Engineering topics

Karasiev, V. V.

Publications and source records attributed to Karasiev, V. V..

8 records

DOE OSTI2023

Laser-direct-drive fusion target design with a high- Z gradient-density pusher shell

Laser-direct-drive fusion target designs with solid deuterium-tritium (DT) fuel, a high-Z gradient-density pusher shell (GDPS), and a Au-coated foam layer have been investigated through both 1D and 2D radiation-hydrodynamic simulations. Compared with conventional low-Z ablators and DT-push-on-DT targets, these GDPS targets possess certain advantages of being instability-resistant implosions that can be high adiabat (α ≥ 8) and low hot-spot and pusher-shell convergence (CR hs ≈ 22 and CR PS ≈ 17), and have a low implosion velocity (v imp < 3 × 10 7 cm/s). Using symmetric drive with laser energies of 1.9 to 2.5 MJ, 1D LILAC simulations of these GDPS implosions can result in neutron yields corresponding to >~50–MJ energy, even with reduced laser absorption due to the cross-beam energy transfer (CBET) effect. Two-dimensional DRACO simulations show that these GDPS targets can still ignite and deliver neutron yields from 4 to ~10 MJ even if CBET is present, while traditional DT-push-on-DT targets normally fail due to the CBET-induced reduction of ablation pressure. If CBET is mitigated, these GDPS targets are expected to produce neutron yields of >20 MJ at a driven laser energy of ~2 MJ. Here are the key factors behind the robust ignition and moderate energy gain of such GDPS implosions are as follows: (1) The high initial density of the high-Z pusher shell can be placed at a very high adiabat while the DT fuel is maintained at a relatively low-entropy state; therefore, such implosions can still provide enough compression ρR >1 g/cm 2 for sufficient confinement; (2) the high-Z layer significantly reduces heat-conduction loss from the hot spot since thermal conductivity scales as ~1/Z; and (3) possible radiation trapping may offer an additional advantage for reducing energy loss from such high-Z targets.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2021

Ionization state and dielectric constant in cold rarefied hydrocarbon plasmas of inertial confinement fusion

A combined approach to study cold rarefied matter is introduced that includes a semianalytical method based on the free-energy minimization and ab initio calculations based on the finite-temperature density-functional theory. The approach is used to calculate the ionization state of hydrocarbon (CH) under the shock-release conditions in inertial confinement fusion. Furthermore, the dielectric constant of CH is calculated using the Kubo-Greenwood formulation and contribution from atomic polarizabilities is found to be as important as the free-electron contribution. Using the ionization state and dielectric constant, the electron density profile in the rarefaction wave of the shock-release plasma is obtained.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2021

Improved first-principles equation-of-state table of deuterium for high-energy-density applications

Here, we present a first-principles equation-of-state (EOS) table of deuterium aimed at improving the previously established first-principles equation-of-state table (FPEOS). The EOS table presented here, referred to as iFPEOS, introduces (1) a universal density functional theory (DFT) treatment of all density and temperature conditions, (2) a fully consistent treatment of exchange-correlation (XC) thermal effects across the entire range of temperatures covered, and (3) quantum treatment of ions. Based on ab initio molecular dynamics driven by thermal density functional theory, iFPEOS includes density points in the range 1×10 –3 $\leqslant$ ρ $\leqslant$ 1.6×10 3 g/cm 3 and temperature points in the range 800 K $\leqslant$ T $\leqslant$ 256 MK, thus covering the challenging warm dense matter (WDM) regime. For an improved description of the electronic structure, iFPEOS employs an advanced free-energy XC density functional with explicit temperature dependence, which is at the metageneralized gradient approximation level of DFT. We use the latest orbital-free free-energy density functional for the high-temperature regime where it shows excellent agreement with standard Mermin-Kohn-Sham DFT. For quantum treatment of ions we use path-integral molecular dynamics in order to take into account nuclear quantum effects. Results are compared to other EOS models and most recent experimental measurements of deuterium properties such as the molecular-toatomic fluid transition, the principal and reshock Hugoniot, and sound speed. We find that iFPEOS provides an improved agreement with experimental data compared to other first-principles EOS models in the WDM regime for pressures up to 200 GPa and temperatures up to 60 000 K. For higher pressures and temperatures, however, iFPEOS is in agreement with other models in predicting lower compressibility and higher sound speed along the Hugoniot, compared to experiment.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

DOE OSTI2021

Density evolution after shock release from laser-driven polystyrene (CH) targets in inertial confinement fusion

