Search NASA⌕ Search

Engineering topics

Jian, Xiang

Publications and source records attributed to Jian, Xiang.

6 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

The role of ion-scale micro-turbulence in pedestal width of the DIII-D wide-pedestal QH mode

The low-edge rotation, intrinsically ELM-free, and improved confinement wide-pedestal quiescent H-mode (QH-mode), discovered in DIII-D tokamak, has pedestal widths exceeding the EPED-kinetic-ballooning mode (KBM) model scaling typically by at least 25%. Ion-scale ($k_yp_s$ < 1) microturbulence and its role in setting the pedestal structure is investigated using the radially local δ$f$ gyrokinetic code CGYRO. The electromagnetic trapped electron mode (TEM) is unstable at the pedestal top, while plasma beta (β$_e$) is ∼60% below the KBM onset threshold and the electron temperature gradient mode is found to be unstable in the peak gradient region. Nonlinear simulation reveals that the ion-scale turbulence could produce electron energy flux consistent with the flux inferred from power balance at the pedestal top, with a reasonable variation of the local shearing rate; and the local neoclassical transport from NEO is dominant over the simulated turbulent transport in the ion energy flux channel. The simulated ion-scale turbulence produces much lower electron energy flux than inferred from experiment in the pedestal peak gradient region. A correction to the EPED-KBM pedestal width scaling is obtained based on the two-dimensional scan of pedestal top plasma beta (β$_e$) and normalized electron density and temperature scale lengths,${a}$/${L_n}_e$, ${a}$/${L_T}_n$using CGYRO linear simulations. Mode transitions among TEM, micro-tearing mode, ion-temperature gradient mode and KBM, are observed in the 2D scan at the pedestal top. A fixed normalized growth rate for these drift-type modes is taken to determine the pedestal width scaling, which shows good consistency with the QH experimental database on pedestal heights and widths. The onset of KBM instabilities and the local E × B shear suppression criterion set the lower and upper limit for the pedestal width of standard QH-mode, wide-pedestal QH-mode and type-I ELMy H mode. A potentially higher and wider pedestal is expected from the new scaling of pedestal width. This work presents an improved understanding of the ion-scale micro-turbulence of wide-pedestal QH-mode and sheds light on a promising scenario for future reactors, including ITER and beyond.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2024

Inter-ELM pedestal turbulence dynamics dependence on q 95 and temperature gradient

A series of dedicated experiments from DIII-D tokamak provide spatially and temporally resolved measurements of electron density and temperature, and multiscale and multichannel fluctuations over a wide range of conditions. Measurements of long wavelength density fluctuations in the type-I ELMing H-mode pedestal routinely revealed a coexistence of multiple instabilities that exhibit dramatic different dynamic behaviors as q 95 and temperature gradient are varied, apparently responsible for limiting pedestal temperature profiles. Two distinct frequency bands of density fluctuations are modulated with ELM cycle with frequency above 200kHz propagating in the electron diamagnetic direction in the lab frame (electron mode) and below 200kHz propagating in the ion diamagnetic direction (ion mode). The electron mode amplitude peaks near the electron temperature gradient region and increases with q 95 which seems to be correlated with the increased χ e at higher q 95 , similar to the characteristics expected for Micro-tearing Mode (MTM). At higher q 95 , during the inter-ELM period, the ion mode decays at later phase of the ELM cycle. Consistently, the poloidal correlation length of the ion mode is also found to reduce which suggests the possible E×B flow shear suppression of ion mode at later phase of the ELM cycle as the Er well recovers. In contrast, the electron mode grows during the ELM cycle and reaches saturation at around 50-60% of ELM period. Linear gyrokinetic simulations find the MTMs as the most unstable mode in the pedestal electron temperature gradient region. The higher q 95 and lower magnetic shear destabilize MTMs. These observations provide key insights of the underlying physics of multifield properties and rich dataset of experimental 'fingerprints' that enable new tests of the theoretical pedestal models and lead to developing a predictive model for pedestal formation on ITER and future burning plasma experiments.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2022

Deconvolving the roles of E × B shear and pedestal structure in the energy confinement quality of super H-mode experiements

