Engineering topics

Kazakov, Ye O.

Publications and source records attributed to Kazakov, Ye O..

8 records

DOE OSTI2024

Overview of Large Helical Device experiments of basic plasma physics for solving crucial issues in reaching burning plasma conditions

Recently, experiments on basic plasma physics issues for solving future problems in fusion energy have been performed on a Large Helical Device. There are several problems to be solved in future devices for fusion energy. Emerging issues in burning plasma are: alpha-channeling (ion heating by alpha particles), turbulence and transport in electron dominant heating helium ash exhaust, reduction of the divertor heat load. To solve these problems, understanding the basic plasma physics of (1) wave–particle interaction through (inverse) Landau damping, (2) characteristics of electron-scale (high-k) turbulence, (3) ion mixing and the isotope effect, and (4) turbulence spreading and detachment, is necessary. This overview discusses the experimental studies on these issues and turbulent transport in multi-ion plasma and other issues in the appendix.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2023

Overview of interpretive modelling of fusion performance in JET DTE2 discharges with TRANSP

In the paper we present an overview of interpretive modelling of a database of JET-ILW 2021 D-T discharges using the TRANSP code. The main aim is to assess our capability of computationally reproducing the fusion performance of various D-T plasma scenarios using different external heating and D-T mixtures, and to understand the performance driving mechanisms. We find that interpretive simulations confirm a general power-law relationship between increasing external heating power and fusion output, which is supported by absolutely calibrated neutron yield measurements. A comparison of measured and computed D-T neutron rates shows that the calculations' discrepancy depends on the absolute neutron yield. The calculations are found to agree well with measurements for higher performing discharges with external heating power above ~20 MW, while low-neutron shots display an average discrepancy of around +40% compared to measured neutron yields. A similar trend is found for the ratio between thermal and beam-target fusion, where larger discrepancies are seen in shots with dominant beam-driven performance. We compare the observations to studies of JET-ILW D discharges, to find that on average the fusion performance is well modelled over a range of heating power, although an increased unsystematic deviation for lower-performing shots is observed. The ratio between thermal and beam-induced D-T fusion is found to be increasing weakly with growing external heating power, with a maximum value of ≳1 achieved in a baseline scenario experiment. An evaluation of the fusion power computational uncertainty shows a strong dependence on the plasma scenario type and fusion drive characteristics, varying between ±25% and 35%. D-T fusion alpha simulations show that the ratio between volume-integrated electron and ion heating from alphas is ≲10 for the majority of analysed discharges. Alphas are computed to contribute between ~15% and 40% to the total electron heating in the core of highest performing D-T discharges. An alternative workflow to TRANSP was employed to model JET D-T plasmas with the highest fusion yield and dominant non-thermal fusion component because of the use of fundamental radio-frequency heating of a large minority in the scenario, which is calculated to have provided ~10% to the total fusion power.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2023

Experiments on excitation of Alfvén eigenmodes by alpha-particles with bump-on-tail distribution in JET DTE2 plasmas

Dedicated experiments were performed in JET DTE2 plasmas for obtaining an α-particle bump-on-tail (BOT) distribution aiming at exciting Alfvén eigenmodes (AEs). Neutral beam injection-only heating with modulated power was used so that fusion-born α-particles were the only ions present in the MeV energy range in these DT plasmas. The beam power modulation on a time scale shorter than the α-particle slowing down time was chosen for modulating the α-particle source and thus sustaining a BOT in the α-particle distribution. High-frequency modes in the toroidicity-induced Alfven eigenmode (TAE) frequency range and multiple short-lived modes in a wider frequency range have been detected in these DT discharges with interferometry, soft x-ray cameras, and reflectometry. The modes observed were localised close to the magnetic axis and were not seen in the Mirnov coils. Analysis with the TRANSP and Fokker-Planck FIDIT codes confirms that α-particle distributions with BOT in energy were achieved during some time intervals in these discharges though no clear correlation was found between the times of the high-frequency mode excitation and the BOT time intervals. The combined magneto-hydrodynamic (MHD) and kinetic modelling studies show that the high-frequency mode in the TAE frequency range is best fitted with a TAE of toroidal mode number n= 9. This mode is driven mostly by the on-axis beam ions while the smaller drive due to the pressure gradient of α-particles allows overcoming the marginal stability and exciting the mode. The observed multiple short-lived modes in a wider frequency range are identified as the on-axis kinetic AEs predicted in Rosenbluth and Rutherford.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2023