The evolution of the plasma density in the rarefaction wave formed after a laser-driven shock is released from a CH foil was measured using optical interferometry. Here, it was found that the plasma density profile is very sensitive to the conditions at the back surface of the foil before the shock release. Dedicated experiments demonstrated that radiation preheat by coronal x-rays caused early expansion of the back surface and faster expansion of the rarefaction wave. Radiation-hydrodynamics simulations with accurate modeling of radiation preheat from the plasma corona are in good agreement with the experimental results. The early expansion of material interfaces due to coronal x-ray preheat must be evaluated in designing and interpreting laser-driven inertial confinement fusion experiments.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2020

Thermal effects on the electronic properties of sodium electride under high pressures

Sodium is a simple metal at ambient conditions, while it transits to an electride phase at pressures above ~160 GPa along the room temperature isotherm. Here we explore the thermal effects on the electronic properties of the $hP4$ phase of sodium along the $ρ$ = 5.872 g/cm 3 isochore. We quantitatively classify this phase as an insulator based on the criterion of nearsightedness of the one-particle density matrix. Ab initio calculations suggest that the band gap of this insulator decreases with increasing temperature along the isochore, primarily because of ionic distortions; culminating in an insulator-to-metal transition upon melting at $T_m \approx 2100$ $\hbox{K}$. This transition is accompanied by residual electronic localization (in d orbitals) in the form of dynamic electron bubbles and a change in hybridization form $p–d$ to $s–p$ upon melting. This transition is explored by tracking the electronic and electro-optical properties along the isochore under consideration.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Thermal hybrid exchange-correlation density functional for improving the description of warm dense matter

Finite-temperature density functional theory (FT-DFT) has become a standard tool for first principles calculations of the properties of warm dense matter (WDM) relevant to high-energy density physics (HEDP) applications. In this work we introduce theoretical grounds of thermal hybrid exchange-correlation (XC) functionals within the generalized Mermin-Kohn-Sham scheme for an improved description of WDM. Building on the previously developed KSDT (Karasiev-Sjostrom-Dufty-Trickey) [Karasiev et al., Phys. Rev. Lett. 112, 076403 (2014)] local density approximation (LDA) and the KDT16 (Karasiev-Dufty-Trickey 2016) [Karasiev et al., Phys. Rev. Lett. 120, 076402 (2018)] generalized-gradient approximation (GGA) XC free-energy density functionals, we construct a new thermal hybrid XC functional, referred to here as KDT0. The KDT0 model at low temperature reduces to the popular ground-state PBE0 hybrid due to properties of the used KDT16 density functional approximation. Application to static calculations of electronic band gap and band structure at a wide range of temperatures for various systems of interest to HEDP show that KDT0 provides a significant improvement to the lower LDA and GGA rung XC functionals and to the ground-state PBE0 hybrid.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Interspecies radiative transition in warm and superdense plasma mixtures

Superdense plasmas widely exist in planetary interiors and astrophysical objects such as brown-dwarf cores and white dwarfs. How atoms behave under such extreme-density conditions is not yet well understood, even in single-species plasmas. Here, we have applied thermal density functional theory to investigate the radiation spectra of superdense iron–zinc plasma mixtures at mass densities of ρ = 250 to 2000 g cm -3 and temperatures of kT = 50 to 100 eV, accessible by double-shell–target implosions. Our ab initio calculations reveal two extreme atomic-physics phenomena—firstly, an interspecies radiative transition; and, secondly, the breaking down of the dipole-selection rule for radiative transitions in isolated atoms. Our first-principles calculations predict that for superdense plasma mixtures, both interatomic radiative transitions and dipole-forbidden transitions can become comparable to the normal intra-atomic Kα-emission signal. These physics phenomena were not previously considered for extreme high-density plasma mixtures at super-high energy densities.

79 ASTRONOMY AND ASTROPHYSICS↗

DOE OSTI2020

Towards accurate orbital-free simulations: A generalized gradient approximation for the noninteracting free energy density functional

For orbital-free ab initio molecular dynamics, especially on systems in extreme thermodynamic conditions, we provide the first pseudo-potential-adapted generalized gradient approximation (GGA) functional for the non-interacting free energy. This is achieved by systematic finite-temperature extension of our recent LKT ground state non-interacting kinetic energy GGA functional (Phys. Rev. B 98, 041111(R) (2018)). We test the performance of the new functional first via static lattice calculations on crystalline aluminum and silicon. Then we compare deuterium equation of state results against both path-integral Monte Carlo and conventional (orbital-dependent) Kohn-Sham results. The new functional, denoted LKTF, outperforms the previous best semi-local free energy functional, VT84F (Phys. Rev. B 88, 161108(R) (2013)), and provides modestly faster simulations. Finally, we discuss subtleties of identification of kinetic and entropic contributions to non-interacting free-energy functionals obtained by extension from ground state orbital-free kinetic energy functionals.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