Quantitative analysis of EXAFS data sets using deep reinforcement learning
Not provided.
Engineering topics
Publications and source records attributed to Jeong, Eun-Suk.
Not provided.
The orientation-dependent local structural properties of CoO films on sapphire substrates during growth were investigated through linearly-polarized extended X-ray absorption fine structure (EXAFS) measurements. Specifically, CoO(1 1 1) and (100) crystals with a rock-salt structure (Fm3m) were epitaxially grown on alpha-Al2O3(0001) and (1012) substrates, respectively, at 700 degrees C using a radio-frequency sputtering system. The local structural properties of CoO films in the in-plane and out-of-plane orientations were quantitatively determined using linearly-polarized EXAFS at the Co K-edge during growth. The EXAFS analysis revealed that during the initial stages of growth, the local structural properties exhibit significant differences compared to thick films, with short atomic distances and large (small) Debye-Waller factors observed in the out-of-plane (in-plane) orientations. The local structural strain mostly diminished when approximately 20 CoO layers accumulated on the substrate. Density functional theory (DFT) calculations further supported these findings by confirming that cobalt atoms initially form stable bonds with the sapphire surface, leading to the simultaneous growth of oxygen and cobalt layers in a coordinated manner through layer-by-layer growth.
Not Available
The heterogeneous catalysts of Pt/transition-metal oxides are typically synthesized through calcination at 500 °C, and Pt nanoparticles are uniformly and highly dispersed when hydrogen peroxide (H 2 O 2 ) is applied before calcination. The influence of H 2 O 2 on the dispersion and the stability of Pt nanoparticles on titania-incorporated fumed silica (Pt/Ti–FS) supports was examined using X-ray absorption fine structure (XAFS) measurements at the Pt L 3 and Ti K edges as well as density functional theory (DFT) calculations. The local structural and chemical properties around Pt and Ti atoms of Pt/Ti–FS with and without H 2 O 2 treatment were monitored using in-situ XAFS during heating from room temperature to 500 °C. XAFS revealed that the Pt nanoparticles of H 2 O 2 -Pt/Ti–FS are highly stable and that the Ti atoms of H 2 O 2 -Pt/Ti–FS support form into a distorted-anatase TiO 2 . DFT calculations showed that Pt atoms bond more stably to oxidized–TiO 2 surfaces than they do to bare- and reduced–TiO 2 surfaces. XAFS measurements and DFT calculations clarified that the presence of extra oxygen atoms due to the H 2 O 2 treatment plays a critical role in the strong bonding of Pt atoms to TiO 2 surfaces.