Engineering topics

Johnson, R. W.

Publications and source records attributed to Johnson, R. W..

At least 19 records

NASA NTRS1991

Advanced technology commercial fuselage structure

Boeing's program for Advanced Technology Composite Aircraft Structure (ATCAS) has focused on the manufacturing and performance issues associated with a wide body commercial transport fuselage. The primary goal of ATCAS is to demonstrate cost and weight savings over a 1995 aluminum benchmark. A 31 foot section of fuselage directly behind the wing to body intersection was selected for study purposes. This paper summarizes ATCAS contract plans and review progress to date. The six year ATCAS program will study technical issues for crown, side, and keel areas of the fuselage. All structural details in these areas will be included in design studies that incorporate a design build team (DBT) approach. Manufacturing technologies will be developed for concepts deemed by the DBT to have the greatest potential for cost and weight savings. Assembly issues for large, stiff, quadrant panels will receive special attention. Supporting technologies and mechanical tests will concentrate on the major issues identified for fuselage. These include damage tolerance, pressure containment, splices, load redistribution, post-buckled structure, and durability/life. Progress to date includes DBT selection of baseline fuselage concepts; cost and weight comparisons for crown panel designs; initial panel fabrication for manufacturing and structural mechanics research; and toughened material studies related to keel panels. Initial ATCAS studies have shown that NASA's Advanced Composite Technology program goals for cost and weight savings are attainable for composite fuselage.

Ilcewicz, L. B.↗

NASA NTRS1991

Piezoresistive sensors for measurement of thermally-induced stresses in microelectronics

The general theory of conduction in a piezoresistive material subjected to temperature change is derived and the basic equations needed to design and apply test chips for thermal stress measurement are established. A general expression is obtained for the resistance changes which occur in an arbitrarily oriented 1D filamentary conductor subjected to general 3D stress states and arbitrary temperature changes. The derived formula is valid for crystals such as silicon which have cubic symmetry and diamond lattice structures. Basic equations are presented for the resistance changes experienced by stressed in-plane resistors fabricated on (100) silicon wafers. The established theory is applied to a simple two-element sensor rosette. A test chip containing this rosette configuration is designed and fabricated, and a suitable calibration system is constructed.

Suhling, J. C.↗

NASA NTRS1988

Continental scale variability in vegetation reflectance and its relationship to canopy morphology

The spectral canopy reflectance, biomass, and projected leaf-area index (LAI) of widely dispersed plots of a North American coastal plant were measured in order to study potential impacts of continental-scale environmental variability on the assumptions underlying remote vegetation analysis. Systematic changes in the canopy geometry and resultant near-infrared reflectance of this plant were noted. Mean infrared canopy reflectances of canopies in the northern half of the range were shown to nearly double those of the southern half. It is suggested that the difference results from divergent canopy morphologies, with the northern canopies presenting greater horizontally projected LAIs per unit biomass than southern canopies.

Bartlett, D. S.↗

NASA NTRS1986

Assessing impacts of off-nadir observation on remote sensing of vegetation - Use of the Suits model

The use of Suits' (1972a, b) digital radiative transfer model to simulate the effect of nonLambertian canopy reflectance on off-nadir observations of vegetation is discussed. Canopy reflectances of cord grass are calculated using the radiative transfer model, field radiometric measurements, and airborne multispectral scanner data. The effects of varying view angles on canopy reflectance are analyzed and compared. The comparison reveals that the model is effective in simulating the sense and magnitude of reflectance change due to variable angles of observations; however, the model does not reproduce the observed dependence of nadir canopy reflectance on solar zenith angle. It is concluded that the radiative transfer model is applicable for predicting the variation in canopy reflectance due to changing view zenith angles.

Bartlett, D. S.↗

NASA NTRS1985

Study on utilization of advanced composites in fuselage structures of large transports

The potential for utilizing advanced composites in fuselage structures of large transports was assessed. Six fuselage design concepts were selected and evaluated in terms of structural performance, weight, and manufacturing development and costs. Two concepts were selected that merit further consideration for composite fuselage application. These concepts are: (1) a full depth honeycomb design with no stringers, and (2) an I section stringer stiffened laminate skin design. Weight reductions due to applying composites to the fuselages of commercial and military transports were calculated. The benefits of applying composites to a fleet of military transports were determined. Significant technology issues pertinent to composite fuselage structures were identified and evaluated. Program plans for resolving the technology issues were developed.

