Engineering topics

Kahraman, A.

Publications and source records attributed to Kahraman, A..

5 records

NASA NTRS1992

Dynamic Analysis of Geared Rotors by Finite Elements

A finite element model of a geared rotor system on flexible bearings has been developed. The model includes the rotary inertia of on shaft elements, the axial loading on shafts, flexibility and damping of bearings, material damping of shafts and the stiffness and the damping of gear mesh. The coupling between the torsional and transverse vibrations of gears were considered in the model. A constant mesh stiffness was assumed. The analysis procedure can be used for forced vibration analysis geared rotors by calculating the critical speeds and determining the response of any point on the shafts to mass unbalances, geometric eccentricities of gears, and displacement transmission error excitation at the mesh point. The dynamic mesh forces due to these excitations can also be calculated. The model has been applied to several systems for the demonstration of its accuracy and for studying the effect of bearing compliances on system dynamics.

Kahraman, A.↗

NASA NTRS1991

Error associated with a reduced order linear model of a spur gear pair

The paper proposes a reduced-order analytical model of a spur gear pair which consists of two identical spur gears, two identical flexible shafts, and four identical rolling element bearings of a given radial stiffness. The error associated with the undamped eigensolution is estimated by a comparison with a benchmark finite element model.

Kahraman, A.↗

NASA NTRS1991

Non-linear dynamics of a geared rotor-bearing system with multiple clearances

The nonlinear frequency response characteristics of a geared rotor-bearing system are examined. A three-DOF dynamic model is developed which includes nonlinearities associated with radial clearances in the radial rolling element bearings and backlash between a spur gear pair; linear time-invariant gear meshing stiffness is assumed. The corresponding linear system problem is also solved, and predicted natural frequencies and modes match with finite element method results. The applicability of both analytical and numerical solution techniques to the multi-DOF nonlinear problem is investigated. Satisfactory agreement is found between the theory presented here and the available experimental data. Nonlinear modal interactions and differences between internal static transmission error excitation and external torque excitation are discussed. In addition, parametric studies are performed to understand the effect of system parameters such as bearing stiffness to gear mesh stiffness ratio, alternating to mean force ratio and radial bearing preload to mean force ratio on the nonlinear dynamic behavior.

Kahraman, A.↗

NASA NTRS1990

Non-linear dynamics of a spur gear pair

The backlash nonlinearity excited primarily by transmission error between spur gear pairs is studied for both external and internal excitations. The digital simulation technique and the method of harmonic balance are used to develop steady state solutions for the internal sinuosidal excitations. The analytic predictions agreed well with available experimental data. Digital simulation is used to observe that at the chaotic and subharmonic resonances may exist in a gear pair depending on the mean or design load, mean to alternating force ratio, damping, and backlash.

Kahraman, A.↗

NASA NTRS1989

Dynamic analysis of geared rotors by finite elements

The finite element model of a geared rotor system on flexible bearings has been developed. The model includes the rotary inertia of shaft elements, the axial loading on shafts, flexibility and damping of bearings, material damping of shafts and the stiffness and the damping of gear mesh. The coupling between the torsional and transverse vibrations of gears were considered in the model. A constant mesh stiffness was assumed. The analysis procedure can be used for forced vibration analysis of geared rotors by calculating the critical speeds and determining the response of any point on the shaft to mass unbalances, geometric eccentricities of gears and displacement transmission error excitation at the mesh point. The dynamic mesh forces due to these excitations can also be calculated. The model has been applied to several systems for the demonstration of its accuracy and for studying the effect of bearing compliances on system dynamics.

Kahraman, A.↗