Search NASA⌕ Search

Engineering topics

Jacquet, P

Publications and source records attributed to Jacquet, P.

Influence of gas puff location on the coupling of lower hybrid waves in JET ELMy H-mode plasmas

Reliable coupling of the lower hybrid current drive (LHCD) to H-mode plasmas in JET is made feasible through a dedicated gas injection system, located at the outer wall and magnetically connected to the antenna (Pericoli Ridolfini et al 2004 Plasma Phys. Control. Fusion 46 349, Ekedahl et al 2005 Nucl. Fusion 45 351, Ekedahl et al 2009 Plasma Phys. Control. Fusion 51 044001). An experiment was carried out in JET in order to investigate whether a gas injection from the top of the torus, as is foreseen for the main gas injection in ITER, could also provide good coupling of the LH waves if magnetically connected to the antenna. The results show that a top gas injection was not efficient for providing a reliable LHCD power injection, in spite of being magnetically connected and in spite of using almost twice the amount of gas flow compared with the dedicated outer mid-plane gas puffing system. A dedicated gas injection system, set in the outer wall and magnetically connected to the LHCD antenna, is therefore recommended in order to provide the reliable coupling conditions for an LHCD antenna in ITER.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Parasitic signals in the receiving band of the Sub-Harmonic Arc Detection system on JET ICRF Antennas

When testing the SHAD system on JET ICRF antennas, parasitic signals in the detection band (5-20MHz) were detected. We have identified emission from grid breakdown events in the Neutral Beam injectors, and Ion Cyclotron Emission from the plasma. Spurious signals in the band 4-10 MHz are also often observed at the onset of ELM events. Such parasitic signals could complicate the design and operation of SHAD in ICRF systems for fusion devices.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

ICRF scenarios for ITER's half-field phase

The non-active operation phase of ITER will be done in H and {sup 4}He plasmas at half the nominal magnetic field, B{sub 0} = 2.65T. At this field and for the given frequency range of the ICRF system (f = 40-55MHz), three ICRF heating scenarios are available a priori: (i) Fundamental ICRH of majority H plasmas at f{approx_equal}40MHz,(ii) second harmonic (N= 2) {sup 3}He ICRH in H plasmas at f{approx_equal}53MHz and (iii) fundamental minority H heating in {sup 4}He plasmas at f{approx_equal}40MHz. While the latter is expected to perform well for not too large H concentrations, the heating scenarios available for the Hydrogen plasmas are less robust. Recent JET experiments performed in similar conditions to those expected in ITER's half-field phase confirmed the low performance of these two scenarios and numerical simulations have shown that the situation is not much improved in ITER, mainly because of the rather modest plasma temperature and density expected in its initial operation phase. A summary of the main experimental results obtained at JET followed by numerical predictions for ITER's half-field ICRF heating scenarios will be presented.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Enhancing The Mode Conversion Efficiency In JET Plasmas With Multiple Mode Conversion Layers

The constructive interference effect described by Fuchs et al. [1] shows that the mode conversion and thereby the overall heating efficiency can be enhanced significantly when an integer number of fast wave wavelengths can be folded in between the high field side fast wave cutoff and the ion-ion hybrid layer(s) at which the ion Bernstein or ion cyclotron waves are excited. This effect was already experimentally identified in ({sup 3}He)-D plasmas [2] and was recently tested in ({sup 3}He)-H JET plasmas. The latter is an 'inverted' scenario, which differs significantly from the ({sup 3}He)-D scenarios since the mode-conversion layer is positioned between the low field side edge of the plasma and the ion-cyclotron layer of the minority {sup 3}He ions (whereas the order in which a wave entering the plasma from the low field side encounters these layers is inverted in a 'regular' scenario), and because much lower {sup 3}He concentrations are needed to achieve the mode-conversion heating regime. The presence of small amounts of {sup 4}He and D in the discharges gave rise to an additional mode conversion layer on top of the expected one associated with {sup 3}He-H, which made the interpretation of the results more complex but also more interesting: Three different regimes could be distinguished as a function of X[{sup 3}He], and the differing dynamics at the various concentrations could be traced back to the presence of these two mode conversion layers and their associated fast wave cutoffs. Whereas (1-D and 2-D) numerical modeling yields quantitative information on the RF absorptivity, recent analytical work by Kazakov [3] permits to grasp the dominant underlying wave interaction physics.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Interaction of ICRF Fields with the Plasma Boundary in AUG and JET and Guidelines for Antenna Optimization