PFPO plasma scenarios for exploration of long pulse operation in ITER

Long Pulse Scenarios (LPS) in ITER foreseen during the Pre-Fusion Power Operation (PFPO) phase of the ITER Research Plan (IRP) are assessed using 1.5D transport simulations within the ASTRA framework. Such assessment is required to predict the operational space for LPS operation in PFPO, as well as to evaluate which physics processes for LPS operation during Fusion Power Operation (FPO) could be studied during PFPO. An important aspect in the development of LPSs in PFPO is to minimize lifetime consumption of the Central Solenoid (CS) for these scenarios. The maximum pulse length achievable for LPSs in PFPO with no consumption of CS lifetime (currents in CS coils $&LessSlantEqual;$30 kA per turn) has been assessed for a range of heating schemes and heating mixes, confinement regimes (L-mode and H-mode) and for helium and hydrogen plasmas. The operational space of LPS and pulse length has been explored through density scans with the Heating and Current Drive mix required for the FPO Q $&GreaterSlantEqual;$ 5 steady-state plasma scenario (namely Neutral Beam Injection and Electron Cyclotron Heating) including acceptable shine through losses on the first wall for both helium and hydrogen plasmas. Fast particle physics aspects that are common between FPO plasmas and LPS PFPO H-mode plasmas at low densities are studied including MHD stability analysis with the KINX code and non-perturbative critical gradient model based on high-n Toroidal Alfven Eigenmodes (TAE) stability kinetic ballooning code HINST calculations.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

Simultaneous measurements of unstable and stable Alfvén eigenmodes in JET

Here, we report the novel experimental observation of both unstable and stable toroidicity-induced Alfvén eigenmodes (TAEs) measured simultaneously in a JET tokamak plasma. The three-ion-heating scheme (D-DNBI-3He) is employed to accelerate deuterons to MeV energies, thereby destabilizing TAEs with toroidal mode numbers n = 3–5, each decreasing in mode amplitude. At the same time, the Alfvén eigenmode active diagnostic resonantly excites a stable n = 6 TAE with total normalized damping rate –γ/ω 0 ≈ 1%–4%. Hybrid kinetic-MHD modeling with codes NOVA-K and MEGA both find eigenmodes with similar frequencies, mode structures, and radial locations as in experiment. NOVA-K demonstrates good agreement with the n = 3, 4, and 6 TAEs, matching the damping rate of the n = 6 mode within uncertainties and identifying radiative damping as the dominant contribution. Improved agreement is found with MEGA for all modes: the unstable n = 3–5 and stable n = 2, 6 modes, with the latter two stabilized by higher intrinsic damping and lower fast ion drive, respectively. While some discrepancies remain to be resolved, this unique validation effort gives us confidence in TAE stability predictions for future fusion devices.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

A novel measurement of marginal Alfvén eigenmode stability during high power auxiliary heating in JET

