Engineering topics

Joyce, J. P.

Publications and source records attributed to Joyce, J. P..

6 records

NASA NTRS1976

Hydrogen environment embrittlement of turbine disk alloys

Astroloy and V-57, two candidate turbine disk alloys for the auxiliary power unit (APU) of the space shuttle propulsion and power system were tested for their resistance to embrittlement in hydrogen environments. Samples of both these nickel-base alloys were subjected to notch and smooth tensile testing and to creep testing in hydrogen. The high resistance exhibited by Astroloy forgings to embrittlement by hydrogen is attributed to the microstructure produced by forging and also to the special heat treatment schedule. V-57 turbine disks successfully completed short-time performance testing in the experimental APU. The use of the Astroloy, however, would permit increasing turbine inlet temperature and the rotational speed beyond those possible with V-57.

Gray, H. R.↗

NASA NTRS1975

Hydrogen environment embrittlement of astroloy and Udimet 700 (nickel-base) and V-57 (iron-base) superalloys

The sensitivity to hydrogen environment embrittlement of three superalloys was determined. Astroloy forgings were resistant to embrittlement during smooth tensile, notched tensile, and creep testing in 3.5-MN/sq m hydrogen over the range 23 to 760 C. The notched tensile strength of Udimet 700 bar stock in hydrogen at 23 C was only 50 percent of the baseline value in helium. Forgings of V-57 were not significantly embrittled by hydrogen during smooth tensile testing over the range 23 to 675 C; creep and rupture lives of V-57 were degraded by hydrogen. Postcreep tensile ductility of V-57 was reduced by 40 percent after creep exposure in hydrogen.

Gray, H. R.↗

NASA NTRS1973

H2-O2 auxiliary power unit for Space Shuttle vehicles - A progress report.

Description of a program to establish technology readiness of hydrogen-oxygen (H2-O2) auxiliary power units for use on board the Space Shuttle orbiter vehicle. Fundamental objectives include experimentally establishing an acceptable propellant flow control method, verification of combustor stability, and adequate thermal management. An initial auxiliary power unit (APU) configuration with recycled hydrogen flow has been studied and revised toward greater simplicity and scaling ease. The selected APU is a recuperated open-cycle, turbine-driven unit. Series flow of cryogenic hydrogen removes internally-generated heat and heat from the hydraulic system. The revised configuration schematic and its calculated performance are reviewed. A weight comparison is made between the shuttle baseline hydrazine and H2-O2 APU systems, showing that hydrogen-oxygen APUs have the potential of increasing the payload of the Space Shuttle.

Joyce, J. P.↗

NASA NTRS1973

H2-O2 auxiliary power unit for space shuttle vehicles

A program to establish technology readiness of hydrogen-oxygen (H2-O2) auxiliary power units for use on board the space shuttle orbiter vehicle is discussed. Fundamental objectives include experimentally establishing an acceptable propellant flow control method, verification of combustor stability, and adequate thermal management. An initial APU configuration with recycled hydrogen flow has been studied and revised towards greater simplicity and scaling ease. The selected APU is a recuperated open-cycle, turbine-driven unit. Series flow of cryogenic hydrogen removes internally-generated heat and from the hydraulic system. Steady-state test of the combustor has been successful.

Joyce, J. P.↗

NASA NTRS1972

An H2-O2 auxiliary power unit for space shuttle

Auxiliary power units operating on hydrogen and oxygen have the potential for significantly improved performance and payload for space shuttle vehicles. A recuperated open cycle hydrogen-oxygen turbine driven power system concept with pressure modulated reactant control is considered. The reference system, the control mode, component arrangement, performance potential, and the technology program for this system are discussed.

Beremand, D. G.↗

NASA NTRS1972

An H2-O2 auxiliary power unit for Space Shuttle.

Auxiliary power units operating on hydrogen and oxygen have the potential for significantly improved performance and payload for the Space Shuttle vehicles. In order to identify the technologies required for these units and to identify promising system configurations, contracted studies provided component and system-configuration screening analysis and detailed analysis of two preliminary system layouts. From these studies, Lewis Research Center has selected for further investigation a recuperated open-cycle hydrogen-oxygen turbine-driven APU concept with pressure-modulated reactant control. This paper discusses the reference system, the control mode, component arrangement, performance potential, and the technology program for this system.

Beremand, D. G.↗