Engineering topics

Johnston, Nick

Publications and source records attributed to Johnston, Nick.

3 records

NASA NTRS2006

Simulator for Testing Spacecraft Separation Devices

A report describes the main features of a system for testing pyrotechnic and mechanical devices used to separate spacecraft and modules of spacecraft during flight. The system includes a spacecraft simulator [also denoted a large mobility base (LMB)] equipped with air thrusters, sensors, and data-acquisition equipment. The spacecraft simulator floats on air bearings over an epoxy-covered concrete floor. This free-flotation arrangement enables simulation of motion in outer space in three degrees of freedom: translation along two orthogonal horizontal axes and rotation about a vertical axis. The system also includes a static stand. In one application, the system was used to test a bolt-retraction system (BRS) intended for separation of the lifting-body and deorbit-propulsion stages of the X- 38 spacecraft. The LMB was connected via the BRS to the static stand, then pyrotechnic devices that actuate the BRS were fired. The separation distance and acceleration were measured. The report cites a document, not yet published at the time of reporting the information for this article, that is said to present additional detailed information.

Johnston, Nick↗

NASA NTRS2004

Demonstration of a Pyrotechnic Bolt-Retractor System

A paper describes a demonstration of the X-38 bolt-retractor system (BRS) on a spacecraft-simulating apparatus, called the Large Mobility Base, in NASA's Flight Robotics Laboratory (FRL). The BRS design was proven safe by testing in NASA's Pyrotechnic Shock Facility (PSF) before being demonstrated in the FRL. The paper describes the BRS, FRL, PSF, and interface hardware. Information on the bolt-retraction time and spacecraft-simulator acceleration, and an analysis of forces, are presented. The purpose of the demonstration was to show the capability of the FRL for testing of the use of pyrotechnics to separate stages of a spacecraft. Although a formal test was not performed because of schedule and budget constraints, the data in the report show that the BRS is a successful design concept and the FRL is suitable for future separation tests.

Johnston, Nick↗

NASA NTRS1999

Position Estimation Verification Testing for the Video Guidance Sensor and Dynamic Overhead Target Simulator

The Video Guidance Sensor, part of the Automated Rendezvous and Capture mechanism, is due to undergo formal qualification testing at Marshall Space Flight Center. Before it undergoes this qualification, a test was needed to verify repeatability of the sensor, and to allow different sensor configurations to be compared. This test was developed at the Flight Robotics Laboratory. The test uses a software script to drive the sensor target to the same position and thus allows sensor runs to be compared. The sensor target is the Dynamic Overhead Target Simulator. The simulator uses encoders as its position indicator. Distance Measuring Device's were used to independently verify the software script, the sensor reading, and the target position. The test area, sensor, and other test equipment are briefly described. The actual data is tabulated and will serve as a baseline for future tests. The software script was found to be adequate for the test. Position repeatability was acceptable for all the equipment. The system test is now ready to be used in formal qualification testing.

Gaines, Joseph↗