The interaction of Alfvén eigenmodes (AEs) and energetic particles is one of many important factors determining the success of future tokamaks. In JET, eight in-vessel antennas were installed to actively probe stable AEs with frequencies ranging 25–250 kHz and toroidal mode numbers |n| < 20. During the 2019–2020 deuterium campaign, almost 7500 resonances and their frequencies f 0 , net damping rates γ < 0, and toroidal mode numbers were measured in almost 800 plasma discharges. From a statistical analysis of this database, continuum and radiative damping are inferred to increase with edge safety factor, edge magnetic shear, and when including non-ideal effects. Both stable AE observations and their associated damping rates are found to decrease with |n|. Active antenna excitation is also found to be ineffective in H-mode as opposed to L-mode; this is likely due to the increased edge density gradient’s effect on accessibility and ELM-related noise’s impact on mode identification. A novel measurement is reported of a marginally stable, edge-localized ellipticity-induced AE probed by the antennas during high-power auxiliary heating (ion cyclotron resonance heating and neutral beam injection) up to 25 MW. NOVA-K kinetic-MHD simulations show good agreement with experimental measurements of f 0 , γ, and n, indicating the dominance of continuum and electron Landau damping in this case. Similar experimental and computational studies are planned for the recent hydrogen and ongoing tritium campaigns, in preparation for the upcoming DT campaign.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

Validation of realistic Monte Carlo plasma gamma-ray source on JET discharges

A novel modelling methodology has been developed for the creation of a realistic plasma gamma-ray source for Monte Carlo transport simulations in the tokamak JET. The methodology couples the TRANSP code for plasma transport calculations with the MCNP Monte Carlo particle transport code, thus connecting plasma physics with gamma-ray transport. Here, we present the validation of the developed source methodology by comparing calculated gamma-ray spectra with measurements performed at JET. The validation focuses on gamma-ray spectra measured by the tangential gamma-ray spectrometer during two JET three ion RF scenario discharges, performed in the JET 2019 deuterium experimental campaign. For validation the calculated plasma gamma-ray spectrum was combined with the neutron induced prompt gamma-ray background, originating in the vacuum vessel, and scaled to absolute values calculating the total number of plasma gamma-ray and neutron emitting reactions. The comparison between calculated and measured gamma-ray spectra shows good agreement with the shape of the calculated gamma-ray spectra matching that of measurements for both studied discharges. Moreover, the calculated absolute values of the gamma-ray spectra were of the same order of magnitude at the position of the gamma-ray detector located at the end of a long line-of-sight in a biological shield. Finally, the comparison has validated the developed plasma gamma-ray source methodology for MCNP photon transport calculations at JET. The validation provides a basis for the developed plasma gamma-ray source to be used as a support for the development of future tokamaks such as DEMO.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2021

Experimental validation of an integrated modelling approach to neutron emission studies at JET

An integrated modelling methodology for the calculation of realistic plasma neutron sources for the JET tokamak has been developed. The computational chain comprises TRANSP plasma transport and DRESS neutron spectrum calculations, and their coupling to the MCNP neutron transport code, bridging plasma physics and neutronics. Here, we apply the developed methodology to the analysis of neutron emission properties of deuterium and helium plasmas at JET, and validate individual modelling steps against neutron diagnostic measurements. Two types of JET discharges are modelled—baseline-like and three-ion radio-frequency scenarios—due to their diversity in plasma heating, characteristics of the induced fast ion population, and the imprint of these on neutron emission properties. The neutron emission modelling results are quantitatively compared to the total neutron yield from fission chambers, neutron emissivity profiles from the neutron camera, neutron spectra from the time-of-flight spectrometer, and neutron activation measurements. The agreement between measured and calculated quantities is found to be satisfactory for all four diagnostic systems within the estimated experimental and computational uncertainties. Additionally, the effect of neutrons not originating from the dominating D(D, n) 3 He reactions is studied through modelling of triton burnup DT neutrons, and, in mixed D- 3 He plasmas, neutrons produced in the 9 Be(D, nγ) 10 B reaction on impurities. It is found that these reactions can contribute up to several percent to the total neutron yield and dominate the neutron activation of samples. Finally, the effect of MeV-range fast ions on the neutron activation of 115 In and 27 Al samples is measured and computationally validated.

integrated modelling↗