W sputtering during ICRF on ASDEX Upgrade (AUG) and temperature rise on JET A2 antenna septa are considered in connection with plasma conditions at the antenna plasma facing components and E{sub parallel} near-fields. Large antenna-plasma clearance, high gas puff and low light impurity content are favorable to reduce W sputtering in AUG. The spatial distribution of spectroscopically measured effective W sputtering yields clearly points to the existence of strong E{sub parallel} fields at the antenna box ('feeder fields') which dominate over the fields in front of the antenna straps. The picture of E{sub parallel} fields, obtained by HFSS code, corroborates the dominant role of E{sub parallel} at the antenna box on the formation of sheath-driving RF voltages for AUG. Large antenna-plasma clearance and low gas puff are favorable to reduce septum temperature of JET A2 antennas. Assuming a linear relation between the septum temperature and the sheath driving RF voltage calculated by HFSS, the changes of the temperature with dipole phasing (00{pi}{pi}, 0{pi}{pi}0 or 0{pi}0{pi}) are well described by the related changes of the RF voltages. Similarly to the AUG antenna, the strongest E{sub parallel} are found at the limiters of the JET A2 antenna for all used dipole phasings and at the septum for the phasings different from 0{pi}0{pi}. A simple general rule can be used to minimize E{sub parallel} at the antenna: image currents can be allowed only at the surfaces which do not intersect magnetic field lines at large angles of incidence. Possible antenna modifications generally rely either on a reduction of the image currents, on their short-circuiting by introducing additional conducting surfaces or on imposing the E{sub parallel} = 0 boundary condition. On the example of AUG antenna, possible options to minimize the sheath driving voltages are presented.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Overview on Experiments On ITER-like Antenna On JET And ICRF Antenna Design For ITER

Following an overview of the ITER Ion Cyclotron Resonance Frequency (ICRF) system, the JET ITER-like antenna (ILA) will be described. The ILA was designed to test the following ITER issues: (a) reliable operation at power densities of order 8 MW/m{sup 2} at voltages up to 45 kV using a close-packed array of straps; (b) powering through ELMs using an internal (in-vacuum) conjugate-T junction; (c) protection from arcing in a conjugate-T configuration, using both existing and novel systems; and (d) resilience to disruption forces. ITER-relevant results have been achieved: operation at high coupled power density; control of the antenna matching elements in the presence of high inter-strap coupling, use of four conjugate-T systems (as would be used in ITER, should a conjugate-T approach be used); operation with RF voltages on the antenna structures up to 42 kV; achievement of ELM tolerance with a conjugate-T configuration by operating at 3{omega} real impedance at the conjugate-T point; and validation of arc detection systems on conjugate-T configurations in ELMy H-mode plasmas. The impact of these results on the predicted performance and design of the ITER antenna will be reviewed. In particular, the implications of the RF coupling measured on JET will be discussed.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Present Status of the ITER-like ICRF Antenna on JET

The commissioning of the ITER-Like ICRF Antenna (ILA) on JET plasmas from May 2008 to April 2009 in various conditions (33, 42 and 47 MHz, L- and H-mode, antenna strap-plasma separatrix distances of {approx}9 to 17 cm) has provided relevant information for future antenna design and operation. The maximum power density achieved was 6.2 MW/m{sup 2} in L-mode with strap to plasma separatrix distance of {approx}9-10 cm at 42 MHz on the lower half of the ILA extrapolating to 8 MW/m{sup 2} if the full generator power had been available. Efficient (trip-free operation) ELM tolerance was obtained both at 33 and 42 MHz on a large range of ELMs with strap voltages up to 42 kV and a maximum power density of 4.1 MW/m{sup 2}. The paper reviews these achievements as well as remaining issues.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

RF Matching Feedback Control Systems on the JET ITER-Like Antenna

Ion Cyclotron Resonance Frequency (ICRF) antennas achieve maximum power transfer from RF generator to plasma load by establishing an impedance match. The JET ITER-Like Antenna (ILA) consists of 4 mutually coupled resonators that need to be matched simultaneously and whose resonant states need to be accurately controlled by several available actuators to couple maximum power and to achieve optimal ELM resilience. The operation of the matching system is described. Experimental operation revealed some phenomena and sensitivities that did not surface from simulation alone and that should be taken into account for the design of future ICRF antennae systems.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Simulating the JET ITER-like Antenna circuit

