Engineering topics

Jenna L Eppink

Publications and source records attributed to Jenna L Eppink.

6 records

NASA NTRSDate not supplied

High-Frequency Secondary Instabilities Downstream of a Forward-Facing Step

Localized high-frequency velocity fluctuations were measured downstream of a forward-facing step on a 30◦swept flat plate with an imposed pressure gradient. Phase-locked time-resolved particle image velocimetry measurements were performed to determine the source of the fluctuations, which ultimately lead to transition. The steps result in localized regions of reversed flow for a short region downstream of the step. These regions are highly localized due to the impact of the stationary crossflow vortices. The velocity fluctuations typically increase significantly in amplitude shortly downstream of reattachment in these localized regions, indicating that the fluctuations are related to reattachment of the shear layer. The phase-averaged measurements confirm that the unsteadiness in the shear layer results in the shedding of a plethora of vortices, some oriented in the streamwise direction, and others in the spanwise direction. These vortices are impacted by the local properties of the mean flow, such as streamwise vorticity and streamwise velocity gradient. The origin of the unsteadiness in the shear layer is not definitively shown, but evidence suggests it is due to a shear-layer instability. Ultimately, the unsteadiness of the shear layer, and the vortices that are shed as a result of this unsteadiness, are responsible for transition in this scenario.

Jenna L Eppink↗

NASA NTRSDate not supplied

Effects of Step Shape on Transition over a Swept Backward-Facing Step

The effect of backward-facing step shape on stationary-crossflow growth was studied down-stream of a two-dimensional step in a swept-wing flow. The step height was set at 76% of the local unperturbed boundary-layer thickness at the step location, and the shape was varied by placing three ramps of differing slopes and shapes on the downstream face of the step, including a 30◦ramp, rounded ramp, and a 5◦ramp. In addition, the square step shape (with noramp) was studied. The 5◦ramp was the only one that was successful at substantially delaying transition downstream of the step. Even so, it did not completely mitigate the effect of the step. The 5◦ramp significantly altered the mean flow, significantly reducing the separation region downstream of the step. While this geometry still resulted in increased growth of the stationary crossflow instability, it substantially reduced the amplitude of the unsteady instabilities that grew downstream of the step. In particular, this ramp completely eliminated the low-frequency, traveling crossflow mode that was observed in the other cases.

Jenna L Eppink↗

NASA NTRSDate not supplied

Stability Analysis of the Flow over a Swept Forward-Facing Step using PIV Base Flowsin a Non-Orthogonal Coordinate System

Understanding the flow of a crossflow-vortex-dominated boundary layer over a forward-facing step excrescence is necessary in order to mitigate an early transition scenario on the wings and tail of commercial aircraft. By performing BiGlobal stability analysis on the flowfield measured with high-resolution, stereographic Particle Image Velocimetry (PIV), previous work has shown that a family of unstable disturbances exists in the direct downstream vicinity of a supercritical, forward-facing step. The goal of the present paper is to improve the previously used stability approach on two fronts: 1) the stability problem is formulated in a non-orthogonal coordinate system and 2) the contribution of the out-of-plane base-flow derivatives is accounted for locally. The resulting eigen solutions feature significantly stronger growth rates and eigenfunctions that are localized above regions of reverse flow. The changes in the problem formulation furthermore establish a significant improvement in the comparison of the stability solutions with the results from the Spectral Proper Orthogonal Decomposition (SPOD) of a time-resolved measurement of the perturbation content. A large destabilizing effect by the out-of-plane base-flow derivatives is determined to be justified, despite the assumption that these derivatives are small, because the effect can be reconstructed upon using an eigenvalue-correction formula that assumes the responsible terms are infinitesimally small. The unstable perturbation mechanisms are demonstrated to have a convective nature by assessing the relation between the frequency and the out-of-plane wavenumber, which indicates that their group speed does not approach zero. The last 2 facts, that 1) the perturbations are convective and 2) that the out-of-plane base-flow-derivative terms are small, remove any qualitative suspicions that the perturbation problem is not conducive to parabolization. This opens the path to analyzing this problem with a plane-marching approach.

Boundary- Layer Transition↗

NASA NTRSDate not supplied

Three-Dimensional Instantaneous Flow-field Reconstruction Using Planar Spectral Proper Orthogonal Decomposition

A novel method for three-dimensional flowfield reconstruction is presented that utilizes spectral proper orthogonal decomposition (SPOD). The time-resolved PIV data are acquired in multiple two-dimensional spanwise planes, with adequate streamwise spacing to resolve the out-of-plane wavelength. Knowledge of the out-of-plane phase speed is also required, and for the present case this value was obtained using instantaneous hot-wire measurements. The method is validated by comparing phase-averaged results acquired with a forcing signal to the SPOD reconstructed results using the same data. The method is also applied to data with no forcing applied, and the results are shown to be similar to the forced case. This method is particularly useful for cases in which there are multiple frequencies of interest, or cases in which the phenomena occur over a broad range of frequencies. This method allows reconstruction of the frequencies of interest without the need for a forcing signal, so the flow can be studied in its natural (undisturbed) state.

boundary-layer transition↗

NASA NTRSDate not supplied

Effects of Random Micron-Sized Roughness on Swept-Wing Transition

This study examines the effect of random micron-sized distributed roughness on stationary crossflow instabilities. The roughness parameters are varied by creating nanoparticle coatings of various formulations and applying them to inserts that cover approximately the first 14% of the model. In addition to the baseline configuration (no added roughness, root-mean-square (RMS) ≈ 0.42 𝜇m), panels with RMS roughness values of 4.8 and 8.6 𝜇m were tested, with correlation lengths of 1029 and 385 𝜇m, respectively. Despite the significant roughness levels tested, the transition location was found to be only mildly impacted by the additional roughness, and the roughness panel with lower RMS amplitude caused a larger upstream movement of transition, on average. However, the stationary crossflow amplitudes and wavelength content were found to vary substantially depending on the roughness input. In particular, the panel with higher RMS roughness amplitude resulted in significantly larger amplitudes in the 7.5-9 mm wavelength range at the farthest upstream measurement station, while the lower roughness panel resulted in mildly larger amplitudes at 10 mm and wavelengths larger than 15 mm. Nonlinear Parabolized Stability Equations (PSE) computations were performed to attempt to estimate the initial amplitudes of the stationary crossflow instabilities. Wavelength spectra were matched at the most upstream measurement location, but large discrepancies exist between the predicted and measured growth behavior farther downstream, thus, more work is required to improve confidence in initial amplitude estimates.

boundary-layer transition↗

NASA NTRSDate not supplied

Transition Measurements on the SWiFT Model in the National Transonic Facility

Boundary layer transition locations on the Swept Wing Flow Test (SWiFT) Hybrid Wing Body model were measured in the National Transonic Facility (NTF) at the NASA Langley Research Center using several different methods. These methods include sublimating chemical flow visualization for a limited number of low Reynolds number conditions, as well as mean static pressure and dynamic pressure measurements. Results are presented for a range of conditions in the NTF, demonstrating Mach and Reynolds number effects. The transition front locations obtained from the different techniques agree well. A variation of the static pressure transition detection method is described in which continuous angle of attack polars are performed. This approach enables detection of the transition front at more challenging (high Reynolds number) conditions than is possible with sparser data from pitch-pause angle-of-attack polars. The trip dot effectiveness is also verified using all of the available diagnostics. Additionally, low Reynolds number results are compared with those acquired on the same model at the Aircraft Research Association (ARA) facility, and these results show good agreement overall, suggesting similar freestream flow quality conditions of the two facilities.

National Transonic Facility↗