Search NASA⌕ Search

Engineering topics

Ji, Yichen

Publications and source records attributed to Ji, Yichen.

9 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2022

Site and Structural Requirements for the Dehydra-Decyclization of Cyclic Ethers on ZrO2

In this study, we examined the site and structural requirements for the dehydra-decyclization of cyclic ethers, tetrahydrofuran, and tetrahydropyran to produce conjugated dienes over ZrO2-based catalysts, a reaction that could be an important step in the use of biomass-derived sugars as a starting material to produce monomers for the plastics industry. To help identify the active sites for this reaction, studies were conducted in which ZrO2 surfaces were decorated with Na. These studies showed that Na was effective at poisoning the activity for the ring opening of cyclic ethers, but much less so for the dehydration of the resulting adsorbed alkoxides. The studies of the activity of different types of ZrO2 for the dehydra-decyclization reaction, including single crystals and ultra-thin films supported on MgAl2O4 and silica, also showed that the reaction was dependent on the local structure of the ZrO2 surface. The insights these results provide for identifying the active sites on the ZrO2 surface are discussed.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2022

Selective dehydra-decyclization of cyclic ethers to conjugated dienes over zirconia

ZrO 2 provides high selectivity (>90%) to conjugated pentadienes through the dehydra-decyclization of C-5 cyclic ethers, even at high conversions. 1,3-Pentadiene was the major product in both reaction of 2-methyltetrahydrofuran and tetrahydropyran over ZrO 2 . The reaction of 3-methyltetrahydrofuran produced nearly stoichiometric amounts of isoprene. Other catalysts, including TiO 2 , γ-Al 2 O 3 , and H-ZSM-5, were generally much less selective and produced a mixture of diene isomers. A combination of TPD and steady-state measurements revealed that both piperylenes are exclusively produced through primary catalytic pathways from 2-methyltetrahydrofuran, avoiding any isomerization once formed. First-principle calculations on ZrO 2 imply the presence of an energetically favored, surface isomerization of ring-opened intermediates to conjugated alkenolates that selectively dehydrate to conjugated dienes, providing high selectivity to the desired products. Finally, the stabilization of the conjugated alkenolate is key for understanding the ability of ZrO 2 to selectively produce conjugated dienes from cyclic ethers, without the need for the thermo-limited diene isomerization.

1,3 -pentadiene↗
DOE OSTI2020

RFA Measurement of E-Cloud Generation Process at Fermilab Main Injector

Fermilab aims to provide greater beam power for the neutrino physics program. As the beam power increases, the unwanted production of secondary electrons in the beam pipe, known as ‘electron cloud’ or ‘E-cloud’ may become disruptive to high intensity operation. Instrumentation has been deployed in the Fermilab Main Injector (MI) to study E-cloud. One of these is a Retard Field Analyzer (RFA) that can be used to directly measure E-cloud generation at the location of the instrument. Studies of the dependence of E-cloud on beam intensity and bunch length have been carried out. The experimental results are compared to POSINST simulations. These simulations are guided by measurements from a Secondary Electron Yield (SEY) test stand installed in the MI to measure the SEY of materials such as the beam pipe stainless steel. The SEY has a strong influence on the E-cloud density. Results of these comprehensive studies comparing the RFA data with realistic MI simulations will be presented.

43 PARTICLE ACCELERATORS↗
DOE OSTI2020

Investigation of Rh–titanate (ATiO 3 ) interactions on high-surface-area perovskite thin films prepared by atomic layer deposition

Thin, ~1 nm films of CaTiO 3 , SrTiO 3 , and BaTiO 3 were deposited onto MgAl 2 O 4 by Atomic Layer Deposition (ALD) and studied as catalyst supports for Rh. Scanning Transmission Electron Microcopy (STEM) and X-Ray Diffraction (XRD) demonstrated that the films had the perovskite structure and formed uniform coatings stable up to 1073 K. Rh, added by ALD, interacted strongly with CaTiO 3 and somewhat less strongly with SrTiO 3 , while Rh on BaTiO 3 was similar to Rh on unmodified MgAl 2 O 4 . STEM measurements of Rh on CaTiO 3 films showed Rh remained well dispersed after repeated oxidations and reductions at 1073 K; however, the Rh was inactive for CO-oxidation. Rh formed small particles on SrTiO 3 films and was active for CO oxidation after reduction at 1073 K. The reducibility and catalytic activity of Rh/BaTiO 3 /MgAl 2 O 4 were similar to that of Rh/MgAl 2 O 4 . Evidence from CO-TPR, FTIR, and XPS all indicated that the degree of interaction between Rh and the three perovskite films can be ranked in the following order: Rh/CaTiO 3 /MgAl 2 O 4 > Rh/SrTiO 3 /MgAl 2 O 4 > Rh/BaTiO 3 /MgAl 2 O 4 . Here, bulk ex-solution catalysts, synthesized by reduction of ATi 0.98 Rh 0.02 O 3 (A = Ca, Sr, and Ba), were also examined for comparison.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2020

Dehydra-decyclization of tetrahydrofurans to diene monomers over metal oxides

The dehydra-decyclization of tetrahydrofuran (THF) to butadiene was investigated over a series of metal oxide catalysts, where a common set of chemical pathways was identified. Alongside butadiene, propene is formed via a retro-Prins condensation as the main side product typically observed. Reaction occurred at similar temperatures on each of the oxides, but tetragonal zirconia (t-ZrO 2 ) and monoclinic zirconia (m-ZrO 2 ) were unique in showing high selectivity to butadiene (>90%). Near quantitative yields to butadiene could be achieved over t-ZrO 2 at 673 K and a WHSV of 0.93 g THF gcat –1 h –1 . Through contact time studies, butadiene is determined to be a primary product. Methyl-substituted THF gave only moderate increases in rates and the products showed minimal isomerization of the carbon backbone. The t-ZrO 2 catalyst was found to be relatively stable with time on stream, experiencing coking as a likely source of deactivation. Complete regeneration of the catalyst was demonstrated through calcination alone, allowing for multiple regenerations with no irreversible loss in activity or selectivity. Lastly, the catalytic activity of zirconia was found to be structure insensitive, with t-ZrO 2 and m-ZrO 2 exhibiting similar initial activities; however, m-ZrO 2 was observed to deactivate much more rapidly.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2020

Atomic Layer Deposition for Preparing Isolated Co Sites on SiO 2 for Ethane Dehydrogenation Catalysis

Unlike Co clusters, isolated Co atoms have been shown to be selective for catalytic dehydrogenation of ethane to ethylene; however, preparation of isolated Co sites requires special preparation procedures. Here, we demonstrate that Atomic Layer Deposition (ALD) of tris(2,2,6,6-tetramethyl-3,5-heptanedionato)cobalt(III) (Co(TMHD) 3 ) on silica and other supports is effective in producing these isolated species. Silica-supported catalysts prepared with one ALD cycle showed ethylene selectivities greater than 96% at 923 K and were stable when CO 2 was co-fed with the ethane. Co catalysts prepared by impregnation formed clusters that were significantly less active, selective, and stable. Rates and selectivities also decreased for catalysts with multiple ALD cycles. Isolated Co catalysts prepared on Al 2 O 3 and MgAl 2 O 4 showed reasonable selectivity for ethane dehydrogenation but were not as effective as their silica counterpart.

36 MATERIALS SCIENCE↗