Investigating Abrasion Effects of Lunar Simulant Grain Sizes on Candidate Spacesuit Fabric
Lunar dust is identified as one of the most significant challenges during the Apollo exploration missions due to its extremely abrasive and electrostatic characteristics. As NASA and the space industry prepare for the upcoming Artemis missions, researching and testing with lunar simulant is quintessential to understanding the effects of lunar dust on the systems and equipment that will be deployed on the lunar surface. Testing will also provide paths that lead to developing technologies and cleaning tools that could be used for dust mitigation. Additionally, it is expected that any hardware that will be exposed to the dusty environment should undergo rigorous testing to ensure it will maintain long-term performance and operate on the lunar surface. For this study, exterior spacesuit fabric was observed. Abrasion is one of the main concerns of lunar dust exposure for spacesuit fabric. Three different abrasion methods were chosen: a rotary tumbler, the Martindale method, and Accelerotor. These abrasion methods were tested on coated and uncoated spacesuit material, Orthofabric, to understand the abrasion rates of sieved lunar simulant and investigate if the addition of ceramic coating mitigated dust abrasion. To summarize, the testing results provided that larger grains are more abrasive than smaller grains, and the selected ceramic coatings did not minimize abrasion during the controlled abrasion tests. It is important to note that the selected ceramic coatings were not designed or intended to provide protection from the abrasive lunar environment. It is recommended to select additional ceramic coatings with an elevated TRL of 5 or greater for testing with Orthofabric and lunar simulant. As an additional note, contact angle measurements were not accounted for in coating selection and should be a factor when selecting adhesion resistant coatings for lunar dust.