Considerations on a Large Hydraulic Jet Catapult
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to Joyner, Upshur T.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Experimental results of tests made at the Langley Memorial Aeronautical Laboratory are presented to show how heat-transfer coefficients can he increased by a method utilizing the high rate of heat transfer known to exist on any heat-transfer surface in the region adjacent to the edge on which the cooling or heating fluid impinges. The results show that, for the same pressure drop, the average surface heat-transfer.coefficient can be increased 50 to 100 percent when a cooling surface having a length of four inches in the direction of fluid flow is cut to form twenty fins with a length of 0.2 inch in the direction of fluid flow and the fins are sharpened and staggered in the air stream. The percentage of increase in the surface heat-transfer coefficient obtained as a result of shortening the length of the cooling surface varies with the pressure drop of the cooling fluid in passing the surface, the increase being largest when small pressure drop is used and smallest when high pressure drop is used.
A mathematical analysis has been made to show the method of obtaining the dimensions of the intercooler that will use the least total power for a given set of design conditions. The results of this analysis have been used in a sample calculation and, on the basis of this calculation, a new inter cooler arrangement is suggested. Because the length of the two air passages of the new arrangement is short in comparison with the third dimension, the height of the intercooler, this intercooler arrangement has unusual dimensions. These dimensions give the proposed intercooler arrangement an advantage over one of usual dimensions because less total power will be consumed by the intercooler, the weight and volume of the intercooler will be smaller, and the pressure drop of both the engine air and the cooling air in passing through the intercooler will be lower.
Measurements have been made of the lift on an airfoil in pitching oscillation with a continuous-recording, instantaneous-force balance. The experimental values for the phase difference between the angle of attack and the lift are shown to be in close agreement with theory.
A study was made of the factors affecting the pressure available for ground cooling in front of a cowling. Most of the results presented were obtained with a set-up that was about one-third full scale. A number of isolated tests on four full-scale airplanes were made to determine the general applicability of the model results. The full-scale tests indicated that the model results may be applied qualitatively to full-scale design and quantitatively as a first approximation of the front pressure available for ground cooling.