Search NASA⌕ Search

Engineering topics

Jones, Kyle

Publications and source records attributed to Jones, Kyle.

Predicting multiphase flow and tracer transport for an underground chemical explosive test

Detecting radionuclide gas seepage from clandestine underground nuclear tests is central to nonproliferation explosion monitoring research. Yet, early-time (<6 day) gas transport driven by the explosive pressure wave remains poorly constrained due to scarcity of field data. We simulate multi-phase gas transport in the vadose zone using pre-shot data from a recent chemical explosion in P-Tunnel at the Nevada National Security Site, USA. Despite using a simplified 2D-radial model, predictions of tracer arrival matched observations within one order-of-magnitude. Our results show how transient blast forcing rapidly mobilizes gases from the cavity into surrounding rock – critical for optimizing sensor placement and test planning. This unique integration of field data and modeling represents a significant improvement in our ability to predict gas migration from underground explosions. More broadly, it offers insights into the coupled dynamics of pressure waves and contaminant transport in the vadose zone, with implications for monitoring and hazard assessment.

54 ENVIRONMENTAL SCIENCES↗

Permeability scaling relationships of volcanic tuff from core to field scale measurements

A recent chemical explosive test in P-Tunnel at the Nevada National Security Site, Nevada, USA, was conducted to better understand how signals propagate from explosions in the subsurface. A primary signal of interest is the migration of gases that can be used to differentiate chemical from nuclear explosions. Gas migration is highly dependent on the rock permeability which is notoriously difficult to determine experimentally in the field due to a potentially large dependence on the scale over which measurements are made. Here, we present pre-explosion permeability estimates to characterize the geologic units surrounding the recent test. Permeability measurements were made at three scales of increasing size: core samples (≈2 cm), borehole packer system tests (≈1 m), and a pre-shot cavity pressurization test (> 10 m) across ten tuff units. Permeability estimates based on core measurements showed little difference from borehole packer tests. However, permeability in most rock units calibrated from cavity pressurization tests resulted in higher permeability estimates by up to two orders of magnitude. Here, we demonstrate that the scale of the measurement significantly impacts the characterization efforts of hydraulic properties in volcanic tuff, and that local-scale measurements (< 10 m scale) do not incorporate enough heterogeneity to accurately predict field-scale flow and mass transport.

Environmental sciences↗

The Source Physics Experiment (SPE) Science Plan

The Source Physics Experiment (SPE) series is a long-term NNSA research and development effort designed to improve U.S. arms control and nuclear nonproliferation verification and monitoring capabilities. The findings from the SPE will advance the United States’ nuclear explosion monitoring capabilities, particularly with respect to detection, discrimination and determination of yields associated with small nuclear explosions that can be lost amid the noisy seismo-acoustic background from other sources. The data generated from the SPE, a series of well-designed and recorded chemical explosions, will contribute to the development and validation of first-principles explosive source generated seismo-acoustic modeling codes. These codes will then facilitate the update of semi-empirical methods, currently based on historic test site data, such that key explosion observables can be reproduced, thus improving confidence in nuclear test monitoring in new areas and/or under novel emplacement conditions. The overall SPE project is comprised of both the development of the new explosion simulation codes and the chemical explosion test series. The chemical explosion test series will generate the empirical data required to both develop and validate the new simulation codes.

58 GEOSCIENCES↗

The Source Physics Experiment (SPE) Science Plan (Version 2.4c)

The Source Physics Experiment (SPE) series is a long-term NNSA research and development effort designed to improve U.S. arms control and nuclear nonproliferation verification and monitoring capabilities. The findings from the SPE will advance the United States’ nuclear explosion monitoring capabilities, particularly with respect to detection, discrimination and determination of yields associated with small nuclear explosions that can be lost amid the noisy seismo-acoustic background from other sources. The data generated from the SPE, a series of well-designed and recorded chemical explosions, will contribute to the development and validation of first-principles explosive source generated seismo-acoustic modeling codes. These codes will then facilitate the update of semi-empirical methods, currently based on historic test site data, such that key explosion observables can be reproduced, thus improving confidence in nuclear test monitoring in new areas and/or under novel emplacement conditions. The overall SPE project is comprised of both the development of the new explosion simulation codes and the chemical explosion test series. The chemical explosion test series will generate the empirical data required to both develop and validate the new simulation codes.

