Search NASA⌕ Search

Engineering topics

Jernell, L. S.

Publications and source records attributed to Jernell, L. S..

17 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1980

Performance estimates of a Boeing 747-100 transport mated with an outsize cargo pod

The design mission performance of a Boeing 747-100 aircraft mated with an outsize cargo pod was studied. The basic design requirement was the rapid deployment of a combat loaded mobile bridge launcher from a United States east coast staging base to Europe. Weight was minimized by stripping the aircraft of unneeded, quick removal items and by utilizing graphite-epoxy composite materials for most pod components. The mission analysis was based on wind tunnel data and full scale carrier aircraft and engine data. The results are presented in tabular and graphic form.

Jernell, L. S.↗
NASA NTRS1979

Effects of a military cargo pod and tail fins on the aerodynamic characteristics of a large wide-body transport model

Wind tunnel tests were conducted on a 0.03 scale model of a large wide-body commercial aircraft to determine the effects on the static aerodynamic characteristics resulting from the attachment of a belly pod for the long-range deployment of outsize military equipment. The effectiveness of horizontal-tip fins in augmenting directional stability was investigated. At a test Reynolds number of 1.08 x 1,000,000, the addition of the pod results in an increase in total drag of approximately 20 percent. Trim drag due to the pod is very small. Although the pod produces a significant decrease in directional stability, the addition of the tip fins restores some of the stability, particularly at the lower angles of attack.

Jernell, L. S.↗
NASA NTRS1978

Effects of laminar flow control on the performance of a large span-distributed-load flying-wing cargo airplane concept

The effects of laminar flow control (LFC) on the performance of a large span-distributed-load flying-wing cargo airplane concept having a design payload of 2.669 MN and range of 5.93 Mm were determined. Two configurations were considered. One employed laminarized flow over the entire surfaces of the wing and vertical tails, with the exception of the estimated areas of interference due to the fuselage and engines. The other case differed only in that laminar flow was not applied to the flaps, elevons, spoilers, or rudders. The two cases are referred to as the 100 percent and 80 percent laminar configurations, respectively. The utilization of laminar flow control results in reductions in the standard day, sea level installed maximum static thrust per engine from 240 kN for the non-LFC configuration to 205 kN for the 100 percent laminar configuration and 209 kN for the 80 percent case. Weight increases due to the LFC systems cause increases in the operating empty weights of approximately 3 to 4 percent. The design takeoff gross weights decrease approximately 3 to 5 percent. The FAR-25 takeoff field distances for the LFC configurations are greater by about 6 to 7 percent. Fuel efficiencies for the respective configurations are increased 33 percent and 23 percent.

Jernell, L. S.↗
NASA NTRS1978

Preliminary study of a large span-distributed-load flying-wing cargo airplane concept

An aircraft capable of transporting containerized cargo over intercontinental distances is analyzed. The specifications for payload weight, density, and dimensions in essence configure the wing and establish unusually low values of wing loading and aspect ratio. The structural weight comprises only about 18 percent of the design maximum gross weight. Although the geometric aspect ratio is 4.53, the winglet effect of the wing-tip-mounted vertical tails, increase the effective aspect ratio to approximately 7.9. Sufficient control power to handle the large rolling moment of inertia dictates a relatively high minimum approach velocity of 315 km/hr (170 knots). The airplane has acceptable spiral, Dutch roll, and roll-damping modes. A hardened stability augmentation system is required. The most significant noise source is that of the airframe. However, for both take-off and approach, the levels are below the FAR-36 limit of 108 db. The design mission fuel efficiency is approximately 50 percent greater than that of the most advanced, currently operational, large freighter aircraft. The direct operating cost is significantly lower than that of current freighters, the advantage increasing as fuel price increases.

Jernell, L. S.↗
NASA NTRS1977

Design of a Large Span-Distributed Load Flying-Wing Cargo Airplane

The design and operation of very large, long-range, subsonic cargo aircraft are considered. A design concept which distributes the payload along the wingspan to counterbalance the aerodynamic loads, with a resultant decrease in the in-flight wing bending moments and shear forces, is described. The decreased loading of the wing structure, coupled with the very thick wing housing the cargo, results in a relatively low overall structural weight in comparison to that of conventional aircraft.

Jernell, L. S.↗
NASA NTRS1976

Development of two supercritical airfoils with a thickness-to-chord ratio of 0.20 and design lift coefficients of 0.3 and 0.4

Two supercritical airfoils were developed specifically for application to span distributed loading cargo aircraft. These airfoils have a thickness-to-chord ratio of 0.20 and design lift coefficients of 0.3 and 0.4, and were derived by modifying a recently developed supercritical airfoil having a thickness-to-chord ratio of 0.18 and a design lift coefficient of 0.5. The aerodynamic characteristics were calculated using a theoretical method which computes the flow field about an airfoil having supercritical surface velocities.

Jernell, L. S.↗
NASA NTRS1974

Stability and control characteristics of a monoplane missile with large delta wings and various tail controls at Mach 1.90 to 2.86

Wind tunnel tests were conducted to determine the stability and control characteristics of a monoplane missile with large delta wings and various tail configurations. The tests were conducted at angles of attack of approximately 24 degrees and angles of sideslip of about 22 degrees. Tail control configurations were the cruciform, conventional airplane type, and an inverted airplane configuration. Control effectiveness was measured for pitch, yaw, and roll.

Jernell, L. S.↗
NASA NTRS1974

Comparisons of two-dimensional shock-expansion theory with experimental aerodynamic data for delta-planform wings at high supersonic speeds

An investigation has been conducted to explore the potential for optimizing airfoil shape at high supersonic speeds by utilizing the two-dimensional shock-expansion method. Theoretical and experimental force and moment coefficients are compared for four delta-planform semispan wings having a leading-edge sweep angle of 65 deg and incorporating modified diamond airfoils with a thickness-chord ratio of 0.06. The wings differ only in airfoil maximum-thickness position and camber. The experimental data are obtained at Mach numbers of 3.95 and 4.63 and at a Reynolds number of 9.84 million per meter. A relatively simple method is developed for predicting, in terms of lift-drag ratio, the optimum modified diamond airfoil at high supersonic and hypersonic speeds.

Jernell, L. S.↗
NASA NTRS1970

Effects of Nose Bluntness on Aerodynamic Characteristics of Cruciform-Finned Missile Configuration at Mach 1.50 to 2.86

An investigation has been conducted in the Langley Unitary Plan wind tunnel to determine the effects of spherical nose bluntness on the aerodynamic characteristics of a typical cruciform-finned short-range missile configuration for roll angles of 0 deg and 45 deg and Mach numbers from 1.50 to 2.86. Also investigated was the effectiveness of a forward protruding nose spike in reducing the axial-force coefficient of a blunt-nose configuration. The results indicated that the effects of nose bluntness and nose spike on the longitudinal stability were small. For roll angles of both 0 deg and 45 deg, the greatest effects of nose bluntness on the aerodynamic-center location near zero angle of attack occurred at a Mach number of 2.86, where for each roll position, a rearward shift of approximately 3.5 percent of the body length occurred as bluntness was increased. Although large magnitudes of nose bluntness were accompanied by high axial-force coefficients, significant reductions in the axial-force coefficient of a blunt-nose configuration were achieved with the use of the nose spike. There were no noteworthy effects of nose bluntness on either the directional stability or side-force parameters. However, for high angles of attack at a Mach number of 1.50 increased nose bluntness generally resulted in decreased effective dihedral.

Jernell, L. S.↗