Search NASASearch

Engineering topics

Kandil, Hamdy A.

Publications and source records attributed to Kandil, Hamdy A..

Forced Rolling Oscillation of a 65 deg-Delta Wing in Transonic Vortex-Breakdown Flow

Unsteady, transonic, vortex dominated flow over a 65 deg. sharp-edged, cropped-delta wing of zero thickness undergoing forced rolling oscillations is investigated computationally. The wing angle of attack is 20 deg. and the free stream Mach number and Reynolds number are 0.85 and 3.23 x 10(exp 6), respectively. The initial condition of the flow is characterized by a transverse terminating shock which induces vortex breakdown of the leading edge vortex cores. The computational investigation uses the time accurate solution of the laminar, unsteady, compressible, full Navier-Stokes equations with the implicit, upwind, Roe flux difference splitting, finite-volume scheme. While the maximum roll amplitude is kept constant at 4.0 deg., both Reynolds number and roll frequency are varied covering three cases of forced sinusoidal rolling. First, the Reynolds number is held at 3.23 x 10(exp 6) and the wing is forced to oscillate in roll around the axis of geometric symmetry at a reduced frequency of 2(pi). Second, the Reynolds number is reduced to 0.5 x 10(exp 6) to observe the effects of added viscosity on the vortex breakdown. Third, with the Reynolds number held at 0.5 x 10(exp 6), the roll frequency is reduced to 1(pi) to complete the study.

Menzies, Margaret A.

Shock-vortex interaction over a 65-degree delta wing in transonic flow

Transonic flow over a 65-deg swept-back, sharp-edged, cropped delta wing is investigated computationally using the time-accurate solution of the unsteady, compressible, full Navier-Stokes equations with an implicit, upwind, flux-difference splitting, finite-volume scheme. Coarse and fine O-H grids are used to obtain the solution. The grid consists of 125 x 85 x 84 points in the wrap-around, normal, and axial directions, respectively. The results are presented for an angle of attack of 20 deg Mach number of 0.85 and Reynolds number of 3.23 x 10 exp 6. With the fine grid, the results show that a system of shocks has been captured over the upper wing surface and that the leading-edge vortex core experiences an unsteady supersonic vortex breakdown after passing through a spanwise shock near the wing trailing edge. The computed results at a certain time are in good agreement with the experimental data. Topological aspects of the vortex breakdown flowfield are also presented and discussed.

Kandil, Osama A.

Three-dimensional supersonic vortex breakdown

Three-dimensional supersonic vortex-breakdown problems in bound and unbound domains are solved. The solutions are obtained using the time-accurate integration of the unsteady, compressible, full Navier-Stokes (NS) equations. The computational scheme is an implicit, upwind, flux-difference splitting, finite-volume scheme. Two vortex-breakdown applications are considered in the present paper. The first is for a supersonic swirling jet which is issued from a nozzle into a supersonic uniform flow at a lower Mach number than that of the swirling jet. The second is for a supersonic swirling flow in a configured circular duct. In the first application, an extensive study of the effects of grid fineness, shape and grid-point distribution on the vortex breakdown is presented. Four grids are used in this study and they show a substantial dependence of the breakdown bubble and shock wave on the grid used. In the second application, the bubble-type and helix-type vortex breakdown have been captured.

Kandil, Osama A.

Supersonic vortex breakdown over a delta wing in transonic flow

The effects of freestream Mach number and angle of attack on the leading-edge vortex breakdown due to the terminating shock on a 65-degree, sharp-edged, cropped delta wing are investigated computationally, using the time-accurate solution of the laminar unsteady compressible full Navier-Stokes equations with the implicit upwind flux-difference splitting, finite-volume scheme. A fine O-H grid consisting of 125 x 85 x 84 points in the wrap-around, normal, and axial directions, respectively, is used for all the flow cases. Keeping the Reynolds number fixed at 3.23 x 10 exp 6, the Mach number is varied from 0.85 to 0.9 and the angle of attack is varied from 20 to 24 deg. The results show that, at 20-deg angle of attack, the increase of the Mach number from 0.85 to 0.9 results in moving the location of the terminating shock downstream. The results also show that, at 0.85 Mach number, the increase of the angle of attack from 20 to 24 deg results in moving the location of the terminating shock upstream. The results are in good agreement with the experimental data.

Kandil, Hamdy A.

Simulation of tail buffet using delta wing-vertical tail configuration

Computational simulation of the vertical tail buffet problem is accomplished using a delta wing-vertical tail configuration. Flow conditions are selected such that the wing primary-vortex cores experience vortex breakdown and the resulting flow interacts with the vertical tail. This multidisciplinary problem is solved successively using three sets of equations for the fluid flow, aeroelastic deflections and grid displacements. For the fluid dynamics part, the unsteady, compressible, full Navier-Stokes equations are solved accurately in time using an implicit, upwind, flux-difference splitting, finite-volume scheme. For the aeroelastic part, the aeroelastic equation for bending vibrations is solved accurately in time using the Galerkin method and the four-stage Runge-Kutta scheme. The grid for the fluid dynamics computations is updated every few time steps using a third set of interpolation equations. The computational application includes a delta wing of aspect ratio 1 and a rectangular vertical tail of aspect ratio 2, which is placed at 0.5 root-chord length downstream of the wing trailing edge. The wing angle of attack is 35 deg and the flow Mach number and Reynolds number are 0.4 and 10,000, respectively.

