Search NASASearch

Engineering topics

Jones, J. J.

Publications and source records attributed to Jones, J. J..

At least 19 records

Electric field measurements with an airplane - Problems caused by emitted charge

The temporal variation of electric field components deduced from measurements made with airplanes penetrating electrified clouds is often complex, especially when the airplane experiences strong electrical charging. However, unusually simple electric field variations were obtained for penetrations involving severe charging of an airplane on flights over Kennedy Space Center, Florida, on August 19, 1989. Analysis of these results suggests that plumes of ions were emitted from the airplane. The electric field from these plumes was more intense than the ambient field from the cloud at the location of the aft electric field sensor. As a consequence, the deduced component of the ambient electric field in the direction of flight was severely distorted. These findings emphasize (1) the importance of careful evaluation of electric field data obtained with airplanes and (2) the need for improved measurements.

Jones, J. J.

Charge control experiments on a CH-53E helicopter in a dusty environment

Charge control tests were carried out on a ground based, Marine Corps helicopter to determine if control of the electric fields acting on the engine exhaust gases could be used to reduce the electrification of the helicopter when it operated in a dusty atmosphere. The test aircraft was flown to a dusty, unpaved area and was then isolated electrically from the earth. When the helicopter engines were operated at ground idle with the rotor locked, the isolated aircraft charged positively, as had been observed previously. However, when the rotor brake was released and the turning rotor created a downdraft that raised dust clouds, the aircraft always became charged more positively, to potentials ranging form +30 to +45 kV. The dust clouds raised by the rotor downwash invariably carried negative space charges with concentrations of up to -100 nC/cu m and caused surface electric fields with strengths of up to 10 kV/m immediately down wind of the aircraft. The natural charging of the helicopter operating in these dust clouds was successfully opposed by control of the electric fields acting on the hot, electrically conductive exhaust gases. The control was achieved by placing electrostatic shield around the exhausts.

Moore, C. B.

Aircraft measurements of electrified clouds at Kennedy Space Center, part 3

Flights made by the Special Purpose Test Vehicle for Atmospheric Research (SPTVAR) airplane during a second deployment to Florida during the summer of 1989 are discussed. The findings based on the data gathered are presented. The progress made during the second year of the project is discussed. The summer 1989 study was carried out with the support and guidance of Col. John Madura, Commander of Detachment 11, 2nd Weather Squadron, USAF, at Patrick Air Force Base (PAFB) and Cape Canaveral Air Force Station. The project goals were to develop and demonstrate techniques for measuring the electric field aloft and locating regions of charge during flight within and near clouds; to characterize the electric conditions that are presently identified as a threat to space launch vehicles; and to study the correlation between the electric field aloft and that at Kennedy Space Center's ground-based electric field mill array for a variety of electrified clouds.

Jones, J. J.

Aircraft measurements of electrified clouds at Kennedy Space Center

The space-vehicle launch commit criteria for weather and atmospheric electrical conditions in us at Cape Canaveral Air Force Station and Kennedy Space Center (KSC) have been made restrictive because of the past difficulties that have arisen when space vehicles have triggered lightning discharge after their launch during cloudy weather. With the present ground-base instrumentation and our limited knowledge of cloud electrification process over this region of Florida, it has not been possible to provide a quantitative index of safe launching conditions. During the fall of 1988, a Schweizer 845 airplane equipped to measure electric field and other meteorological parameters flew over KSC in a program to study clouds defined in the existing launch restriction criteria. All aspects of this program are addressed including planning, method, and results. A case study on the November 4, 1988 flight is also presented.

Jones, J. J.

Aircraft measurements of electrified clouds at Kennedy Space Center. Part 1: 1988 flights

During the fall of 1988, a Schweizer 845 airplane equipped to measure electric field and other meteorological parameters flew over Kennedy Space Center in a program to study clouds defined in the existing launch retriction requirements. The special purpose test vehicle for atmospheric research (SPTVAR) was suitable for flights through thunderclouds and was instrumented to measure all three components of the ambient electric vector. The main goals of the project were: (1) to develop and demonstrate techniques for measuring the electric field aloft and locate regions of charge during flight; (2) to characterize the electrical conditions within and near clouds that are presently identified as a threat to space launch vehicles; and (3) to study the correlation between the electric field aloft and that at Kennedy Space Center's ground-based field mill network for a variety of electrified clouds.

Jones, J. J.

Aircraft measurements of electrified clouds at Kennedy Space Center. Part 2: Case study: 4 November 1988 (88309)

During the fall of 1988, a Schweizer airplane equipped to measure electric field and other meteorological parameters flew over Kennedy Space Center (KSC) in a program to study clouds defined in the existing launch restriction criteria. A case study is presented of a single flight over KSC on November 4, 1988. This flight was chosen for two reasons: (1) the clouds were weakly electrified, and no lightning was reported during the flight; and (2) electric field mills in the surface array at KSC indicated field strengths greater than 3 kV/m, yet the aircraft flying directly over them at an altitude of 3.4 km above sea level measured field strengths of less than 1.6 kV/m. A weather summary, sounding description, record of cloud types, and an account of electric field measurements are included.

Jones, J. J.

The Aeroassist Flight Experiment

The key design drivers for the Aeroassist Flight Experiment are discussed and a description is given of the flight test vehicle, its flight conditions, and instrumentation. The aeroassisted orbital transfer vehicle (AOTV) operates at higher velocities than the Space Shuttle and at higher altitudes than Apollo. Issues such as the effect of shock-layer nonequilibrium on the levels of radiative and convective heating and of viscous and real-gas effects on vehicle aerodynamic characteristics are mentioned.

Walberg, G. D.

