Search NASA⌕ Search

Engineering topics

Karman, Steve

Publications and source records attributed to Karman, Steve.

Fast-airflow tumble clothes dryer with small thermoelectric heat pump: Experimental evaluation

Residential clothes drying accounts for about 5% of the total residential-sector energy consumption in the United States. Most dryers use electric resistance heaters to dry clothes and have low efficiencies. Higher-efficiency dryers that use vapor compression heat pumps are expensive and complex and have not gained a large market share in the United States. A novel tumble clothes dryer using a small thermoelectric heat pump with faster airflow than typical dryers is presented in this work. The benchtop performance of the thermoelectric heat pump and high-speed blower are presented, and the development of the prototype dryer is described. The dryer was tested for efficiency and dry time for a range of airflow rates and applied currents to the thermoelectric heat pump. The combined efficiency factor was 5.09–6.29 lb BDW /kWh (specific moisture extraction rate of 1.23–1.53 kg w /kWh) with 100–138 min dry times for these tests. The measured efficiency was 36 %–68 % greater than the minimum efficiency standard in the United States, and compared with vapor compression heat pump–based clothes dryers, the prototype dryer had less expensive, less complex components and did not use refrigerants. Finally, the performance of this small thermoelectric heat pump clothes dryer is also compared with previous iterations of the thermoelectric tumble clothes dryer described in the literature.

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗

Performance Modeling of a Thermoelectric Heat Pump Clothes Dryer with Very High Air Flow

Previous research has shown that a clothes dryer heated by thermoelectric (Peltier) heat pumps can be up to 85% more efficient than a conventional electric-resistance dryer. A previous thermoelectric prototype used a conventional dryer’s air flow of 120 ft3/min (0.06 m3/s) and provided about 1,300 W of thermoelectric heating capacity at a heating coefficient of performance (COP) of approximately 1.2. In this work, the performance of a clothes dryer with a very high air flow rate, up to 300 ft3/min (1.14 m3/s), and only 400 W of thermoelectric heating capacity was investigated using a thermohydraulic model. Key aspects of the model were validated experimentally. Results for dry time and efficiency are presented for various air flow and heating rates.

Boudreaux, Philip↗

HLPW-4/GMGW-3: High Order Discretization Technology Focus Group Workshop Summary

This paper summarizes the High-Order Technical Focus Group (HO-TFG) submissions for the joint 4th AIAA High Lift Prediction and 3rd Geometry and Mesh Generation Workshop. The goal of the workshop was to assess the state-of-the-art in mesh generation and computational fluid dynamics software. The Common Research Model High-Lift (CRM-HL) variant served as the primary focus of the workshop, and a 2D airfoil section from the CRM-HL was used as a verification test case. The HO-TFG was tasked with generating high-order curved meshes for both geometries, and computing high-order solutions using both Reynolds Averaged Navier-Stokes and scale resolving formulations. While limited by computational resources, the final results demonstrate the potential of higher-order methods to increase solution accuracy with a lower degree of freedom count relative to second-order discretizations.

Galbraith, Marshall C.↗