Analysis of “super H-mode” experiments on DIII-D has put forward that high plasma toroidal rotation, not high pedestal, plays the essential role in achieving energy confinement quality H 98y2 >>1. Recently, super H-mode experiments with variable input torque have confirmed that high rotation shear discharges have very high levels of H 98y2 (>1.5), independent of the pedestal height, and that high pedestal discharges with low rotation shear have levels of H 98y2 only slightly above 1 (≤1.2). Although some increase in stored energy with higher pedestal occurs, the energy confinement quality mainly depends on the toroidal rotation shear, which varies according to different levels of injected neutral beam torque per particle. Here, quasi-linear gyrofluid modeling achieves a good match of the experiment when including the E×B shear; without including plasma rotation, the modeling predicts a confinement quality consistent with the empirical observation of H 98y2 ~1.2 at low rotation. Nonlinear gyrokinetic transport modeling shows that the effect of E×B turbulence stabilization is far larger than other mechanisms, such as the so-called hot-ion stabilization (T i /T e ) effect. Consistent with these experimental and modeling results are previous simulations of the ITER Baseline Scenario using a super H-mode pedestal solution, which showed the potential to exceed the Q=10 target if the pedestal density could be increased above the Greenwald limit. A close look at these simulations reveals that the predicted energy confinement quality is below 1 even at the highest pedestal pressure. The improvement in Q at higher pedestal density is due to the improved fusion power generation at the higher core density associated with higher pedestal density, not to an improved energy confinement quality.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2021

Edge localized mode characteristics and divertor heat flux during stationary and transient phase for CFETR hybrid scenario

The study of edge localized mode (ELM) behavior, stationary heat flux and transient heat flux during the ELM crash phase is performed for a China Fusion Engineering Test Reactor (CFETR) 1 GW hybrid mode operation scenario ($R$ = 7.2 m, ${B_{\text{T}}}$ = 6.5 T, ${I_{\text{p}}}$ = 13.78 MA). Modeling and simulation start with a scenario obtained by multi-code integrated modeling on the one modeling framework for integrated tasks framework. Linear stability and nonlinear simulations of ELM dynamics are carried out using the BOUT++ six-field reduced magnetohydrodynamic module, which show a much smaller ELM energy loss (Δ ELM ~ 0.13%) compared to that of a Type-I ELM. Parametric analysis of the weak linear growth rate and small ELM energy loss characteristics shed light on physics corresponding to a grassy ELM regime for CFETR 1 GW hybrid scenario. The transient heat flux on the divertor target during this small ELM phase is investigated using BOUT++. Here we found that upstream radial transport in the scrape-off-layer (SOL) induced by small ELMs is weak, which keeps it in the drift-dominated region. However, the heat flux width is still broadened to ${\lambda _{\text{q}}}$ = 4.64 mm by the increase of separatrix temperature during ELM nonlinear evolution. The impact of transient peak heat load and ELM energy fluence on tungsten melting and net erosion rate of divertor target is evaluated for the first-time using physics-based transport that connects the pedestal with the SOL. Energy fluence caused by a single ELM pulse is below the tungsten melting limit, while tungsten erosion would exceed the material requirements. We conclude that external mitigation methods, such as divertor detachment and advanced divertor geometry are likely needed for the steady state operation of CFETR.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2020

Achieving a robust grassy-ELM operation regime in CFETR

We have identified a robust grassy-edge localized mode (ELM) operation regime for future tokamak reactors. The regime exists within a pedestal top electron collisionality (ν*) window at high global poloidal beta (β p ). The existence of an upper ν* limit for grassy-ELMs is consistent with results previously reported in experiments (Oyama et al 2010 Nucl. Fusion 50 064014), while the existence of a lower ν* limit has not been reported previously. Using EPED and BOUT++, a theoretical model that quantitatively explains the physics of the grassy-ELMs within the window, which distinguishes them from the small mixed-ELMs at lower ν*, is presented for the first time. A peeling-ballooning stability boundary is obtained by scanning the operating density space. The change in density corresponds to a change in ν* that affects the pedestal bootstrap current. High β p leads to a strong Shafranov shift, which affects the flux surface averaged pressure drive. The two effects combine to create a peeling-dominated window in intermediate ν* buffered by ballooning-dominated regimes. Only the peeling-dominated regime shows a cyclic behavior in the perturbed pressure during the nonlinear simulation of an ELM crash, reminiscent of grassy-ELM dynamics. Similarly, the energy released across the separatrix is demonstrated to be significantly smaller. The quick recovery of the ELM crash is explainable by the rapid rise of a low n kink-peeling instability when the pedestal current I ped exceeds a threshold at high β p . It minimizes the excursion beyond marginal stability and is absent in the ballooning-dominated regime. Comparison with recent experiments over a range of β p and ν* strongly supports the physical picture proposed by the modeling.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