Engineering topics
Publications and source records attributed to Johnson, J. P..
Faraday cage protects electronic and electronically actuated equipment from lightning. Follows standard lightning-protection principles. Whether lightning strikes cage or cables running to equipment, current canceled or minimized in equipment and discharged into ground. Applicable to protection of scientific instruments, computers, radio transmitters and receivers, and power-switching equipment.
Spring-loaded, roller-type inscribing tool marks flat or nearly flat panels. Tool devised to apply grid lines to gore panels: panels then stress-tested by forming or stretching, followed by measurement of grid-system movement to determine distortion.
Experiments were performed to determine how boundary layer turbulence is affected by strong convex curvature. The data gathered on the behavior of the Reynolds stress suggested the formulation of a simple turbulence model. Data were taken on two separate facilities. Both rigs had flow from a flat surface, over a convex surface with 90 deg of turning and then onto a flat recovery surface. The geometry was adjusted so that, for both rigs, the pressure gradient along the test surface was zero. Two experiments were performed at delta/R approximately 0.10, and one at weaker curvature with delta/R approximately 0.05. Results show that after a sudden introduction of curvature the shear stress in the outer part of the boundary layer is sharply diminished and is even slightly negative near the edge. The wall shear also drops off quickly downstream. When the surface suddenly becomes flat again, the wall shear and shear stress profiles recover very slowly towards flat wall conditions. A simple turbulence model, which was based on the theory that the Prandtl mixing length in the outer layer should scale on the velocity gradient layer, was shown to account for the slow recovery.
Sets of data (flows) from eight original sources on three-dimensional turbulent boundary layers were reevaluated and tabulated in a common format. The flows studied were all of the type describable in only two space coordinates, e.g., flow over a swept wing of infinite span. The principal data in each set are profiles of the main and crossflow components of mean velocity. Turbulent shear stress vector profiles were available for two flows, Bradshaw and Terrell (1969) and Johnson (1970). Free stream pressure gradient, wall shear stress coefficient and angle, integral thickness and left and right hand sides of the momentum integral equations were evaluated in a consistent manner for each flow.