Search NASA⌕ Search

Engineering topics

Jedediah M Storey

Publications and source records attributed to Jedediah M Storey.

Propellant Mass Gauging in Microgravity with Electrical Capacitance Tomography

Advancements in microgravity propellant mass gauging will result in improvements to many areas of propellant management, which influences space vehicle performance and mission assurance. Propellant mass gauging technologies designed to work in an accelerated environment, where the propellant remains settled at one end of the propellant tank, do not always work well in a microgravity environment because the propellant is not necessarily settled. While some microgravity mass gauging technologies exist at various stages of development, most of them have major disadvantages. Electrical Capacitance Tomography (ECT) is a sensing technology that is able to reconstruct the liquid distribution inside of a tank, which can then be integrated to obtain mass. While ECT mass gauging will theoretically work during all phases of flight, it had not yet been tested in microgravity. The NASA Kennedy Space Center Launch Services Program, with support from the Flight Opportunities Program, successfully tested an ECT liquid mass gauging system experiment on a parabolic flight aircraft in May 2022. Basics of ECT measurement theory, details of the experiment setup, data processing, ground test results, and the flight test result will be discussed. The results suggest that ECT sensor systems will be useful as a propellant mass gauging technology in both accelerated and microgravity environments.

electrical capacitance tomography↗

A CFD Validation Study using Artemis 1 Orbital Slosh Test Data

Advancements in liquid propellant management science and technologies are key to increasing safety, decreasing cost, and increasing payload mass of NASA space missions. Liquid propellant usually comprises a large portion of the total mass of launch vehicles and spacecraft, so predicting and controlling the motion of it are important. Computational fluid dynamics (CFD) programs are critical to predicting slosh dynamics, but CFD programs require experimental validation with physically relevant test data before the results can be trusted. Low-gravity slosh test data is lacking, and most of what exists is inadequate for CFD validation. A potential slosh risk for Orion, and the lack of validated low-gravity slosh models, led to performing on-orbit slosh tests during the Artemis 1 mission to assess the impacts of slosh on the guidance, navigation, and control of Orion. This work details the validation of a coupled slosh-motion CFD model using the Orion orbital slosh test data set.

CFD↗

A Case Study of AI-assisted Creation of a Thermodynamics Model of Precipitation Formation During Rapid Depressurization of a Vented Container

Precipitation may form in humid containers undergoing rapid depressurization. This precipitation may be liquid, i.e. fog, if the dewpoint is crossed above the freezing point of water, or direct snow crystallization if the dewpoint is crossed below the freezing point. Accurate modeling of this effect is potentially important for rapidly ascending vented containers in aircraft, spacecraft, and launch vehicles, as well as rapidly depressurizing vacuum chambers. A transient thermodynamics model of precipitation formation during the rapid depressurization of a container was developed in python. The model is written for a generic container and includes an optional water pool and water vapor source. Details of the model and results from several example cases spanning the full capabilities of the model, including a validation case, will be presented. Although the model is not novel, in contrast to prior works, this one was treated as a case study of the assistance of AI Large Language Models (LLMs) to create physical models. Impressions, performance, time, and cost of using AI for this task will be discussed.

precipitation↗