A set of simulation/interpretation tools based on transmission line theory and on the RF model developed by M. Vrancken has been developed to study the ITER-like Antenna (ILA) at JET. For given tuning element settings, the unique solution of the equations governing the ILA circuit requires solving a system of coupled linear equations relating the voltages and currents at the antenna straps and other key locations. This computation allows cross-checking predicted values against measured experimental ones. Further more, a minimization procedure allows improving the correspondence with the quantities measured in the circuit during shots, thus coping with unavoidable errors arising from uncertainties in the measurements or from inaccuracies in the adopted RF model. Typical applications are e.g. fine-tuning of the second-stage of the ILA circuit for increased ELM-resilience, cross-checking the calibration of the measurements throughout the circuit and predicting the antenna performance and matching conditions in new plasma scenarios.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Operational Experience with the Scattering Matrix Arc Detection System on the JET ITER-Like Antenna

The Scattering Matrix Arc Detection System (SMAD) has been fully deployed on all 4 sets of Resonant Double Loop (RDL), Vacuum Transmission Line (VTL) and Antenna Pressurised Transmission Lines (APTL) of the JET ICRF ITER-Like Antenna (ILA) and this has been indispensable for operating at low (real) T-point impedance values to investigate ELM tolerance. This paper describes the necessity of the SMAD vs VSWR (Voltage Standing Wave Ratio) protection system, SMAD commissioning, problems and a number of typical events detected by the SMAD system during operation on plasma.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Characterisation of the Sub-Harmonic Arc Detection System on JET ITER-Like Antenna

A Sub-Harmonic Arc Detection (SHAD) system has been installed on the transmission lines feeding the JET ICRF ITER-like-Antenna (ILA). Along with the commissioning of SHAD, extensive measurements of the RF field in the transmission lines were carried-out using fast sampling (125 Mb/s) oscilloscopes. The system is described, and the SHAD ability to detect arcs during ILA operation (in particular on ELMy H modes) is discussed. Overall, SHAD proved to be efficient, and in some conditions it can offer extra protection in complement to other arc detection systems.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

LH Power Losses In Front of the JET Launcher

In recent JET experiments, Lower Hybrid (LH) power losses in the Scrape-Off Layer (SOL) were characterized using infra-red (IR) thermography. Hot spots were observed on objects intercepting the field lines passing in front of the LH launcher, i.e. on poloidal limiters and on dumplates located at the top of the tokamak; their locations being in good agreement with magnetic field line tracing using the EFIT equilibrium code. The dumplate temperature was monitored while scanning the launcher position so that the radial distance between field lines intercepting the hot spots and the launcher was increased up to 3.5 cm. The dissipation layer in front of the launcher was estimated to be at least 3.5 cm wide, in agreement with recent measurements on Tore-Supra, but not with simple models that predict a dissipation layer in the mm range.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Recent experiments on alternative dipole phasing with the JET A2 ICRF antennas

Using the JET A2 ICRF antennas, experiments were carried out to assess the performance of three different dipole phasing configurations relevant for the operation of the ICRF antenna in ITER. Three similar discharges with dipole (0{pi}0{pi}), 'symmetric dipole' (0{pi}{pi}0) and 'super dipole' (00{pi}{pi}) phasings were compared. In the 'super dipole' case, higher coupling was confirmed but lower heating efficiency and much stronger plasma wall interaction were observed, as corroborated, respectively, by the analysis of the diamagnetic energy response to the ICRF power steps and by the observation of a considerable temperature rise of the antenna limiters and septa in the 00{pi}{pi} case. These observations were found to be in line with simulations of the ICRF wave absorption and with High Frequency Structure Simulator (HFSS) modelling of the RF fields near the antenna.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Scattering-matrix arc detection on the JET ITER-like ICRH antenna

Operating Ion Cyclotron Resonance Heating (ICRH) antennas at high power density puts them at risk of arcing which reduces the coupled power to the plasma because the perturbed impedance match triggers the Voltage Standing Wave Ratio (VWSR) based generator trip system but even worse might damage the antenna beyond repair because of the the arc s localised energy deposition. New antennas are designed to operate in a load tolerant way which creates low impedance zones that are especially at risk since the existing VSWR protection systems are less sensitive to arcs in these areas. To protect these low impedance areas, a new arc protection system referred as Scattering Matrix Arc Detection (SMAD) was proposed. This paper describes the basic operating principle and implementation in hard- and software for the JET ITER-Like Antenna (ILA), with testbed and preliminary JET commissioning results.

43 PARTICLE ACCELERATORS↗