Engineering topics

Kalluri, Satya

Publications and source records attributed to Kalluri, Satya.

3 records

DOE OSTI2022

Application of a Machine Learning Algorithm in Generating an Evapotranspiration Data Product From Coupled Thermal Infrared and Microwave Satellite Observations

Land surface evapotranspiration (ET) is one of the main energy sources for atmospheric dynamics and a critical component of the local, regional, and global water cycles. Consequently, accurate measurement or estimation of ET is one of the most active topics in hydro-climatology research. With massive and spatially distributed observational data sets of land surface properties and environmental conditions being collected from the ground, airborne or space-borne platforms daily over the past few decades, many research teams have started to use big data science to advance the ET estimation methods. The Geostationary satellite Evapotranspiration and Drought (GET-D) product system was developed at the National Oceanic and Atmospheric Administration (NOAA) in 2016 to generate daily ET and drought maps operationally. The primary inputs of the current GET-D system are the thermal infrared (TIR) observations from NOAA GOES satellite series. Because of the cloud contamination to the TIR observations, the spatial coverage of the daily GET-D ET product has been severely impacted. Based on the most recent advances, we have tested a machine learning algorithm to estimate all-weather land surface temperature (LST) from TIR and microwave (MW) combined satellite observations. With the regression tree machine learning approach, we can combine the high accuracy and high spatial resolution of GOES TIR data with the better spatial coverage of passive microwave observations and LST simulations from a land surface model (LSM). The regression tree model combines the three LST data sources for both clear and cloudy days, which enables the GET-D system to derive an all-weather ET product. This paper reports how the all-weather LST and ET are generated in the upgraded GET-D system and provides an evaluation of these LST and ET estimates with ground measurements. The results demonstrate that the regression tree machine learning method is feasible and effective for generating daily ET under all weather conditions with satisfactory accuracy from the big volume of satellite observations.

54 ENVIRONMENTAL SCIENCES↗

NASA NTRS2019

Generating Accurate and Consistent Top-Of-Atmosphere Reflectance Products from the New Generation Geostationary Satellite Sensors

GeoNEX is a collaborative project by scientists from NASA, NOAA, JAXA, and other organizations around the world with the purpose of generating a suite of Earth-monitoring products using data streams from the latest geostationary (GEO) sensors including the GOES-16/17 ABI and the Himawari-8/9 AHI. An accurate and consistent top-of-atmosphere (TOA) reflectance product, in particular the bidirectional reflectance factor (BRF), is the starting point in the scientific processing chain. We describe the main considerations and corresponding algorithms in generating the GeoNEX TOA BRF product. First, a special advantage of geostationary data streams is their high temporal resolution (~10 minutes per full-disk scan), providing a key source of information for many downstream products. To fully utilize this high temporal frequency demands a high georegistration accuracy for every acquired image. Our analysis shows that there can be substantial georegistration uncertainties in both GOES and Himawari L1b data which we addressed by implementing a phase-based correction algorithm to remove residual errors. Second, geostationary sensors have distinct illumination-view geometry features in that the solar angle changes for every pixel. Therefore, to accurately derive a BRF requires a solar position algorithm and the estimation of the pixel-wise acquisition time within an uncertainty of 10 seconds. Third, we discuss the measures we adopted to check and correct residual radiometric calibration issues of individual sensors to enable time-series analysis as well as the cross calibration between different satellite sensors (including those from low-Earth orbit). Finally, we also explain the rationale for the choice of the global grid/tile system of the GeoNEX TOA BRF product.

Wang, Weile↗

NASA NTRS2019

GeoNEX: Land Monitoring from a New Generation of Geostationary Sensors

The latest generation of geostationary satellites carry sensors such as the Advanced Baseline Imager (GOES-16/17) and the Advanced Himawari Imager (Himawari-8/9) that closely mimic the spatial and spectral characteristics of MODIS and VIIRS, useful for monitoring land surface conditions. The NASA Earth Exchange (NEX) team at Ames Research Center has embarked on a collaborative effort among scientists from NASA and NOAA exploring the feasibility of producing operational land surface products similar to those from MODIS/VIIRS. The team built a processing pipeline called GEONEX that is capable of converting raw geostationary data into routine products of Fires, surface reflectances, vegetation indices, LAI/FPAR, ET and GPP/NPP using algorithms adapted from both NASA/EOS and NOAA/GOES-R programs. The GEONEX pipeline has been deployed on Amazon Web Services cloud platform and it currently leverages near-realtime geostationary data hosted in AWS public datasets under a NOAA-AWS agreement. Initial analyses of various products from ABI/AHI sensors suggest that they are comparable to those from MODIS in representing the spatio-temporal dynamics of land conditions. Cloud computing offers a variety of options for deploying the GEONEX pipeline including choice CPUs, storage media, and automation. By making the GEONEX pipeline available on the cloud, we hope to engage a broad community of Earth scientists from around the world in utilizing this new source of data for Earth monitoring.

GeoNEX↗