Engineering topics
Publications and source records attributed to Jimenez, Jayvic C..
Side chain engineering of non-planar zinc( ii ) complexes of azadipyrromethene enables either very high hole mobility, high electron mobility or both as estimated by the space-charge limited current (SCLC) method in diodes.
We report to optimize and extend the service life of polymeric materials in outdoor environments, a domain knowledge-based and data-driven approach was utilized to quantitatively investigate the temporal evolution of degradation modes, mechanisms, and rates under various stepwise accelerated exposure conditions. Six formulations of poly(methyl methacrylate) (PMMA) with different combinations of stabilizing additives, including one unstabilized formulation, were exposed in three accelerated weathering conditions. Degradation was dependent on wavelength as samples in UV light at 340 nm (UVA) exposure showed the most yellowing. The unstabilized PMMA formulation showed much higher yellowness index values (59.5) than stabilized PMMA formulations (2–12). Urbach edge analysis shows a shift toward longer wavelength from 285 to 500 nm with increasing exposure time and an increased absorbance around 400 nm of visible region as the unstabilized samples increase in yellowing. The degradation mechanisms of PMMA were tracked using induced absorbance to dose at specific wavelengths that correspond to known degradation mechanisms. The degradation pathway of PMMA was modeled in a framework using network structural equation modeling (netSEM). netSEM showed changes in degradation pathway as PMMA transition stages of degradation.
The homoleptic zinc(II) complex of [2,8-di(1-naphthylethynyl) 3,7-diphenyl 1,9-(4-hexylphenyl)azadipyrromethene (ZnL2) 2 ] is a promising non-planar non-fullerene acceptor for organic photovoltaic applications, but it has a relatively low electron mobility that may limit its performance. Here, we explored the fluorination of peripheral aryl groups to increase intermolecular cofacial π–π stacking interactions, which are desirable for electron transport. Here complexes with fluorine on the distal phenyls [Zn(1F-L2) 2 ], on the naphthyls [Zn(2F-L2) 2 ], and on both [Zn(3F-L2) 2 ] were synthesized and characterized. All three complexes had similar optical and electrochemical properties. The crystal packing structure of Zn(2F-L2) 2 and Zn(3F-L2) 2 revealed cofacial parallel-displaced π–π stacking between the fluorinated 1-naphthylethynyl groups. Such a cofacial orientation was not observed in Zn(L2) 2 crystals, suggesting that fluorination of the naphthyl groups promotes the cofacial π–π stacking orientation. The hole mobility increased from 1.0 × 10 –4 cm 2 V –1 s –1 for Zn(L2) 2 to 0.8–1.0 × 10 –3 cm 2 V –1 s –1 for the fluorinated complexes. Fluorination on the naphthyl groups increased the electron mobility from 4.2 × 10 –5 cm 2 V –1 s –1 for Zn(L2) 2 and Zn(1F-L2) 2 to 2.0 × 10 –4 cm 2 V –1 s –1 for Zn(2F-L2) 2 and Zn(3F-L2) 2 , consistent with cofacial π–π stacking being favorable for electron transport. The three complexes were tested in OPVs using regioregular poly(3-hexylthiophene) (P3HT) as the p-type material, and the best power conversion efficiencies were 5.2, 5.4, and 5.8% for Zn(2F-L2) 2 , Zn(1F-L2) 2 , and Zn(3F-L2) 2 , respectively, compared to 5.5% for Zn(L2) 2 . The fluorination combination found in Zn(3F-L2) 2 resulted in the best device performance. This study points to a viable strategy to increase the electron mobility and performance of non-planar zinc(II) complexes of azadipyrromethene.