a Debye model for the dielectric constant with a single resonance as has been employed at L-band (1.413 GHz) where remote sensing of salinity is currently done. Comparison with contemporary models developed from data at L-band indicates that the L-band model and new P-band model do well at both frequencies for salinity less than 50 pss but at higher values of salinity the L-band models diverge from the data. The data has also been used to test at high salinity the mathematical relationship between salinity and conductivity which is the basis for the practical salinity scale (pss).

Dielectric Constant↗

NASA NTRS2023

New Seawater Dielectric Constant Parametrization and Application to SMOS Retrieved Salinity

The accuracy of the Sea Surface Salinity (SSS) retrieved from L-Band radiometer measurements is strongly dependent on the reliability of the dielectric constant model. Two new parametrizations were recently developed based on one hand on the Soil Moisture and Ocean Salinity (SMOS) satellite multi-angular brightness temperature measurements by Boutin et al. (2021) (BV), and on the other hand, on new George Washington University laboratory measurements by Zhou et al. (2021) (GW2020). These two approaches are fully independent. For most SSS and Sea Surface Temperature (SST) conditions commonly observed over the open ocean, the relative variations of brightness temperatures Tb simulated through the BV and GW2020 parametrizations agree particularly well, and better than with earlier parametrizations previously used in the SMOS, Soil Moisture Active Passive (SMAP) and Aquarius SSS retrievals. Nevertheless, uncertainty remains, especially below 10 °C where a ∼ 0.1 K relative difference between the two models is observed. This motivates the development of a revised parameterization, BVZ, based on a methodology similar to that used to derive BV but using GW2020 instead of SMOS measurements. Compared to the GW2020 parameterization, BVZ is derived with a reduced number of degrees of freedom, it relies on the TEOS10 PSS78 conductivity-salinity relationship, and on the previously derived static permittivity of fresh water. One month per season of SMOS data have been reprocessed in 2018 using BV, GW2020, and BVZ. We find the best overall agreement between SMOS SSS and Argo SSS with BVZ parametrization, with noticeable improvement in the 5 °C–15 °C SST range.

sea measurements↗

NASA NTRS2022

FOAM Emissivity Modelling with Foam Properties Tuned by Frequency and Polarization

We model the sea foam emissivity as a part of the work done by an international science team on developing a radiative transfer model of reference quality for the ocean surface emissivity from L band to infrared frequencies. The focus here is on the foam emissivity at frequencies from 1 to 89 GHz. Sensitivity study for different foam properties(foam layer thickness and upper limit of the foam void fraction)guided the effort to tune the model by frequency and polarization. The results show that the differences between simulated and observed brightness temperatures decrease when using tuned foam model.

Magdalena D Anguelova↗

NASA NTRSDate not supplied

A Reference Ocean Surface Emission and Backscatter Model from Microwaves to Infrared

Satellite observations are vital for the initialization of Numerical Weather Prediction models, and very important for climate monitoring and prediction, as well as other applications such as hydrology and flood awareness prediction. Knowledge of radiative contributions from the Earth's surface is needed to sound the lower troposphere from space. The lack of a reference quality ocean emission and backscatter model is a major gap in our ability to provide absolute calibration of the satellite based observing system. Uncertainty in emissivity models is not well characterized and different models are used for different spectral bands, for active and passive instruments. An International Space Science Institute (ISSI) team was put together [4] to address these issues. The objectives of the team are to provide a reference model as a community software (i.e., documented and freely available code), that is maintained and supported, has traceable uncertainty estimations, and that enables new science from microwaves to infrared with bidirectional reflectance distribution function (BRDF) capability. We will present the model and its various components, discussing the choices between various parameterizations, building on the LOCEAN model of [2]. The model predictions will be evaluated at various frequencies, including comparisons to radiometric observations by SMAP, AMSR2 and GMI (e.g., [5]). We will discuss early model evaluation in the infrared and for active microwave sensors. Areas of ongoing research include improving the foam parametrization (coverage and emissivity) to provide consistent performances across frequencies, building on [1], and the azimuthal dependence of the active and passive signals. The model will be used to generate training data for fast models e.g., Fastem, [3], that are used in operational data assimilation and climate re-analysis.

Emmanuel Dinnat↗

NASA NTRSDate not supplied

Improving Ocean Reanalyses and ENSO Forecasts By Assimilation of Rain-Corrected Satellite Sea Surface Salinity Using the GMOA S2s Forecast System

The ENSO phenomenon has a significant global socio-economic impact and has been the key focus for improving coupled ocean-atmosphere forecasts. Assimilation of satellite altimetry and subsurface temperature and salinity from (mostly) Argo help improve the initialization of the thermocline, while satellite SST aids in constraining surface heat-fluxes, leading to improved coupled system sub-seasonal to seasonal forecasts. However, few studies have focused on improving the near-surface density and mixing through satellite sea surface salinity (SSS) assimilation. The few ocean models that assimilate satellite SSS, bias correct to normalize towards the near-surface Argo data for expediency. This assumption is likely inadequate in rainy regions, where buoyant water forms a fresh surface lens. In previous work, we showed that adjusting SSS to bulk salinity (Sb) using the Rain Impact Model (RIM) of Santos-Garcia et al., 2014 improves the near-surface density and mixed layer depth, leading to deeper thermocline and improved NINO3.4 SST forecasts. We now utilize the Soil Moisture and Ocean Salinity rain-corrected (SMOS_RC) SSS, available in SMOS-CATDS products, to represent Sb more accurately at the first model layer (e.g., 5 m). Rather than a diffusivity model as RIM, SMOS_RC uses a statistical correction dependent on Integrated Multi-satellitE Retrievals for GPM (IMERG) rain rates, established on observed SMOS SSS decreases related to Sb in the presence of rain (Supply et al., 2020). For all experiments, all available along-track absolute dynamic topography and in situ observations are assimilated using the LETKF scheme (Penny et al., 2013). One reanalysis additionally assimilates SMOS SSS data as is, and a separate reanalysis assimilates SMOS_RC. We assess the impact on near-surface and subsurface dynamics by validating against observations and explore how SSS assimilation (SMOS vs SMOS_RC) impacts ENSO forecasts using the NASA GMAO Sub-seasonal to Seasonal coupled forecast system (S2S-v3, Molod et al. 2020). We show that improved estimates of density and near-surface mixing led to more accurate coupled air/sea interaction and better ENSO forecasts. The increased SSS, resulting from the removal of the instantaneous rain effect, modifies the ocean state by enhancing mixing and deepening the thermocline.

Veronica Ruiz Xomchuk↗