58 GEOSCIENCES↗

On infrasound generated by wind farms and its propagation in low-altitude tropospheric waveguides

Infrasound from a 60-turbine wind farm was found to propagate to distances up to 90 km under nighttime atmospheric conditions. Four infrasound sensor arrays were deployed in central New Mexico in February 2014; three of these arrays captured infrasound from a large wind farm. The arrays were in a linear configuration oriented southeast with 13, 54, 90, and 126 km radial distances and azimuths of 166°, 119°, 113°, and 111° from the 60 1.6 MW turbine Red Mesa Wind Farm, Laguna Pueblo, New Mexico, USA. Peaks at a fundamental frequency slightly below 0.9 Hz and its harmonics characterize the spectrum of the detected infrasound. The generation of this signal is linked to the interaction of the blades, flow gradients, and the supporting tower. The production of wind-farm sound, its propagation, and detection at long distances can be related to the characteristics of the atmospheric boundary layer. First, under stable conditions, mostly occurring at night, winds are highly stratified, which enhances the production of thickness sound and the modulation of other higher-frequency wind turbine sounds. Second, nocturnal atmospheric conditions can create low-altitude waveguides (with altitudes on the order of hundreds of meters) allowing long-distance propagation. Third, night and early morning hours are characterized by reduced background atmospheric noise that enhances signal detectability. This paper describes the characteristics of the infrasound from a quasi-continuous source with the potential for long-range propagation that could be used to monitor the lower part of the atmospheric boundary layer.

17 WIND ENERGY↗

Coupled alkai fieldspar dissolution and secondary mineral precipatation in batch systems-2: New experiments with supercritical CO2 and implications for carbon sequestration

In order to evaluate the extent of CO{sub 2}–water–rock interactions in geological formations for C sequestration, three batch experiments were conducted on alkali feldspars–CO{sub 2}–brine interactions at 150–200 °C and 300 bars. The elevated temperatures were necessary to accelerate the reactions to facilitate attainable laboratory measurements. Temporal evolution of fluid chemistry was monitored by major element analysis of in situ fluid samples. SEM, TEM and XRD analysis of reaction products showed extensive dissolution features (etch pits, channels, kinks and steps) on feldspars and precipitation of secondary minerals (boehmite, kaolinite, muscovite and paragonite) on feldspar surfaces. Therefore, these experiments have generated both solution chemistry and secondary mineral identity. The experimental results show that partial equilibrium was not attained between secondary minerals and aqueous solutions for the feldspar hydrolysis batch systems. Evidence came from both solution chemistry (supersaturation of the secondary minerals during the entire experimental duration) and metastable co-existence of secondary minerals. The slow precipitation of secondary minerals results in a negative feedback in the dissolution–precipitation loop, reducing the overall feldspar dissolution rates by orders of magnitude. Furthermore, the experimental data indicate the form of rate laws greatly influence the steady state rates under which feldspar dissolution took place. Negligence of both the mitigating effects of secondary mineral precipitation and the sigmoidal shape of rate–ΔG{sub r} relationship can overestimate the extent of feldspar dissolution during CO{sub 2} storage. Finally, the literature on feldspar dissolution in CO{sub 2}-charged systems has been reviewed. The data available are insufficient and new experiments are urgently needed to establish a database on feldspar dissolution mechanism, rates and rate laws, as well as secondary mineral information at CO{sub 2} storage conditions.

54 ENVIRONMENTAL SCIENCES↗