Engineering topics

Jeong, Shin Young

Publications and source records attributed to Jeong, Shin Young.

4 records

DOE OSTI2024

System and Component Development of Particle-Based Pumped Thermal Energy Storage

Reliable power supply from variable renewable resources requires energy storage at various scales to overcome resource intermittency. Long-duration energy storage (LDES, 10-100 hours) can improve dispatchability and grid reliability with increasing levels of renewable power supply. Thermal energy storage (TES) has siting flexibility and the ability to store a large capacity of energy, and thus has the potential to meet the LDES need and provide charging and discharging durations beyond the economic capacity of conventional batteries. TES technology has evolved from concentrating solar thermal power (CSP) generation and is recognized as an economic large-scale energy storage method. A standalone electric-thermal energy storage system supporting renewable integration of wind and solar power without CSP solar field can firm renewable generation and boost overall grid resilience and security.

concentrating solar thermal power↗

DOE OSTI2022

Experimental characterization of extreme temperature granular flows for solar thermal energy transport and storage

High-temperature, dense granular flows along an inclined plane were considered for solar thermal energy transport and storage with sintered bauxite particles. A series of experiments was performed for particle inlet temperatures of ~ 200, 400, 600, and 800 °C to understand the mechanisms of granular flows at extreme temperatures. Mass flow rates were measured using a load cell and free-surface velocities were measured and computed using particle image velocimetry. Surface temperatures were measured using infrared cameras. A significant decrease in steady-state particle mass flow rate was observed with increasing temperature due to changing flow properties. A decrease in bulk particle free-surface velocities was observed at higher temperatures. Free-surface velocity measurement error between experiments were within 20% of the average. The particle surface temperatures decreased from inlet to outlet with larger gradients at higher temperatures observed due to increasing convection and radiative heat losses. Here, a decrease in temperature was observed along the side walls due to a decrease in particle velocities.

14 SOLAR ENERGY↗

DOE OSTI2022

Advanced Characterization of Particulate Flows for Concentrating Solar Power Applications

The overarching goal of this project was to gain a greater fundamental understanding of heat and mass transfer in particulate-media in concentrated solar power (CSP) applications for thermal energy storage (TES) and to disseminate results to support parallel Gen3 research initiatives. Project objectives were achieved through three planned project phases to systematically characterize the heat transfer and flow properties for particulate (granular) flows at elevated temperatures up to 800 °C. These objectives were accomplished using a combination of fundamental experimental measurements, modeling, and simplified flow experiments over a range of temperatures. This work addressed a serious gap within the field related to the understanding and modeling of granular flow behavior and the related heat transfer at different temperatures, which directly correspond to the operating points of CSP applications which use particles for heat storage.

14 SOLAR ENERGY↗

DOE OSTI2021

Measurements of scattering and absorption properties of submillimeter bauxite and silica particles

Submillimeter solid particles have been considered as thermal storage media for concentrated solar power applications. Knowledge of the scattering and absorption properties of individual particles is crucial for modeling the radiative heat transfer of the particle bed. In this work, a laser scatterometer is used to measure the single-particle scattering properties at a wavelength of 635 nm by using two configurations: (1) a falling particle curtain and (2) a taped particle layer. Because a one-particle nominal thickness is formed with area fractions of 5-55% depending on the configuration, multiple scattering is minimized and hence the single scattering phase function, averaged over all illuminated particles, is directly measured. Bauxite-based ceramic particles that are strongly absorbing in the solar spectrum and silica particles that are nonabsorbing in the visible and near-infrared are investigated. The directional-hemispherical reflectance and transmittance of the taped particles are also measured to deduce the forward and backward scattering efficiency factors and the absorption efficiency factors. Only weak wavelength dependence is observed in the measured region from 380 nm to 1020 nm. Furthermore, the scattering phase functions of all bauxite-based particles with varying sizes and compositions are very similar and can be fitted to a Henyey-Greenstein phase function with an asymmetry factor g = -0.20. For the silica particles, forward scattering dominates and g = 0.45 yields the best fit. A Monte Carlo method is developed to model the particle scattering characteristics, and reasonable agreements between the modeling and experimental results are observed by introducing a specularity parameter.

42 ENGINEERING↗