Johnson, R. W.↗

NASA NTRS1981

Microwave switching power divider

A pair of parallel, spaced-apart circular ground planes define a microwave cavity with multi-port microwave power distributing switching circuitry formed on opposite sides of a thin circular dielectric substrate disposed between the ground planes. The power distributing circuitry includes a conductive disk located at the center of the substrate and connected to a source of microwave energy. A high speed, low insertion loss switching diode and a dc blocking capacitor are connected in series between the outer end of a transmission line and an output port. A high impedance, microwave blocking dc bias choke is connected between each switching diode and a source of switching current. The switching source forward biases the diodes to couple microwave energy from the conductive disk to selected output ports and, to associated antenna elements connected to the output ports to form a synthesized antenna pattern.

Stockton, R. J.↗

NASA NTRS1981

Synoptic thermal and oceanographic parameter distributions in the New York Bight Apex

Concurrent surface water measurements made from a moving oceanographic research vessel were used to calibrate and interpret remotely sensed data collected over a plume in the New York Bight Apex on 23 June 1977. Multiple regression techniques were used to develop equations to map synoptic distributions of chlorophyll a and total suspended matter in the remotely sensed scene. Thermal (which did not have surface calibration values) and water quality parameter distributions indicated a cold mass of water in the Bight Apex with an overflowing nutrient-rich warm water plume that originated in the Sandy Hook Bay and flowed south near the New Jersey shoreline. Data analysis indicates that remotely sensed data may be particularly useful for studying physical and biological processes in the top several metres of surface water at plume boundaries.

Johnson, R. W.↗

NASA NTRS1981

Fast microwave switching power divider

Unit divides power from single input among any 12 of 120 output terminals and redistributes it in 6 microseconds. Microwave current from coaxial line excites disk feeding many radial strip transmission lines. Built for use in electronically-steered S-band antenna, device also divides and switches energy among filters and phase shifters.

Johnson, R. W.↗

NASA NTRS1981

Application of remote sensing to monitoring and studying dispersion in ocean dumping

Remotely sensed wide area synoptic data provides information on ocean dumping that is not readily available by other means. A qualitative approach has been used to map features, such as river plumes. Results of quantitative analyses have been used to develop maps showing quantitative distributions of one or more water quality parameters, such as suspended solids or chlorophyll a. Joint NASA/NOAA experiments have been conducted at designated dump areas in the U.S. coastal zones to determine the applicability of aircraft remote sensing systems to map plumes resulting from ocean dumping of sewage sludge and industrial wastes. A second objective is related to the evaluation of previously developed quantitative analysis techniques for studying dispersion of materials in these plumes. It was found that plumes resulting from dumping of four waste materials have distinctive spectral characteristics. The development of a technology for use in a routine monitoring system, based on remote sensing techniques, is discussed.

Johnson, R. W.↗

NASA NTRS1980

Remote sensing and spectral analysis of plumes from ocean dumping in the New York Bight Apex

The application of the remote sensing techniques of aerial photography and multispectral scanning in the qualitative and quantitative analysis of plumes from ocean dumping of waste materials is investigated in the New York Bight Apex. Plumes resulting from the dumping of acid waste and sewage sludge were observed by Ocean Color Scanner at an altitude of 19.7 km and by Modular Multispectral Scanner and mapping camera at an altitude of 3.0 km. Results of the qualitative analysis of multispectral and photographic data for the mapping, location, and identification of pollution features without concurrent sea truth measurements are presented which demonstrate the usefulness of in-scene calibration. Quantitative distributions of the suspended solids in sewage sludge released in spot and line dumps are also determined by a multiple regression analysis of multispectral and sea truth data.

Johnson, R. W.↗

NASA NTRS1980

Synoptic thermal and oceanographic parameter distribution in the New York Bight Apex on June 23, 1977

Concurrent surface water measurements made from a moving oceanographic research vessel were used to calibrate and interpret remotely sensed data collected over a plume in the New York Bight Apex on June 23, 1977. Multiple regression techniques were used to develop equations to subsequently map synoptic distributions of water quality parameters, chlorophyll A and total suspended matter, in the remotely sensed scene. Thermal (which did not have surface calibration values) and water quality parameter distributions indicated a cold mass of upwelled water in the Bight Apex with an overflowing nutrient-rich warm water plume that originated in the Sandy Hook Bay and flowed south near the New Jersey shoreline. Additional comparison of remotely sensed thermal and optical properties of the water with shipboard measurements indicated that remotely sensed data may be particularly useful for studying physical and biological processes in the top several meters of surface water at the plume boundaries.