Kandil, Osama A.

Critical effects of downstream boundary conditions on vortex breakdown

The unsteady, compressible, full Navier-Stokes (NS) equations are used to study the critical effects of the downstream boundary conditions on the supersonic vortex breakdown. The present study is applied to two supersonic vortex breakdown cases. In the first case, quasi-axisymmetric supersonic swirling flow is considered in a configured circular duct, and in the second case, quasi-axisymmetric supersonic swirling jet, that is issued from a nozzle into a supersonic jet of lower Mach number, is considered. For the configured duct flow, four different types of downstream boundary conditions are used, and for the swirling jet flow from the nozzle, two types of downstream boundary conditions are used. The solutions are time accurate which are obtained using an implicit, upwind, flux-difference splitting, finite-volume scheme.

Kandil, Osama

Computation of compressible quasi-axisymmetric slender vortex flow and breakdown

The unsteady, compressible Navier-Stokes equations are used to compute and analyze compressible quasi-axisymmetric isolated vortices. The Navier-Stokes equations are solved using an implicit, upwind, flux difference splitting finite volume scheme. The developed three dimensional solver was verified by comparing its solution profiles with those of a slender, quasi-axisymmetric vortex solver for a subsonic, quasi-axisymmetric vortex in an unbounded domain. The Navier-Stokes solver is then used to solve for a supersonic, quasi-axisymmetric vortex flow in a configured circular duct. Steady and unsteady vortex-shock interactions and breakdown were captured. The problem was also calculated using the Euler solver of the same code; the results were compared with those of the Navier-Stokes solver. The effect of the initial swirl was investigated.

Kandil, Osama A.

Supersonic quasi-axisymmetric vortex breakdown

An extensive computational study of supersonic quasi-axisymmetric vortex breakdown in a configured circular duct is presented. The unsteady, compressible, full Navier-Stokes (NS) equations are used. The NS equations are solved for the quasi-axisymmetric flows using an implicit, upwind, flux difference splitting, finite volume scheme. The quasi-axisymmetric solutions are time accurate and are obtained by forcing the components of the flowfield vector to be equal on two axial planes, which are in close proximity of each other. The effect of Reynolds number, for laminar flows, on the evolution and persistence of vortex breakdown, is studied. Finally, the effect of swirl ration at the duct inlet is investigated.

Kandil, Osama A.

Computation of steady and unsteady compressible quasi-axisymmetric vortex flow and breakdown

The unsteady, compressible Navier-Stokes equations are used to compute and analyze compressible quasi-axisymmetric isolated vortices. The Navier-Stokes equations are solved using an implicit, upwind, flux-difference splitting finite-volume scheme. The developed three-dimensional solver has been verified by comparing its solution profiles with those of a slender, quasi-axisymmetric vortex solver for a subsonic, isolated quasi-axisymmetric vortex in an unbounded domain. The Navier-Stokes solver is then used to solve for a supersonic quasi-axisymmetric vortex flow in a configured circular duct. Steady and unsteady vortex-shock interactions and breakdown have been captured. The problem has also been calculated using the Euler solver of the same code and the results are compared with those of the Navier-Stokes solver. The effect of the initial swirl has been tentatively studied.

Kandil, Osama A.

Supersonic quasi-axisymmetric vortex breakdown

An extensive computational study of supersonic quasi-axisymmetric vortex breakdown in a configured circular duct is presented. The unsteady, compressible, full Navier-Stokes (NS) equations are used for the present computational study. The NS equations are solved for quasi-axisymmetric flow using an implicit, upwind, flux-difference splitting, finite-volume scheme. The quasi-axisymmetric solutions are time accurate and are obtained by forcing the components of the flowfield vector to be equal on two axial planes, which are in close proximity of each other. The computational study addresses the effect of the Reynolds number, for laminar flows, on the evolution and persistence of vortex breakdown. The effect of boundary conditions at the duct exit on vortex breakdown is also studied. Finally, the effect of swirl ratio at the duct inlet is investigated.

Kandil, Osama A.

Computation and control of asymmetric vortex flow around circular cones using Navier-Stokes equations

The unsteady, compressible, thin-layer and full Navier-Stokes equations are used to numerically simulate steady and unsteady asymmetric, supersonic, locally conical flows around a 5-deg semiapex angle circular cone. The main computational scheme is the implicit, upwind, flux-difference splitting, finite-volume scheme. Comparison of asymmetric flow solutions using the thin-layer and full Navier-Stokes equations is presented and discussed. The implicit, upwind, flux-vector splitting, finite-volume scheme has also been used to solve for the unsteady asymmetric flow with vortex shedding. The unsteady-flow solution using the flux-vector splitting scheme perfectly agrees with the previously obtained solution using the flux-difference splitting scheme. Passive control of asymmetric flows has been demonstrated and studied using sharp- and round-edged, thick and thin strakes.

Kandil, Osama A.