Engineering topics

Keiser, B. E.

Publications and source records attributed to Keiser, B. E..

3 records

NASA NTRS1975

ATS-6 spacecraft surface treatment for the control of electrical discharges

The ATS-6 has been subject to potential charges as high as 11,000 volts based on onboard measurements. Thus, special measures were required to protect the spacecraft surface areas, - primarily the Earth Viewing Module, the reflector support truss, and the solar array boom that were specially processed for thermal control - from electrical discharges whose accompanying fields could destroy sensitive receiving circuits. The paper describes thermal blanket grounding criteria and techniques applied to prevent undesired discharge effects, and discusses the disturbance rate from static discharge in orbit.

Keiser, B. E.↗

NASA NTRS1974

ATS-F spacecraft - An EMC challenge

The Applications Technology Satellite F (ATS-F) is the latest of a series of satellites for communications, scientific experiments, and data collection. The physical configuration of the spacecraft is examined along with operational characteristics and EMC management and control. Predicted and encountered problems are discussed, giving attention to wiring pick-up and reradiation, input rectification and bias off-set, intermodulation products, harmonics, component degradation, electroexplosive devices, spacecraft test complex vulnerability, and launch environment testing. Approaches used for locating the problems are considered and a description is given of the key factors and constraints in achieving EMC.

Kampinsky, A.↗

NASA NTRS1974

ATS 6 EMI field measurements techniques and results

At the present time 'Applications Technology Satellite (ATS)-6' is the world's largest communication satellite. It handles telecommunications in the frequency range of 40 - 30,000 MHz. Power levels on board the spacecraft range from -110 dBm to 52.5 dBw. Consequently considerable care was required in the design and test of this spacecraft, in order to provide assurances that the spacecraft would perform properly in its own RF environments. The testing was performed first by placing the earth viewing module (EVM) in a specially constructed 'small' anechoic chamber with an overhead parabolic reflector section, of 8' in diameter, instead of the 30' reflector of the full scale design. The near field analysis of this paper proves that this test configuration leads to a desirable overtest for the spacecraft. The test requirements, procedure and results are also explained.

Afifi, M. S.↗