Search NASA⌕ Search

Engineering topics

Kanipe, D. B.

Publications and source records attributed to Kanipe, D. B..

8 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1982

Plume/flowfield jet interaction effects on the Space Shuttle Orbiter during entry

A comparison of wind tunnel test results with actual flight test data from the performance of the Orbiter Reaction Control System during the STS-1 and -2 flights is presented. Jet interaction phenomena were modeled analytically and a decision was made to develop a jet interaction scaling parameter from empirical measurements wherever possible. A number of different scaling parameters resulted, and errors bounds were determined for tunnel-to-tunnel differences, model to tunnel differences, balance accuracy, real gas effects, varying nozzle configurations, and angle of sideslip. Flight test data has concentrated on the lateral/directional jet interaction of the aft yaw jets, which operate almost continuously from entry down to Mach 1 conditions. A discussion of rolling moments, side forces, and results of usage of the aft pitch and roll jets indicates an underprediction of the side force and yawing moment and overprediction of pitch and roll jet effects.

Kanipe, D. B.↗
NASA NTRS1981

Space Shuttle entry aerodynamic comparisons of flight 1 with preflight predictions

Results of comparisons of predictions of aerodynamic performance, longitudinal trim, and reaction control jet interaction with data from the initial Shuttle flight are presented. The Shuttle's control surfaces are described, and it is noted that the flight plan contained no provisions for maneuvering capability tests. Wind tunnel testing totaling 35,000 hr were used to replace graduated flight testing, and calculations were made to allow for nonsimulated structural deformation, flowfield parameters, and profile drag. The goal was to desensitize the flight control system with respect to the aerodynamics by adding variations to the predictions. Lift/drag agreed well above Mach 1, while lower drag was encountered below Mach 1. Trim characteristics were predicted accurately between Mach 2-10, and less than satisfactorily outside that range. Discrepancies were also observed for jet interaction effects for the aft yaw jets at Mach numbers greater than 10.

Young, J. C.↗
NASA NTRS1976

Results of test MA22 in the NASA/LaRC 31-inch CFHT on an 0.010-scale model (32-0) of the space shuttle configuration 3 to determine RCS jet flow field interaction, volume 1

A wind tunnel test was conducted in the Langley Research Center 31-inch Continuous Flow Hypersonic Wind Tunnel from May 6, 1975 through June 3, 1975. The primary objectives of this test were the following: (1) to study the ability of the wind tunnel to repeat, on a run-to-run basis, data taken for identical configurations to determine if errors in repeatability could have a significant effect on jet interaction data, (2) to determine the effect of aerodynamic heating of the scale model on jet interaction, (3) to investigate the effects of elevon and body flap deflections on jet interaction, (4) to determine if the effects from jets fired separately along different axes can be added to equal the effects of the jets fired simultaneously (super position effects), (5) to study multiple jet effects, and (6) to investigate area ratio effects, i.e., the effect on jet interaction measurements of using wind tunnel nozzles with different area ratios in the same location. The model used in the test was a .010-scale model of the Space Shuttle Orbiter Configuration 3. The test was conducted at Mach 10.3 and a dynamic pressure of 150 psf. RCS chamber pressure was varied to simulate free flight dynamic pressures of 5, 7.5, 10, and 20 psf.

Kanipe, D. B.↗