Shuttle Performance: Lessons Learned, Part 2

Several areas of Space Shuttle technology were addressed including aerothermal environment, thermal protection, measurement and analysis, Shuttle carrier aerodynamics, entry analysis of the STS-3, and an overview of each section.

Arrington, J. P.

Chemical nonequilibrium effects on flowfields for aeroassist orbital transfer vehicles

Acceptable altitude and velocity ranges for the perigee of aeroassist orbital transfer vehicles (AOTV) have been determined for various values of ballistic coefficient and lift-to-drag ratio. The chemical nonequilibrium effect on the flowfield of a simple but representatively high-drag, blunt configuration was investigated for these perigee conditions, ranging from 73 to 90 km in altitude and 8 to 9.3 km/s in velocity. The analysis was performed using a two-dimensional viscous-shock-layer code which had previously demonstrated good success in predicting nonequilibrium heating on the Space Shuttle. The results indicate lower ratio of nonequilibrium/equilibrium heating for the present AOTV perigee conditions than for the Shuttle flight conditions, due to higher velocity. The trend for the degree of nonequilibrium with the effect of varying wall catalycity and configuration was determined over the altitude range. Some implications to future design consideration are stated.

Shinn, J. L.

OEX - Use of the Shuttle Orbiter as a research vehicle

The Orbiter Experiments Program to provide research instrumentation on the Shuttle Orbiter is discussed. Flight aerodynamic problems such as ground-based data limitations, rarefied flow effects, body flap and control surface effectiveness, and windward surface heat transfer are reviewed. Experiments currently under development are described, including experiments on tile gaps and wall catalytic effects which provide the opportunity to obtain data not available in ground facilities and apply the results to improvements in the Orbiter's thermal protection system. Such experiments combined with other instrumentation on the Orbiter should provide benchmark flight data which can make a significant impact on the design of future space transportation systems.

Jones, J. J.

An experimental determination of the cross section of the Swings band system of C3

The spectral absorption cross section of the Swings band of C3 was determined from measurements behind incident shock waves that heated a gas mixture of argon and acetylene. These measurements spanned the spectral region between 300 and 540 nm, and were obtained at temperatures between 3200 and 4000 K. An electronic oscillator strength of 0.033 was deduced from the measurements.

Cooper, D. M.

A study and experiment plan for digital mobile communication via satellite

The viability of mobile communications is examined within the context of a frequency division multiple access, single channel per carrier satellite system emphasizing digital techniques to serve a large population of users. The intent is to provide the mobile users with a grade of service consistant with the requirements for remote, rural (perhaps emergency) voice communications, but which approaches toll quality speech. A traffic model is derived on which to base the determination of the required maximum number of satellite channels to provide the anticipated level of service. Various voice digitalization and digital modulation schemes are reviewed along with a general link analysis of the mobile system. Demand assignment multiple access considerations and analysis tradeoffs are presented. Finally, a completed configuration is described.

Jones, J. J.

Radiative flux penetration through a blown shock layer for Jupiter entry conditions

A study is made of the radiative blockage due to carbonaceous ablation injection for a probe entering the Jupiter atmosphere. This is accomplished by calculating the stagnation-point blockage factors for three entry trajectories that account for variations in probe configuration, atmospheric gas composition, and entry conditions. The radiative blockage within the relatively cool ablation layer is shown to be large and to be primarily dependent upon the absorption of the C2 and C3 species. The C3 absorption is significant, particularly when the new experimental data for C3 spectral absorption properties are used. Also, the stagnation-point radiative blockage factors are shown to correlate well in terms of the no-injection radiative heating rates for various entry conditions.

Moss, J. N.

The optical absorption of triatomic carbon C3 for the wavelength range 260 to 560 nm

The spectral absorption properties of C3 have been measured in a shock tube containing a test gas mixture of acetylene diluted with argon. The absorption of a pulsed xenon light source was measured by means of eight photomultiplier channels to a spectrograph and an accompanying drum camera. The postshock test gas temperature and pressure were varied over the range 3240 to 4300 K and 37 to 229 kPa, respectively. The results showed appreciable absorption by C3 for the wavelength range 300 to 540 nm. The various reported measurements of the heat of formation of C3 which are available in the open literature were reviewed, and a value of 198 kcal/mol is recommended. This value, along with best available values for other species, was used to calculate the number density of C3 for the conditions of the present experiments in order to compute absorption cross section or electronic oscillator strength. The computed electronic oscillator strength varied from a high of 0.062 at 3300 K to a low of 0.036 at 3900 K.

Jones, J. J.

Effects of atmospheric structure on radiative heating for Jupiter entry probe

New estimates of the radiative heat load to a Jupiter entry probe have been obtained for revised models of Jupiter's atmosphere based on the latest data from Pioneer 10 and 11 missions and earth-based experiments. The new estimates of the radiative heat load are compared with results obtained for the previous atmospheric models. The changes in Jupiter's atmospheric models cause a substantial reduction in the radiative heat load for the atmosphere denoted as 'cool', but only moderate reductions for the atmospheres denoted as 'nominal' and 'warm'. Results are also presented showing the effects of inertial entry angle for off-equatorial entries in the revised model atmospheres.

Sutton, K.

Shock tube measurements of the optical absorption of triatomic carbon, C3

The spectral absorption of C3 has been measured in a shock tube using a test gas mixture of acetylene diluted with argon. The absorption of a pulsed xenon light source was measured by means of eight photomultiplier channels to a spectrograph and an accompanying drum camera. The postshock test gas temperature and pressure were varied over the range 3300-4300 K and 0.36 to 2.13 atmospheres, respectively. The results showed appreciable absorption from C3 for the wavelength range 300 to 540 nanometers. The computed electronic oscillator strength varied from 0.12 to 0.06 as a function of temperature.

Jones, J. J.