Engineering topics

Jolly, Arthur D.

Publications and source records attributed to Jolly, Arthur D..

3 records

DOE OSTI2022

Atmospheric waves and global seismoacoustic observations of the January 2022 Hunga eruption, Tonga

The 15 January 2022 climactic eruption of Hunga volcano, Tonga, produced an explosion in the atmosphere of a size that has not been documented in the modern geophysical record. The event generated a broad range of atmospheric waves observed globally by various ground-based and spaceborne instrumentation networks. Most prominent was the surface-guided Lamb wave (≲0.01 hertz), which we observed propagating for four (plus three antipodal) passages around Earth over 6 days. As measured by the Lamb wave amplitudes, the climactic Hunga explosion was comparable in size to that of the 1883 Krakatau eruption. The Hunga eruption produced remarkable globally detected infrasound (0.01 to 20 hertz), long-range (~10,000 kilometers) audible sound, and ionospheric perturbations. Seismometers worldwide recorded pure seismic and air-to-ground coupled waves. Air-to-sea coupling likely contributed to fast-arriving tsunamis. In this article, we highlight exceptional observations of the atmospheric waves.

58 GEOSCIENCES↗

DOE OSTI2021

Synthetic Evaluation of Infrasonic Multipole Waveform Inversion

Acoustic source inversions estimate the mass flow rate of volcanic explosions or yield of chemical explosions and provide insight into potential source directionality. However, the limitations of applying these methods to complex sources and their ability to resolve a stable solution have not been investigated in detail. We perform synthetic infrasound waveform inversions that use 3-D Green’s functions for a variety of idealized and realistic deployment scenarios using both a flat plane and Yasur volcano, Vanuatu as examples. We investigate the ability of various scenarios to retrieve the input source functions and relative amplitudes for monopole and multipole (monopole and dipole) inversions. Infrasound waveform inversions appear to be a robust method to quantify mass flow rates from simple sources (monopole) using deployments of infrasound sensors placed around a source, but care should be taken when analyzing and interpreting results from more complex acoustic sources (multipole) that have significant directional components. In the examples we consider the solution is stable for monopole inversions with a signal-to-noise ratio greater than five and the dipole component is small. For most scenarios investigated, the vertical dipole component of the multipole explosion source is poorly constrained and can impact the ability to recover the other source term components. Because multipole inversions are ill-posed for many deployments, a low residual does not necessarily mean the proper source vector has been recovered. Synthetic studies are able to help investigate the limitations and place bounds on information that may be missing using monopole and multipole inversions for potentially directional sources.

58 GEOSCIENCES↗

DOE OSTI2021

Local Explosion Detection and Infrasound Localization by Reverse Time Migration Using 3-D Finite-Difference Wave Propagation

Infrasound data are routinely used to detect and locate volcanic and other explosions, using both arrays and single sensor networks. However, at local distances (< km) topography often complicates acoustic propagation, resulting in inaccurate acoustic travel times leading to biased source locations when assuming straight-line propagation. Here we present a new method, termed Reverse Time Migration-Finite-Difference Time Domain (RTM-FDTD), that integrates numerical modeling into the standard RTM back-projection process. Travel time information is computed across the entire potential source grid via FDTD modeling to incorporate the effects of topography. The waveforms are then back-projected and stacked at each grid point, with the stack maximum corresponding to the likely source. We apply our method to three volcanoes with different network configurations, source-receiver distances, and topography. At Yasur Volcano, Vanuatu, RTM-FDTD locates explosions within ~20 m of the source and differentiates between multiple vents. RTM-FDTD produces a more accurate location for the two Yasur subcraters than standard RTM and doubles the number of detected events. At Sakurajima Volcano, Japan, RTM-FDTD locates the source within 50 m of the active vent despite notable topographic blocking. The RTM-FDTD location is similar to that from the Time Reversal Mirror method, but is more computationally efficient. Lastly, at Shishaldin Volcano, Alaska, RTM and RTM-FDTD both produce realistic source locations (<50 m) for ground-coupled airwaves recorded on a four-station seismic network. We show that RTM is an effective method to detect and locate infrasonic sources across a variety of scenarios, and by integrating numerical modeling, RTM-FDTD produces more accurate source locations and increases the detection capability.

58 GEOSCIENCES↗