Search NASASearch

Engineering topics

Kavsaoglu, M. S.

Publications and source records attributed to Kavsaoglu, M. S..

Rectangular jets in a crossflow

Rectangular jets injected from a flat plate into a crossflow at large angles have been studied. Results were obtained as surface pressure distributions, mean velocity vector plots, turbulence intensities, and Reynolds stresses in the jet plume. The length-to-width ratio of the jets was 4, and the jets were aligned streamwise as single and side-by-side dual jets. The jet injection angles were 90 and 60 deg. Surface pressure distribution results were obtained for jet-to-freestream velocity ratios of 2.2, 4, and 8. Mean flow and turbulence flowfield data were obtained for the side-by-side dual jets, mainly for the jet-to-freestream velocity ratio of 4. The jets featured strong negative pressure peaks near the front nozzle corners. The 60-deg jets produced lower magnitude negative pressures, which are distributed over a lesser area when compared to the 90-deg jets.

Kavsaoglu, M. S.

Effects of swirl and high turbulence on a jet in a crossflow

An experimental study has been conducted on the effects of initial swirl and high turbulence in the exhaust of a circular jet injected from a flat plate at a 90-deg angle into a crossflow. The different jet types studied were low-exit turbulence (3 percent), high-exit turbulence (over 10 percent), and 40 and 58 percent swirl. Surface pressure distributions and mean velocity vector plots were obtained for all of these cases. For the surface pressure distribution tests, the jet to crossflow velocity ratios R were 2.2, 4, and 8 for most of the jet types. For the mean velocity vector plots, R = 4 was chosen. Turbulence information in the jet plume was also obtained for the low-exit turbulence case at R = 4. The results showed that the higher-exit turbulence reduced the penetration height, and it also reduced the surface area influenced by negative pressures. The swirl-caused asymmetric pressure distributions and the swirl effects were more pronounced for lower-velocity ratios.

Kavsaoglu, M. S.