Engineering topics

Kapsimalis, Roger J.

Publications and source records attributed to Kapsimalis, Roger J..

7 records

DOE OSTI2023

Pressure-induced evolution of the lattice dynamics for selected UO 3 polymorphs

Uranium trioxide (UO 3 ) is a stable chemical form of uranium oxide with multiple polymorphs found throughout the nuclear fuel cycle. The pressure-induced changes in the structure and lattice dynamics of four of these polymorphs are simulated with density functional perturbation theory and analyzed. Two phases, α- and δ-UO 3 are found to exhibit an isotropic response to pressure and do not undergo any changes in coordination geometry up to ~40 GPa. In contrast, the other two phases investigated, β- and γ-UO 3 , exhibit an anisotropic response to pressure. Decomposition of the phonon eigenvectors allows us to assign specific pressure-induced structural changes to individual phonon modes. Here, this analysis has been performed on a per atom basis for the relatively simple α- and δ-UO 3 structures, which have one symmetrically unique uranium site, and on a per coordination environment basis for β- and γ-UO 3 , which have multiple U sites.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

DOE OSTI2022

Product specific thermal degradation kinetics of bisphenol F epoxy in inert and oxidative atmospheres using evolved gas analysis–mass spectrometry

Knowledge of the degradation kinetics for polymer materials is important for understanding thermal stability. In this study, evolved gas analysis–mass spectrometry and pyrolysis gas-chromatography-mass spectrometry were evaluated for the potential to deliver additional insight into thermal degradation kinetics of diglycidal ether of bisphenol F (DGEBF) epoxy thermoset under inert and oxidative atmospheres. Degradation products of selected precursor ions were evaluated for their uniqueness to the specific precursor using extracted ion thermographs. Unique mass peaks, solely attributed to a single reaction pathway of a specific product, were determined from extracted ion thermographs and used to determine both activation energy (E a ) and pre-exponential factors for the specific primary reaction pathways. These primary reaction pathways for DGEBF epoxy degradation were then evaluated in the context of transition state theory (TST) and related transition state enthalpies (ΔH ‡ ) and entropies (ΔS ‡ ) of activation to further elucidate the degradation process. It was determined under pyrolysis conditions, as suggested by the E a , the formation of bisphenol F monomer was the rate-limiting step toward the formation of xanthene and phenol. In contrast, under thermo-oxidative conditions, reactions involving oxygen containing species were identified as the rate-limiting step for all observed products based on the large negative ΔS ‡ calculated from TST. This work demonstrates a powerful combination of technique and theory that can provide new insight into the degradation of polymer materials.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2021

Optical vibrational spectra and proposed crystal structure of ε-UO 3

ε-UO 3 is an exotic polymorph in the uranium trioxide system with an undetermined crystal structure and limited optical vibrational spectroscopic data. To improve understanding of this compound, we synthesize and investigate the crystal structure and optical vibrational spectra of ε-UO 3 . Infrared spectra collected for ε-UO 3 are in good agreement with previously published results, and our studies extend the available data into the low-energy (600–100 cm –1 ) regime. For the first time, Raman spectra are presented for ε-UO 3 using both 785 and 532 nm excitation wavelengths. Previous reports suggest an impurity phase may be present in ε-UO 3 produced by calcination of U 3 O 8 ; however, spectral center-of-mass calculations, principal component analyses, and Raman spectroscopic mapping employed to investigate this possibility indicate that the product of U 3 O 8 calcined in O 3 (g) in this work is likely phase-pure. A possible novel structure solution for ε-UO 3 is determined via Rietveld refinement of powder X-ray diffraction data and is triclinic, P-1, with a = 4.01 Å, b = 3.85 Å, c = 4.18 Å, and α = 98.26°, β = 90.41°, γ = 120.46° (R wp = 8.30%). The asymmetric unit of ε-UO 3 consists of U(VI) in hexagonal bipyramidal coordination with displaced equatorial oxygen. Further analysis reveals that the structure of ε-UO3 is best described by a 2 × 1 × 2 supercell structure in P-1 with a = 8.03 Å, b = 3.86 Å, c = 8.37 Å with α = 98.26°, β = 90.41°, and γ = 120.46°, although a higher-symmetry structure is possible. Optical vibrational spectroscopic and structural measurements of ε-UO 3 presented here furthers our understanding of this complex uranium oxide and clarifies the origin of reported structural similarity to U 3 O 8 .

