Search NASA⌕ Search

Engineering topics

Jeanloz, R.

Publications and source records attributed to Jeanloz, R..

31 records · Page 2

Shock effects in olivine and implications for Hugoniot data

New observations of shock deformation in single-crystal olivine are presented for the range in peak pressures from about 16 to 75 GPa. A nonequilibrium model is suggested for the behavior of olivine under shock which explains the densification associated with a mixed-phase region and which is consistent with all available observations, yet which bears little similarity to the equilibrium behavior of olivine at high pressure.

Jeanloz, R.↗

Anorthite - Thermal equation of state to high pressures

New shock-wave data are presented for anorthite from which a full high-temperature, high-pressure equation of state is derived. Whereas anorthite has relatively low values of thermal expansion and Grueneisen parameter at zero pressure, it is found that these attain relatively high values in the high density state corresponding to the high-pressure phase Hugoniot but decrease upon compression as expected. It is noted that higher order anharmonic contributions decrease more rapidly with pressure and that the thermal expansion therefore saturates to a high temperature value at pressures above about 100 GPa. Reduction of the Hugoniot data permits shock temperatures to be calculated; it also yields a principal adiabat for the high pressure branch of the Hugoniot. The initial bulk modulus of this adiabat is essentially identical to that of anorthite, whereas the initial density is about 3.40 Mg/cu m.

Jeanloz, R.↗

Infrared spectra of olivine polymorphs - Alpha, beta phase and spinel

The infrared absorption spectra of several olivines (alpha phase) and their corresponding beta phase (modified spinel) and spinel (gamma) high-pressure polymorphs are determined. Spectra were measured for ground and pressed samples of alpha and gamma A2SiO4, where A = Fe, Ni, Co; alpha and gamma Mg2GeO4; alpha Mg2SiO4; and beta Co2SiO4. The spectra are interpreted in terms of internal, tetrahedral and octagonal, and lattice vibration modes, and the spinel results are used to predict the spectrum of gamma Mg2SiO4. Analysis of spectra obtained from samples of gamma Mg2GeO4 heated to 730 and 1000 C provides evidence that partial inversion could occur in silicate spinels at elevated temperatures and pressures.

Jeanloz, R.↗

Release adiabat measurements on minerals - The effect of viscosity

The paper examines the effect of viscosity in the release adiabat measurements on minerals. The current inversion of pressure-particle velocity data for release from a high-pressure shock state to a pressure-density path usually depends critically upon the assumption that the release process is isentropic. It has been shown that the effective viscosity for geological materials below stresses of 150 GPa must be at least 1000 kg/m/s so that viscous work in the shock state remains small compared to mechanical work recovered upon adiabatic rarefaction. The magnitude of the shear stress in the shock state in minerals and viscosities of engineering materials shocked to pressures below 150 GPa show effective viscosities of about 1000 kg/m/s or less indicating that the conditions for isentropic release of materials from shock states are achieved and that the Riemann integral can be applied to obtain pressure-density states along the release adiabats of minerals.

Jeanloz, R.↗

Convection, composition, and the thermal state of the lower mantle

A thermal model for the lower mantle is presented, which is constructed from the petrologically derived estimates of the temperature in the transition zone and from an adiabat based on the thermal properties of MgO and SiO2 measured at high pressures. Superadiabatic contributions to the geotherm through the lower mantle are negligibly small. A thermal boundary layer is required at the base of the mantle in order to satisfy an estimate of the lowest possible temperature in the core. It is suggested that a thermal boundary layer is associated with a chemical discontinuity either at the top of the lower mantle or near its base.

Jeanloz, R.↗

Release adiabat measurements on minerals: The effect of viscosity

The current inversion of pressure-particle velocity data for release from a high pressure shock state to a pressure-density path is analyzed. It is assumed that the release process is isentropic. It was shown that for geological materials below stresses of 150 GPa, the effective viscosity must be 1000 kg/m/s in order that the viscous (irreversible) work carried out on the material in the shock state remains small compared to the mechanical work recovered upon adiabatic rarefaction. The available data pertaining to the offset of the Rayleigh line from the Hugoniot for minerals, the magnitude of the shear stress in the high pressure shock state for minerals, and the direct measurements of the viscosities of several engineering materials shocked to pressures below 150 GPa yield effective viscosities of 1000 kg/m/s or less. An inferance that this indicates that the conditions for isentropic release of minerals from shock states are achieved, and a conclusion that the application of the Riemann integral to obtain pressure-density states along the release adiabats of minerals in shock experiments is valid are made.