Johnson, R. W.↗

NASA NTRS1980

Remote sensing for water quality and biological measurements in coastal waters

Recent remote sensing experiments in the United States' coastal waters indicate that certain biological and water quality parameters have distinctive spectral characteristics. Data outputs from remote sensors, to date, include: (1) high resolution measurements to determine concentrations and distributions of total suspended particulates, temperature, salinity, chlorophyll a, and phytoplankton color group associations from airborne and/or satellite platforms, and (2) low resolution measurements of total suspended solids, temperature, ocean color, and possibly chlorophyll from satellite platforms. A summary of platforms, sensors and parameters measured is given. Remote sensing, especially when combined with conventional oceanographic research methods, can be useful in such high priority research areas as estuarine and continental shelf sediment transport dynamics, transport and fate of marine pollutants, marine phytoplankton dynamics, and ocean fronts.

Johnson, R. W.↗

NASA NTRS1980

Simulation modeling of estuarine ecosystems

A simulation model has been developed of Galveston Bay, Texas ecosystem. Secondary productivity measured by harvestable species (such as shrimp and fish) is evaluated in terms of man-related and controllable factors, such as quantity and quality of inlet fresh-water and pollutants. This simulation model used information from an existing physical parameters model as well as pertinent biological measurements obtained by conventional sampling techniques. Predicted results from the model compared favorably with those from comparable investigations. In addition, this paper will discuss remotely sensed and conventional measurements in the framework of prospective models that may be used to study estuarine processes and ecosystem productivity.

Johnson, R. W.↗

NASA NTRS1979

New space initiatives through large generic structures

New possibilities in satellite communications, surveillance, and orbital experimentation provided by the capability to construct and deploy Large Space Structures (LSS) are presented. The advent of the Shuttle will allow deployment of larger antennas with much larger gain sizes, noting new applications in communications, radiometry, and radar in frequencies from 0.24 to 14 GHz. Applications in multi-beam communication which can hold spot sizes on the ground down to 30 miles in diameter, new applications of the large aperture radar antenna, and estimates of soil moisture by the microwave radiometer are discussed. The Solar Power Satellite consisting of a large solar collector orbiting the earth at geosynchronous altitude over the equator which requires ability to construct LSS in space is described, noting the design of solar cells and materials of construction, including graphite composites and aluminum alloys. Space construction procedures and equipment are considered, noting that the most likely procedure would deliver the subsystems to orbit separately, and then construct the spacecraft on-orbit and assemble the satellite.

Johnson, R. W.↗

NASA NTRS1979

Marine chlorophyll a analysis

Quantitative distribution maps of chlorophyll a and other important environmental parameters of coastal zones are prepared by regression analysis of sea-truth data and data collected by aircraft multispectral scanners.

Johnson, R. W.↗

NASA NTRS1979

Applications of remote sensing for water quality and biological measurements in coastal waters

Potential applications of remote sensing technology to the study of coastal marine environments are reviewed, emphasizing water quality and biological measurements. Parameters measurable by airborne or spaceborne remote sensors include particulates, measured by visual or multispectral photography, chlorophyll a, measured by the Ocean Color Scanner or Coastal Zone Color Scanner, temperature distributions, by IR or microwave sensors, and salinity, by means of microwave radiometers. Research projects in which wide area synoptic or repetitive remote sensing can make a major contribution include the study of estuarine and continental shelf sediment transport dynamics, marine pollutant transport, marine phytoplankton dynamics and ocean fronts.

Johnson, R. W.↗

NASA NTRS1979

Airborne spacecraft - A remotely powered, high-altitude RPV for environmental applications

A high-altitude, unmanned, propeller-driven electric airplane is proposed for remote sensing of environmental phenomena. With motive power from surface-mounted solar arrays or microwave receivers, flight endurance of weeks to months could be anticipated. The proposed system offers unique capability for monitoring oceanic and atmospheric characteristics on local or regional scales. Coastal marine and tropospheric research activities, which require temporal resolutions of 2-72 hours, would be prime application areas. Potential missions might include the monitoring of ocean disposals, episodic marine biological events, and river/ocean interactions. Preliminary sizing and performance calculations are presented along with possible mission scenarios and payload complements.

Youngblood, J. W.↗

NASA NTRS1978

Mapping of chlorophyll a distributions in coastal zones

It is pointed out that chlorophyll a is an important environmental parameter for monitoring water quality, nutrient loads, and pollution effects in coastal zones. High chlorophyll a concentrations occur in areas which have high nutrient inflows from sources such as sewage treatment plants and industrial wastes. Low chlorophyll a concentrations may be due to the addition of toxic substances from industrial wastes or other sources. Remote sensing provides an opportunity to assess distributions of water quality parameters, such as chlorophyll a. A description is presented of the chlorophyll a analysis and a quantitative mapping of the James River, Virginia. An approach considered by Johnson (1977) was used in the analysis. An application of the multiple regression analysis technique to a data set collected over the New York Bight, an environmentally different area of the coastal zone, is also discussed.

Johnson, R. W.↗