-UO3↗

DOE OSTI2021

Reviewing computational studies of defect formation and behaviors in carbon fiber structural units

Solid-state carbon materials, such as graphite and graphene, are at the forefront of materials research because of their unique electronic, vibrational, and mechanical properties, leading to a broad range of potential and realized applications. One key application is their role as basic structural units of carbon fiber (CF), a lightweight alternative to steel. In CF, a delicate relationship exists between ultimate material strength and the atomic-scale density of defects contained at the inter- and intra-subunit levels. Computational studies provide insight into the stability of various types of defects that can form in these systems and connect with experimental observables such as bandgap and spectroscopic measurements. Therefore, the literature contains many computational studies that focus on changes induced by defects, including vacancies and Dienes transformations (Stone-Wales and Thrower defects). However, wide-ranging methods and cell sizes have been used, and property-specific information is often lacking. Furthermore, this review summarizes key literature findings, paying particular attention to changes in the electronic, vibrational, and mechanical properties induced by defects in graphitic materials relevant to CF.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Influence of temperature on accessible pyrolysis pathways of homopolymerized bisphenol A/F epoxies and copolymers

Understanding the thermal pyrolysis of epoxies and their copolymers is important for identifying structural changes resultant from thermal transients, enabling identification of failure modes of high-performance composite materials. This work expands our understanding of the thermal pyrolysis of cured epoxies and the role of temperature and composition on products, pathways, and relative rates. Numerous researchers have explored the pyrolysis of bisphenol A (BPA) epoxy. Significantly fewer have studied bisphenol F (BPF), and copolymers of BPA and BPF have been neglected. In this work, a pyrolysis gas chromatography mass spectrometer (PY-GC-MS) was used to investigate the degradation mechanism of homopolymerized BPA, BPF epoxies and their copolymers. Additionally, for polymer identification, pyrolysis >450 °C resulted in the most extensive fragmentation and is useful for material identification, though lower temperatures show different degradation product profiles that provide mechanistic insight into thermal degradation pathways. Temperature greatly influences the accessible pyrolysis pathways of BPA, revealing dual mechanisms of formation for products p-isopropylphenol and p-isopropenylphenol. For BPF at low pyrolysis temperature the p,p-bisphenol F isomer is produced at significantly lower relative abundance compared to the abundance at higher temperatures tested, but production of the other two isomers changes little with respect to temperature. This suggests the epoxy components consisting of the p,p-bisphenol F isomer have higher thermal stability. Overall, the copolymer epoxies were found to have similar degradation products in stoichiometric distributions. The major exception was the formation of the p,p-bisphenol F isomer, which shows evidence of thermal stabilizing effects from addition of BPA epoxy.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Structural, Spectroscopic, and Kinetic Insight into the Heating Rate Dependence of Studtite and Metastudtite Dehydration

Uranyl peroxide minerals studtite (UO 2 O 2 ·4H 2 O) and metastudtite (UO 2 O 2 ·2H 2 O) are important materials in the nuclear fuel cycle. When heated, they dehydrate and transform to amorphous uranium oxides (UO x ), yet phase stability and heating rate dependence of these transformations are poorly understood. This information is critical to proper management of fuel cycle materials. In this work, we use in situ powder X-ray diffraction (PXRD), Raman spectroscopy, and thermogravimetric analysis (TGA) to monitor the dehydration of studtite and metastudtite. Strong linear correlation between the heating rate and phase transition temperature is observed. Geometric contraction and diffusion-related kinetic models describe studtite dehydration at slow heating rates, whereas Avrami–Erofeev or reaction order models become more accurate for faster thermal treatments. A second order model describes the transition from metastudtite to UO x regardless of the heating rate. Water retention during studtite dehydration is indicated by PXRD, Raman spectroscopy, and TGA. Here, we observe mixed-phase UO x dehydration products of metastudtite with a likely formation mechanism involving conversion of some uranyl centers from hexagonal to pentagonal bipyramidal coordination units via peroxide liberation. Our observations clarify over 100 years of measurements on these materials and represent an advancement in understanding the chemical behavior of nuclear fuel cycle materials.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2020

Computationally Guided Investigation of the Optical Spectra of Pure β-UO 3

Single-phase β-UO 3 is synthesized by flash heating UO 2 (NO 3 )·6H 2 O in air to 450 °C and annealing for 60 h under the same conditions. For the first time, we report the Raman spectra of pure β-UO 3 . To facilitate the assignment of Raman and infrared vibrational modes, we use density functional theory with density functional perturbation theory. By employing a novel analysis scheme that includes the mode frequencies as well as a quantitative analysis of the mode eigenvectors, we assign the observed spectral features to individual chemical modes. In particular, the density functional theory optimized structure, observed Raman spectrum, and eigenvector analysis suggest the presence of four crystallographically distinct uranyl ions, one more than has previously been suggested.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