Jeanloz, R.↗

Anorthite: Thermal equation of state to high pressures

The shock wave (Hugoniot) data on single crystal and porous anorthite (CaAl2Si208) to pressures of 120 GPa are presented. These data are inverted to yield high pressure values of the Grueneisen parameter, adiabatic bulk modulus, and coefficient of thermal expansion over a broad range of pressures and temperatures which in turn are used to reduce the raw Hugoniot data and construct an experimentally based, high pressure thermal equation of state for anorthite. The hypothesis that higher order anharmonic contributions to the thermal properties decrease more rapidly upon compression than the lowest order anharmonicities is supported. The properties of anorthite corrected to lower mantle conditions show that although the density of anorthite is comparable to that of the lower most mantle, its bulk modulus is considerably less, hence making enrichment in the mantle implausible except perhaps near its base.

Jeanloz, R.↗

The equation of state of a lunar anorthosite - 60025

High-pressure equation of state data for lunar anorthosite with an initial porosity of about 18% are compared with previous results for nonporous anorthosite and lunar samples. The porous anorthosite is characterized by a lower shock impedance than the nonporous anorthosite; nonporous gabbroic anorthosite and high-titanium mare basalt show higher shock impedances than the nonporous anorthosite. Thus the properties of target rocks may bias crater statistics and apparent cratering ages for different lunar terranes. Repeated meteoritic bombardment of the moon resulting in even mild brecciation and, hence, porosity, could lead to increases in the efficiency with which thermal energy is trapped by the surface upon impact.

Jeanloz, R.↗

Shock-produced olivine glass - First observation

Transmission electron microscope (TEM) observations of an experimentally shock-deformed single crystal of natural peridot, /Mg(0.88)Fe(0.12)/2SiO4, recovered from peak pressures of about 56 billion pascals revealed the presence of amorphous zones located within crystalline regions with a high density of tangled dislocations. This is the first reported observation of olivine glass. The shocked sample exhibits a wide variation in the degree of shock deformation on a small scale, and the glass appears to be intimately associated with the highest density of dislocations. This study suggests that olivine glass may be formed as a result of shock at pressures above about 50 to 55 billion pascals and that further TEM observations of naturally shocked olivines may demonstrate the presence of glass.

Jeanloz, R.↗

Shock compression and adiabatic release of a titaniferous mare basalt

A report is presented regarding the dynamic properties of a rock indigenous to the mare basins of the moon. The reported data were obtained in a study of sample 70215, a very titanium-rich basalt (58% pyroxene, 18% ilmenite, 15% plagioclase, 6% olivine, and 3% quartz by weight). This rock is probably representative of a class of the earliest mare-filling extrusive rocks which are exposed on the present lunar surface. Two series of experiments were performed. One set of experiments involved the measuring of Hugoniot and release adiabats to 15.7 GPa with a propellant gun apparatus. In the second set of experiments, a light-gas gun was employed to yield Hugoniot data at about 120 GPa and release states at about 90 GPa. Lunar basalt 70215 appears to be among the densest rocks in the present lunar sample collection, having a crystal density of 3.38 g/cu cm and a porosity of about 1.3%. The results of the experiments have important implications for both the degree of shock metamorphism expected for impact processes and the extent of ejecta transport on mare surfaces with high-titanium basalt composition.

Ahrens, T. J.↗

Alkali mobility in shocked basalt

An electron microprobe was used to study plagioclase in unshocked and experimentally shocked samples of Vacaville basalt, and unstable microprobe analyses have been reported for shocked chondritic meteorites. It is concluded that there is no selective sodium loss due to the shock process. Sodium mobilization under the electron beam reflects increasingly severe lattice damage for increasing shock pressures

Jeanloz, R.↗

Pyroxenes and olivines: Structural implications of shock-wave data for high pressure phases

The nature of the shock-induced, high-pressure phases of olivine and pyroxene rocks is examined in the light of data for the densities of a new class of perovskite-related silicate structures. Also examined are some new Hugoniot and release adiabat data for bronzite. Reexamining available shock data for magnesian pyroxenes and olivines leads to the conclusion that they define a mixed phase (or disequilibrium) region to about the 100 GPa range, related to the kinetics of phase transformation in these silicates. By recognizing this point, certain discrepancies in previous interpretations of shock data can be explained. A set of theoretical Hugonoits for pyroxene and olivine stoichiometry, perovskite-bearing assemblages was constructed based on their properties deduced from high-pressure work, showing that the shock data is compatible with transformations to perovskites in the 45-7GPa region. Finally, the shock data indicate very similar properties for olivine and pyroxene at high pressures making them both equally likely candidates for the lower mantle.

Jeanloz, R.↗